Nanowire-based sources of non-classical light

Zincblende InAsxP1-x/InP Quantum Dot Nanowires for Telecom Wavelength Emission

InAsxP1-x quantum dots (QDs) in InP nanowires (NWs) have been realized as a platform for emission at telecom wavelengths. These QDs are typically grown in NWs with the wurtzite crystal phase, but in this case, ultrathin diameters are required to achieve defect-free heterostructures, making the structures less robust. In this work, we demonstrate the growth of pure zincblende InAsxP1-x QDs in InP NWs, which enabled an increase in NW diameters to about 45 nm, achieved by employing Au-assisted vapor liquid solid growth in a chemical beam epitaxy system. We studied the growth of InP/InAsxP1-x heterostructures with different compositions to control the straight growth along the ⟨100⟩ direction and to tune the emission wavelength. Interestingly, we found that the growth mechanism for pure InAs QDs is different compared to that for InAsxP1-x alloy QDs. This allowed us to optimize different growth protocols to achieve straight growth of the final QD NWs. We successfully obtained the growth of InAsxP1-x QDs with a composition in the range of x = 0.24-1.00. By means of microphotoluminescence measurements, we demonstrate the tunability of the emission in dependence of the InAsxP1-x QD composition and morphology, remarkably observing an emission at the telecom O-band for a 10 nm thick QD with 80% of As content.

Self-Consistent Model for the Compositional Profiles in Vapor-Liquid-Solid III-V Nanowire Heterostructures Based on Group V Interchange

Due to the very efficient relaxation of elastic stress on strain-free sidewalls, III-V nanowires offer almost unlimited possibilities for bandgap engineering in nanowire heterostructures by using material combinations that are attainable in epilayers. However, axial nanowire heterostructures grown using the vapor-liquid-solid method often suffer from the reservoir effect in a catalyst droplet. Control over the interfacial abruptness in nanowire heterostructures based on the group V interchange is more difficult than for group-III-based materials, because the low concentrations of highly volatile group V atoms cannot be measured after or during growth. Here, we develop a self-consistent model for calculations of the coordinate-dependent compositional profiles in the solid and liquid phases during the vapor-liquid-solid growth of the axial nanowire heterostructure Ax0B1-x0C/Ax1B1-x1C with any stationary compositions x0 and x1. The only assumption of the model is that the growth rates of both binaries AC and BC are proportional to the concentrations of group V atoms A and B in a catalyst droplet, requiring high enough supersaturations in liquid phase. The model contains a minimum number of parameters and fits quite well the data on the interfacial abruptness across double heterostructures in GaP/GaAsxP1-x/GaP nanowires. It can be used for any axial III-V nanowire heterostructures obtained through the vapor-liquid-solid method. It forms a basis for further developments in modeling the complex growth process and suppression of the interfacial broadening caused by the reservoir effect.

Size control of InP nanowires byin situannealing and its application to the formation of InAsP quantum dots

We carried outin situannealing of InP nanowires (NWs) in a metal-organic vapor phase epitaxial (MOVPE) growth reactor to control and reduce the tip size of InP NWs. InP NWs were grown by selective-area (SA) MOVPE on partially masked (111)A InP substrates, and annealing was successively applied in tertiarybutylphosphine (TBP) ambient. Initially, the InP NWs had a hexagonal cross-section with{112¯}facets vertical to the substrates; they became tapered, and the edges were rounded by annealing. By appropriately selecting the annealing temperature and initial NW diameter, the tip size of the NW was reduced and NWs with a tip size of 20 nm were successfully formed. Subsequently, a thin InAsP layer was grown on the annealed NWs and their photoluminescence was investigated at low temperatures. The characterization results indicated the formation of InAsP quantum dots (QDs) emitting in the telecom band. Our approach is useful for reducing the size of the NWs and for the controlled formation of InAsP QDs embedded in InP NWs in photonic devices compatible with telecom bands.

