One-pot synthesized Bi2Te3/graphene for a self-powered photoelectrochemical-type photodetector

Structural phase transition driven dielectric and optical properties with reduction in band gap in Sr2+modified BaTiO3ceramics

Ferroelectric materials with crystal symmetry transition from single phase to multiphase coexistence exhibit anomalous photosensitive properties. The optical properties (optical band gap and photosensitive) found on non-centrosymmetric and centrosymmetric systems achieved research interest because of their interesting behavior. In this regard, the lead-free polycrystalline Ba1-xSrxTiO3(BSTO, 0⩽x⩽0.3) has been synthesized to explore its crystal structure, dielectric, light absorption, and photocurrent sensing properties for various applications. Both experimental and theoretical studies on BSTO (0⩽x⩽0.3) ceramics confirm the crystal symmetry transition with the reduction of band gap as compared to pristine BaTiO3. This crystal symmetry transition plays an important role in varying the various physical properties as it involves the transition from the polar phase to the non-polar phase. The optical band gap has been estimated experimentally by the Tauc plot method and found that there is a small variation of energy band gap from 3.615 eV to 3.212 eV with Sr substitution. The highest dielectric constant was found to be 5327 at lower frequency on Ba0.76Sr0.24TiO3after that for further increase in Sr concentration the dielectric constant decreases because of the introduction of the non-polar phase. A strong correlation between crystal structure and physical properties (dielectric, optical, etc.) has been observed. The photocurrent of the samples is significant which reveals that the sample is influenced by the photons. In a nutshell, the present study deepens the understanding of the correlation between crystal structure and various physical properties of BSTO and, hence provides an idea of required design parameters to construct a ferroelectric system for better photosensitive nature suitable for device applications.

Recent Progress on Graphene Flexible Photodetectors

In recent years, optoelectronics and related industries have developed rapidly. As typical optoelectronics devices, photodetectors (PDs) are widely applied in various fields. The functional materials in traditional PDs exhibit high hardness, and the performance of these rigid detectors is thus greatly reduced upon their stretching or bending. Therefore, the development of new flexible PDs with bendable and foldable functions is of great significance and has much interest in wearable, implantable optoelectronic devices. Graphene with excellent electrical and optical performance constructed on various flexible and rigid substrates has great potential in PDs. In this review, recent research progress on graphene-based flexible PDs is outlined. The research states of graphene conductive films are summarized, focusing on PDs based on single-component graphene and mixed-structure graphene, with a systematic analysis of their optical and mechanical performance, and the techniques for optimizing the PDs are also discussed. Finally, a summary of the current applications of graphene flexible PDs and perspectives is provided, and the remaining challenges are discussed.

In Situ Synthesis of a Bi2Te3-Nanosheet/Reduced-Graphene-Oxide Nanocomposite for Non-Enzymatic Electrochemical Dopamine Sensing

Dopamine is a neurotransmitter that helps cells to transmit pulsed chemicals. Therefore, dopamine detection is crucial from the viewpoint of human health. Dopamine determination is typically achieved via chromatography, fluorescence, electrochemiluminescence, colorimetry, and enzyme-linked methods. However, most of these methods employ specific biological enzymes or involve complex detection processes. Therefore, non-enzymatic electrochemical sensors are attracting attention owing to their high sensitivity, speed, and simplicity. In this study, a simple one-step fabrication of a Bi₂Te₃-nanosheet/reduced-graphene-oxide (BT/rGO) nanocomposite was achieved using a hydrothermal method to modify electrodes for electrochemical dopamine detection. The combination of the BT nanosheets with the rGO surface was investigated by X-ray diffraction, X-ray photoelectron spectroscopy, field-emission scanning electron microscopy, transmission electron microscopy, Raman spectroscopy, and Fourier-transform infrared spectroscopy. Electrochemical impedance spectroscopy, cyclic voltammetry, and differential pulse voltammetry were performed to analyze the electrochemical-dopamine-detection characteristics of the BT/rGO nanocomposite. The BT/rGO-modified electrode exhibited higher catalytic activity for electrocatalytic oxidation of 100 µM dopamine (94.91 µA, 0.24 V) than that of the BT-modified (4.55 µA, 0.26 V), rGO-modified (13.24 µA, 0.23 V), and bare glassy carbon electrode (2.86 µA, 0.35 V); this was attributed to the synergistic effect of the electron transfer promoted by the highly conductive rGO and the large specific surface area/high charge-carrier mobility of the two-dimensional BT nanosheets. The BT/rGO-modified electrode showed a detection limit of 0.06 µM for dopamine in a linear range of 10–1000 µM. Additionally, it exhibited satisfactory reproducibility, stability, selectivity, and acceptable recovery in real samples.

