Transferrable superhydrophobic TiO2 nanorods on reduced graphene oxide films using block copolymer templates

Block Copolymer Nanopatterning for Nonsemiconductor Device Applications

Block copolymer (BCP) nanopatterning has emerged as a versatile nanoscale fabrication tool for semiconductor devices and other applications, because of its ability to organize well-defined, periodic nanostructures with a critical dimension of 5-100 nm. While the most promising application field of BCP nanopatterning has been semiconductor devices, the versatility of BCPs has also led to enormous interest from a broad spectrum of other application areas. In particular, the intrinsically low cost and straightforward processing of BCP nanopatterning have been widely recognized for their large-area parallel formation of dense nanoscale features, which clearly contrasts that of sophisticated processing steps of the typical photolithographic process, including EUV lithography. In this Review, we highlight the recent progress in the field of BCP nanopatterning for various nonsemiconductor applications. Notable examples relying on BCP nanopatterning, including nanocatalysts, sensors, optics, energy devices, membranes, surface modifications and other emerging applications, are summarized. We further discuss the current limitations of BCP nanopatterning and suggest future research directions to open up new potential application fields.

Biomimetic Superhydrophobic Films with an Extremely Low Roll-Off Angle Modified by F16CuPc via Two-Step Fabrication

Superhydrophobicity is the phenomenon of which the water contact angle (WCA) of droplets on a solid surface is greater than 150°. In the present paper, we prepare a superhydrophobic film with a structure similar to the surface of a lotus leaf, which is composed of polydimethylsiloxane (PDMS), zinc oxide (ZnO), a molecular sieve (MS) and 1,2,3,4,8,9,10,11,15,16,17,18,22,23,24,25-hexadecafluorophthalocyanine copper(II) (F₁₆CuPc). The F₁₆CuPc was used as the modifier to reduce the surface energy of the biomimetic micro-nanostructure. With the introduction of F₁₆CuPc, the superhydrophobic properties of the surface were enhanced so that the WCA and water roll-off angle could reach 167.1° and 0.5°, respectively. Scanning electron microscopy, X-ray energy spectrometry, and X-ray photoelectron spectroscopy analyses verified that the enhanced superhydrophobic properties of the film were mainly attributed to the modification of F₁₆CuPc. Finally, thermal, mechanical, and chemical stability studies, as well as the influences of UV and underwater immersion on the superhydrophobic film were investigated. This developed two-step fabrication method may be a potential direction for superhydrophobic surface fabrication due to its simple process, excellent superhydrophobic property, and favorable stability.

Vertically aligned nanostructured TiO2 photoelectrodes for high efficiency perovskite solar cells via a block copolymer template approach

We fabricated perovskite solar cells with enhanced device efficiency based on vertically oriented TiO2 nanostructures using a nanoporous template of block copolymers (BCPs). The dimension and shape controllability of the nanopores of the BCP template allowed for the construction of one-dimensional (1-D) TiO2 nanorods and two-dimensional (2-D) TiO2 nanowalls. The TiO2 nanorod-based perovskite solar cells showed a more efficient charge separation and a lower charge recombination, leading to better performance compared to TiO2 nanowall-based solar cells. The best solar cells employing 1-D TiO2 nanorods showed an efficiency of 15.5% with VOC = 1.02 V, JSC = 20.0 mA cm(-2) and fill factor = 76.1%. Thus, TiO2 nanostructures fabricated from BCP nanotemplates could be applied to the preparation of electron transport layers for improving the efficiency of perovskite solar cells.