Titania-based nanoheterostructured microspheres for prolonged visible-light-driven photocatalysis

The effect of TiO2 nanoparticles on bacterial growth: the effect of particle size and their structure - a systematic review

One of the widely used microbiological methods to determine the toxicity of chemicals, catalysts, and other types of materials is the minimum inhibitory concentration (MIC) test. The present study aims to investigate the influence of composition of composite materials based on TiO2 and their particle size as well as bacterial type and shape based on the MIC values reported in the literature. The results show that among the 36 articles selected, most of the studies used Escherichia coli (E. coli) (26) and Staphylococcus aureus (S. aureus) (19) bacteria to determine MIC values. This study revealed that the MIC in values below 70 µg ml-1 for S. aureus was lower than that for E. coli bacteria (below 200 µg ml-1). Importantly, MIC value decreased from 60.6 to 7.66 µg ml-1 with decrease in the size of nanoparticles. It follows from the increased surface area for smaller-sized particles, thus increased interaction with bacteria during MIC test.

Preparation of multilayer strontium-doped TiO2/CDs with enhanced photocatalytic efficiency for enrofloxacin removal

Multilayer strontium-doped TiO₂/carbon dots (CDs) materials (TC) were produced via sol-gel-layered carbonization method. A thorough analysis of the fabricated composites via XRD, SEM, and XPS revealed that strontium ions, TiO₂ and CDs, were combined with each other to form layered structures. According to the UV-Vis diffuse reflectance spectrograms and (αhv)^1/2 vs. hv plots, the electron-donor property of strontium ions caused a more positive TC conduction band position than that in the pure TiO₂, thereby increasing the visible-light absorption range of TC. Based on the photocatalytic degradation data, the degradation rate of enrofloxacin was 84.7% at the dosage of 0.05 g·L^-1 and the concentration of 10 mg·L^-1. The capture experiments and ESR results showed that ·O₂^- and e^- played a major role in the degradation process of TC. The possible degradation mechanism of enrofloxacin was explained in terms of decarboxylation and defluorination, as was detected via ultra-performance liquid chromatography-mass spectrometry (UPLC-MS) analysis.

Anodic TiO2nanotube arrays for photocatalytic CO2conversion: comparative photocatalysis and EPR study

Titania (TiO₂) is a widely used semiconductor for the photocatalytic decomposition of organic impurities in air, water and the conversion of CO₂into hydrocarbon fuel precursors. TiO₂in the form of nanotubes arrays is the most attractive for practical use because of the morphological advantages providing more favorable diffusion of photocatalytic reaction products and a low recombination rate of photogenerated electrons and holes. We have carried out a comparative study of the photocatalytic activity of gas-phase conversion of CO₂to hydrocarbon products and the defect properties of multi-walled and single-walled arrays of TiO₂nanotubes. Methanol and methane have been detected in the CO₂photoreduction process. The photocatalytic evolution rate of multi-walled TiO₂nanotubes is twice as fast for methane as for single-walled TiO₂nanotubes after four hours of irradiation and four times faster for methanol. The type and features of the structural defects have been investigated by EPR spectroscopy. For the first time, it has been shown that Ti³⁺/oxygen vacancy centers are mainly located inside the outer layer of nanotubes, while carbon dangling bonds have been observed directly on the surface of the inner layer. Carbon defects have been found to be the centers of adsorption and accumulation of photoinduced charge carriers. The results are entirely new; they clarify the role of different types of defects in the photocatalytic conversion of CO₂to hydrocarbon compounds and show good prospects for applying TiO₂nanotube arrays.