Time-Resolved Line Shapes of Single Quantum Emitters via Machine Learned Photon Correlations

Solid-state single-photon emitters (SPEs) are quantum light sources that combine atomlike optical properties with solid-state integration and fabrication capabilities. SPEs are hindered by spectral diffusion, where the emitter's surrounding environment induces random energy fluctuations. Timescales of spectral diffusion span nanoseconds to minutes and require probing single emitters to remove ensemble averaging. Photon correlation Fourier spectroscopy (PCFS) can be used to measure time-resolved single emitter line shapes, but is hindered by poor signal-to-noise ratio in the measured correlation functions at early times due to low photon counts. Here, we develop a framework to simulate PCFS correlation functions directly from diffusing spectra that match well with experimental data for single colloidal quantum dots. We use these simulated datasets to train a deep ensemble autoencoder machine learning model that outputs accurate, noiseless, and probabilistic reconstructions of the noisy correlations. Using this model, we obtain reconstructed time-resolved single dot emission line shapes at timescales as low as 10 ns, which are otherwise completely obscured by noise. This enables PCFS to extract optical coherence times on the same timescales as Hong-Ou-Mandel two-photon interference, but with the advantage of providing spectral information in addition to estimates of photon indistinguishability. Our machine learning approach is broadly applicable to different photon correlation spectroscopy techniques and SPE systems, offering an enhanced tool for probing single emitter line shapes on previously inaccessible timescales.

Exploiting flux shadowing for strain and bending engineering in core-shell nanowires

Here we report on the non-uniform shell growth of In_xGa_1-xAs on the GaAs nanowire (NW) core by molecular beam epitaxy (MBE). The growth was realized on pre-patterned silicon substrates with the pitch size (p) ranging from 0.1 μm to 10 μm. Considering the preferable bending direction with respect to the MBE cells as well as the layout of the substrate pattern, we were able to modify the strain distribution along the NW growth axis and the subsequent bending profile. For NW arrays with a high number density, the obtained bending profile of the NWs is composed of straight (barely-strained) and bent (strained) segments with different lengths which depend on the pitch size. A precise control of the bent and straight NW segment length provides a method to design NW based devices with length selective strain distribution.

Unity yield of deterministically positioned quantum dot single photon sources

We report on a platform for the production of single photon devices with a fabrication yield of 100%. The sources are based on InAsP quantum dots embedded within position-controlled bottom-up InP nanowires. Using optimized growth conditions, we produce large arrays of structures having highly uniform geometries. Collection efficiencies are as high as 83% and multiphoton emission probabilities as low as 0.6% with the distribution away from optimal values associated with the excitation of other charge complexes and re-excitation processes, respectively, inherent to the above-band excitation employed. Importantly, emission peak lineshapes have Lorentzian profiles indicating that linewidths are not limited by inhomogeneous broadening but rather pure dephasing, likely elastic carrier-phonon scattering due to a high phonon occupation. This work establishes nanowire-based devices as a viable route for the scalable fabrication of efficient single photon sources and provides a valuable resource for hybrid on-chip platforms currently being developed.

Magnetic tuning of tunnel coupling between InAsP double quantum dots in InP nanowires

We study experimentally and theoretically the in-plane magnetic field dependence of the coupling between dots forming a vertically stacked double dot molecule. The InAsP molecule is grown epitaxially in an InP nanowire and interrogated optically at millikelvin temperatures. The strength of interdot tunneling, leading to the formation of the bonding-antibonding pair of molecular orbitals, is investigated by adjusting the sample geometry. For specific geometries, we show that the interdot coupling can be controlled in-situ using a magnetic field-mediated redistribution of interdot coupling strengths. This is an important milestone in the development of qubits required in future quantum information technologies.

