L1₀ FePtCu bit patterned media

Fabrication of flexible highly ordered porous alumina templates by combined nanosphere lithography and anodization

In this work, we propose a new method for the large-scale production of flexible, periodic alumina arrays with well-ordered pores. We show the incorporation of pre-patterning based on polystyrene (PS) nanosphere lithography into an aluminium anodization process. We prepared ordered monolayers of PS spheres with average diameters of (510 ± 10) nm and (430 ± 10) nm on a large area (1.5 × 1.5 cm²) of the Si substrate. Next, we deposited a 5 μm aluminium layer on arrays of PS nanospheres using the sputtering technique. After the deposition, we covered the aluminium film with a polymer Scotch adhesive tape, and separated it from the silicon substrate by ultrasonic-assisted lift-off. Finally, we performed the anodization of the aluminium. We compared the pore and cell sizes, and the pore distance for the templates obtained by this technique, with reference to the templates prepared by a two-step anodization process. Using this new approach, we obtained highly ordered hexagonal 2D lattices over a large area of up to 2 cm² with sparse defects, amounting to not more than four defects per 1000 μm² on average. Here, we show that the use of indentation techniques is not necessary and can be replaced by a fast, cheap and easy pre-patterning step based on nanosphere lithography.

Ordered FePdCu nanoisland arrays made by templated solid-state dewetting

Ordered FePdCu nanoisland arrays were formed by annealing at 600 °C, which caused solid state dewetting of [Cu/Fe/Pd] multilayers deposited on self-assembled SiO2 nanospheres with a size of 100 nm. A single FePdCu island was formed on the top of each SiO2 nanosphere. The structure of the obtained system was studied by x-ray diffraction (XRD), while its magnetic properties were studied by SQUID magnetometry. A partially ordered L10 alloy appeared in the annealed films, leading to magnetic hardening of the material. The paper presents the influence of the patterning on the system properties. It is shown that templated dewetting is a method providing nanoislands with well-controlled sizes and positions. The role of copper admixture in controlling the structural and magnetic properties is also discussed.

Laser-induced magnetization dynamics and reversal in ferrimagnetic alloys

This review discusses the recent studies of magnetization dynamics and the role of angular momentum in thin films of ferrimagnetic rare-earth-transition metal (RE-TM) alloys, e.g. GdFeCo, where both magnetization and angular momenta are temperature dependent. It has been experimentally demonstrated that the magnetization can be manipulated and even reversed by a single 40 fs laser pulse, without any applied magnetic field. This switching is found to follow a novel reversal pathway, that is shown however to depend crucially on the net angular momentum, reflecting the balance of the two opposite sublattices. In particular, optical excitation of ferrimagnetic GdFeCo on a time scale pertinent to the characteristic time of the exchange interaction between the RE and TM spins, i.e. on the time scale of tens of femtoseconds, pushes the spin dynamics into a yet unexplored regime, where the two exchange-coupled magnetic sublattices demonstrate substantially different dynamics. As a result, the reversal of spins appears to proceed via a novel transient state characterized by a ferromagnetic alignment of the Gd and Fe magnetic moments, despite their ground-state antiferromagnetic coupling.Thus, optical manipulation of magnetic order by femtosecond laser pulses has developed into an exciting and still expanding research field that keeps being fueled by a continuous stream of new and sometimes counterintuitive results. Considering the progress in the development of plasmonic antennas and compact ultrafast lasers, optical control of magnetic order may also potentially revolutionize data storage and information processing technologies.