Detection of lead in bone phantoms and arsenic in soft tissue phantoms using synchrotron radiation and a portable x-ray fluorescence system

Assessment of alternative methods for analyzing X-ray fluorescence spectra

When analyzing characteristic peaks in X-ray fluorescence (XRF) spectra, the peak area is the value most often used to quantify peak size. However, some studies have reported the amplitude of the peak instead of the area. When the width of the peak is allowed to vary from trial to trial in order to provide the best possible fit to the data, these two alternative methods can yield slightly different results. In the current study, these two approaches to peak analysis are compared for data obtained from bone reference materials having certified lead concentrations of 1.09 ± 0.03 μg/g, 16.1 ± 0.3 μg/g, 13.2 ± 0.3 μg/g, and 31.5 ± 0.7 μg/g. Measurements were made with an Olympus Innov-X Delta Premium portable XRF system. Using both the area and amplitude methods, lines of best fit were constructed for the lead Lα and lead Lβ signals as a function of lead concentration. Additionally, coefficients of variation were calculated for each reference material and condition of analysis. To assess possible variations over time, the procedure was performed at two points separated by about one year. The amplitude and area methods were found to produce results which were consistent and proportional. Using either method, lead XRF signal plotted as a function of known lead concentration produced adjusted r² values of ∼0.99. The amplitude method provided slightly higher adjusted r² values overall. Coefficients of variation were generally very similar between the two methods, although more pronounced differences emerged from measurements of the lowest concentration reference material.

Feasibility of measuring zinc in human nails using portable x-ray fluorescence

A variety of adverse health effects have been identified as resulting from zinc deficiency. Zinc supplementation may therefore be indicated for certain individuals or populations. A rapid and straightforward means of assessing zinc status in humans would be of considerable medical benefit. In this study, the feasibility of measuring zinc levels in human fingernails or toenails using a portable x-ray fluorescence technique was assessed. Whole nail models (or phantoms) were constructed from resin, and dosed with various concentrations of zinc. These different concentration "nails" were cut into small slices of 4.4 ± 0.2 mm width. The combination of these various slices into different arrangements allowed the modeling of different time-dependent zinc exposure scenarios. A portable x-ray fluorescence device was tested using an "open beam" configuration having a beam diameter of ∼9 mm, and using a "weld mask" configuration with the beam width reduced to 2.9 mm. Minimum detection limits were determined to be 0.15 ± 0.01 ppm for the open beam, and 1.13 ± 0.08 ppm when using the weld mask. By scanning across the length of the model nails, it was demonstrated that differences in zinc levels deposited over time could be detected, and that the weld mask configuration was better suited to resolving spatial changes. The x-ray fluorescence approach was found to be highly sensitive for detecting zinc in nail, and capable of differentiating patterns of zinc uptake over time.