Broadband quasi-differential multifrequency electrical impedance imaging system

High precision Multifrequency Electrical Impedance Tomography System and Preliminary imaging results on saline tank

To establish a high precision data acquisition system for multi-frequency electrical impedance tomography (EIT), a series of methods were introduced. Those methods include building a driving signal with up to four frequency components to diminish the effect of the dynamic change of tissues resistivity, extracting the impedance information by a digital demodulator that can improve the SNR by 8 times. The system that established can work at a wide range from 1.6kHz to 380kHz. Its CMRR is 74dB at 100kHz. The output impedance of current source is 2MΩ at that frequency. And measurement precision on a 100ohm resistor is better than -80dB in full bandwidth. Both the quasi-static and the dynamic imaging results based on a saline tank can reflect the resistivity changes inside the phantom clearly. Therefore, the system was competent in multifrequency EIT research work.

Design and preliminary evaluation of a portable device for the measurement of bioimpedance spectroscopy

Portable bioimpedance spectroscopy (BIS) devices are of great value for monitoring the pathological status of biological tissues in clinical and home environments. The two traditional techniques for measuring complex bioimpedance, the bridge method and quadrature demodulation method, are either time-consuming or often associated with high cost, high power consumption, and large board space, and therefore are not ideally suitable for designing a portable device for BIS measurement. This paper describes a novel design of a portable BIS device based on the magnitude-ratio and phase-difference detection method and its implementation using the newest generation of analog electronic products which greatly decrease the complexity of both hardware and software. In order to improve the accuracy of the device, a three-reference calibration algorithm was applied. Experimental sweep-frequency measurements on RC circuits were carried out to preliminarily evaluate the performances of the device. The results obtained by the device were found to be in good agreement with the results measured by a commercial impedance analyzer HP4194, with an overall mean error of 0.014% in magnitude and 0.136 degrees in phase over a frequency range of 20 kHz to 1 MHz.

Propagation of measurement noise through backprojection reconstruction in electrical impedance tomography

A framework to analyze the propagation of measurement noise through backprojection reconstruction algorithms in electrical impedance tomography (EIT) is presented. Two measurement noise sources were considered: noise in the current drivers and in the voltage detectors. The influence of the acquisition system architecture (serial/semi-parallel) is also discussed. Three variants of backprojection reconstruction are studied: basic (unweighted), weighted and exponential backprojection. The results of error propagation theory have been compared with those obtained from simulated and experimental data. This comparison shows that the approach provides a good estimate of the reconstruction error variance. It is argued that the reconstruction error in EIT images obtained via backprojection can be approximately modeled as a spatially nonstationary Gaussian distribution. This methodology allows us to develop a spatial characterization of the reconstruction error in EIT images.

Patient-instrument connection errors in bioelectrical impedance measurement

Bioelectrical impedance in vivo measurement errors due to the connection between instrument and patient are analysed theoretically and experimentally. Special attention is paid to the patient cable capacitances and to the reduction of unwanted common-mode signals at the voltage amplifier input. Experiments with single-ended and symmetrical current sources, with different simulated body impedance values, with five types of cable connection and with three types of cable screen driving are carried out. The use of a balanced voltage-to-current transverter with a floating common point is recommended. Four separate patient cables should be used with separately driven screens by high-quality unity-gain buffers. Thus the impedance module measurement error can be reduced to below 1% in the range of 20 to 1000 omega and the phase measurement error to less than 0.3 degree, for frequencies from 1 kHz to 300 kHz.