Morphology evolution and enhanced broadband photoresponse behavior of two-dimensional Bi2Te3nanosheets

Bismuth telluride (Bi₂Te₃), as an emerging two-dimensional (2D) material, has attracted extensive attention from scientific researchers due to its excellent optoelectronic, thermoelectric properties and topological structure. However, the application research of Bi₂Te₃mainly focuses on thermoelectric devices, while the research on optoelectronic devices is scarce. In this work, the morphology evolution and growth mechanism of 2D Bi₂Te₃nanosheets with a thickness of 12 ± 3 nm were systematically studied by solvothermal method. Then, the Bi₂Te₃nanosheets were annealed at 350 °C for 1 h and applied to self-powered photoelectrochemical-type broadband photodetectors. Compared with the as-synthesized Bi₂Te₃photodetector, the photocurrent of the photodetector based on the annealed Bi₂Te₃is significantly enhanced, especially enhanced by 18.3 times under near-infrared light illumination. Furthermore, the performance of annealed Bi₂Te₃photodetector was systematically studied. The research results show that the photodetector not only has a broadband response from ultraviolet to near-infrared (365-850 nm) under zero bias voltage, but also obtains the highest responsivity of 6.6 mA W^-1under green light with an incident power of 10 mW cm^-2. The corresponding rise time and decay time are 17 ms and 20 ms, respectively. These findings indicate that annealed Bi₂Te₃nanosheets have great potential to be used as self-powered high-speed broadband photodetectors with high responsivity.

Liquid-Exfoliated 2D Materials for Optoelectronic Applications

Two-dimensional (2D) materials have attracted tremendous research attention in recent days due to their extraordinary and unique properties upon exfoliation from the bulk form, which are useful for many applications such as electronics, optoelectronics, catalysis, etc. Liquid exfoliation method of 2D materials offers a facile and low-cost route to produce large quantities of mono- and few-layer 2D nanosheets in a commercially viable way. Optoelectronic devices such as photodetectors fabricated from percolating networks of liquid-exfoliated 2D materials offer advantages compared to conventional devices, including low cost, less complicated process, and higher flexibility, making them more suitable for the next generation wearable devices. This review summarizes the recent progress on metal-semiconductor-metal (MSM) photodetectors fabricated from percolating network of 2D nanosheets obtained from liquid exfoliation methods. In addition, hybrids and mixtures with other photosensitive materials, such as quantum dots, nanowires, nanorods, etc. are also discussed. First, the various methods of liquid exfoliation of 2D materials, size selection methods, and photodetection mechanisms that are responsible for light detection in networks of 2D nanosheets are briefly reviewed. At the end, some potential strategies to further improve the performance the devices are proposed.

Liquid-Phase Exfoliated GeSe Nanoflakes for Photoelectrochemical-Type Photodetectors and Photoelectrochemical Water Splitting

Photoelectrochemical (PEC) systems represent powerful tools to convert electromagnetic radiation into chemical fuels and electricity. In this context, two-dimensional (2D) materials are attracting enormous interest as potential advanced photo(electro)catalysts and, recently, 2D group-IVA metal monochalcogenides have been theoretically predicted to be water splitting photocatalysts. In this work, we use density functional theory calculations to theoretically investigate the photocatalytic activity of single-/few-layer GeSe nanoflakes for both the hydrogen evolution reaction (HER) and the oxygen evolution reaction (OER) in pH conditions ranging from 0 to 14. Our simulations show that GeSe nanoflakes with different thickness can be mixed in the form of nanoporous films to act as nanoscale tandem systems, in which the flakes, depending on their thickness, can operate as HER- and/or OER photocatalysts. On the basis of theoretical predictions, we report the first experimental characterization of the photo(electro)catalytic activity of single-/few-layer GeSe flakes in different aqueous media, ranging from acidic to alkaline solutions: 0.5 M H2SO4 (pH 0.3), 1 M KCl (pH 6.5), and 1 M KOH (pH 14). The films of the GeSe nanoflakes are fabricated by spray coating GeSe nanoflakes dispersion in 2-propanol obtained through liquid-phase exfoliation of synthesized orthorhombic (Pnma) GeSe bulk crystals. The PEC properties of the GeSe nanoflakes are used to design PEC-type photodetectors, reaching a responsivity of up to 0.32 AW-1 (external quantum efficiency of 86.3%) under 455 nm excitation wavelength in acidic electrolyte. The obtained performances are superior to those of several self-powered and low-voltage solution-processed photodetectors, approaching that of self-powered commercial UV-Vis photodetectors. The obtained results inspire the use of 2D GeSe in proof-of-concept water photoelectrolysis cells.