Optical fibre-based single photon source using InAsP quantum dot nanowires and gradient-index lens collection

We present a compact, fibre-coupled single photon source using gradient-index (GRIN) lenses and an InAsP semiconductor quantum dot embedded within an InP photonic nanowire waveguide. A GRIN lens assembly is used to collect photons close to the tip of the nanowire, coupling the light immediately into a single mode optical fibre. The system provides a stable, high brightness source of fibre-coupled single photons. Using pulsed excitation, we demonstrate on-demand operation with a single photon purity of 98.5% when exciting at saturation in a device with a source-fibre collection efficiency of 35% and an overall single photon collection efficiency of 10%. We also demonstrate "plug and play" operation using room temperature photoluminescence from the InP nanowire for room temperature alignment.

Point Defects in Two-Dimensional Indium Selenide as Tunable Single-Photon Sources

In the past few years remarkable interest has been kindled by the development of nonclassical light sources and, in particular, of single-photon emitters (SPE), which represent fundamental building blocks for optical quantum technology. In this Letter, we analyze the stability and electronic properties of an InSe monolayer with point defects with the aim of demonstrating its applicability as an SPE. The presence of deep defect states within the InSe band gap is verified when considering substitutional defects with atoms belonging to group IV, V, and VI. In particular, the optical properties of Ge as substitution impurity of Se predicted by solving the Bethe-Salpeter equation on top of the GW corrected electronic states show that transitions between the valence band maximum and the defect state are responsible for the absorption and spontaneous emission processes, so that the latter results in a strongly peaked spectrum in the near-infrared. These properties, together with a high localization of the involved electronic states, appear encouraging in the quest for novel SPE materials.

Defect-Free Axially Stacked GaAs/GaAsP Nanowire Quantum Dots with Strong Carrier Confinement

Axially stacked quantum dots (QDs) in nanowires (NWs) have important applications in nanoscale quantum devices and lasers. However, there is lack of study of defect-free growth and structure optimization using the Au-free growth mode. We report a detailed study of self-catalyzed GaAsP NWs containing defect-free axial GaAs QDs (NWQDs). Sharp interfaces (1.8-3.6 nm) allow closely stack QDs with very similar structural properties. High structural quality is maintained when up to 50 GaAs QDs are placed in a single NW. The QDs maintain an emission line width of <10 meV at 140 K (comparable to the best III-V QDs, including nitrides) after having been stored in an ambient atmosphere for over 6 months and exhibit deep carrier confinement (∼90 meV) and the largest reported exciton-biexciton splitting (∼11 meV) for non-nitride III-V NWQDs. Our study provides a solid foundation to build high-performance axially stacked NWQD devices that are compatible with CMOS technologies.

Tailoring the Geometry of Bottom-Up Nanowires: Application to High Efficiency Single Photon Sources

For nanowire-based sources of non-classical light, the rate at which photons are generated and the ability to efficiently collect them are determined by the nanowire geometry. Using selective-area vapour-liquid-solid epitaxy, we show how it is possible to control the nanowire geometry and tailor it to optimise device performance. High efficiency single photon generation with negligible multi-photon emission is demonstrated using a quantum dot embedded in a nanowire having a geometry tailored to optimise both collection efficiency and emission rate.

Demonstration of InP/InAsP/InP axial heterostructure nanowire array vertical LEDs

Semiconductor nanowires (NWs), which have nanoscale footprints, enable us to realize various quantum structures with excellent position and size controllability, utilizing a wide range of materials for heterostructures. In addition, enhancing light extraction and controlling spontaneous emission by modifying their size and shape are possible. Thus, NWs are promising materials for nanoscale light sources applicable from visible to telecommunication bands. In this study, we grew InP/InAsP/InP axial heterostructure NWs, where the InAsP layer was embedded to serve as an active layer, by selective-area growth and demonstrated vertical NW array light-emitting diodes (LEDs) as a step towards realizing on-demand single photon sources. The NW array LEDs showed rectifying characteristics and electroluminescence originating from the embedded InAsP layer in the near-infrared region.