Dissolution of artificial (natural) stones in a standard model: first results

The Use of Chemical Treatments for Improved Comminution of Artificial Stones

PURPOSE

The acoustic and mechanical properties of various stone compositions are significantly different and thus result in varying degrees of fragility. Consequently, results to shock wave lithotripsy (SWL) are influenced accordingly. We report the results of a study of fragility of various stone compositions, and the influence on each stone's baseline physical properties and fragility when exposed to various chemolytic solutions.

MATERIALS AND METHODS

Before SWL artificial stones of differing compositions were irrigated with various chemolytic solutions. Calcium oxalate monohydrate (COM) stones were treated with ethylenediaminetetraacetic acid (EDTA), stones composed of magnesium ammonium phosphate hydrogen were treated with hemiacidrin, and stones made of uric acid (UA) were treated with tromethamine. Synthetic urine served as a control for all stone groups. Using an ultrasound transmission technique, longitudinal wave propagation speed was measured in all groups of artificial stones. Stone density was also measured by using a pycnometer (based on Archimedes' principle). Based on these measurements transverse (shear) wave speed (assuming a constant Poisson's ratio), wave impedance and dynamic mechanical properties of the artificial stones were calculated. Moreover, the microhardness of these artificial stones was measured, and fragility testing using SWL with and without pretreatment with the previously mentioned chemolytic solutions, was performed.

RESULTS

Wave speed, wave impedance, dynamic mechanical properties and microhardness of EDTA treated COM stones and tromethamine treated UA stones were found to decrease compared to untreated (synthetic urine) control groups. The suggestion that chemolytic pretreatment increases stone fragility was verified by the finding of increased stone comminution after SWL testing. Combining this medical pretreatment and SWL, the findings demonstrate a significant impact of various solvents on stone comminution, in particular EDTA treated COM stones, tromethamine treated UA stones and hemiacidrin treated magnesium ammonium phosphate hydrogen stones. These data suggest that by altering the chemical environment of the fluid surrounding the stones it is possible to increase the fragility of renal calculi in vitro.

CONCLUSIONS

These results indicate that appropriate chemical treatments may provide a useful adjunctive modality for improving the efficacy of stone comminution during shock wave lithotripsy.

A new type of artificial urinary calculi: in vitro study by spiral CT

RATIONALE AND OBJECTIVES

Artificial urinary calculi similar to natural stones have long been sought in urologic research. In an experimental study, the authors assessed the CT characteristics of a new type of artificially produced urinary calculus [BON(N)-STONE].

METHODS

Six different types of urinary calculi (uric acid, struvite, cystine, calcium oxalate, brushite, and apatite) were produced by a coating technique in which several layers of a suspension of pure substance were applied around a core and dried. A total of 60 stones (10 per group) were studied by spiral CT at two energy levels (100 and 120 kV, 250 mA) with 1-mm slice thickness.

RESULTS

All calculi showed a small hyperdense core surrounded by a homogeneous matrix and a slightly hyperdense outer rim. From the least to the most dense, the stone types were uric acid, struvite, cystine, calcium oxalate, brushite, and apatite. Absolute CT values at 100 and 120 kV could differentiate between all groups of stones at a significance level of P < 0.001 or better. Attenuation values were in a comparable range to reported values for natural stones, with the exception of uric acid and struvite, which were notably lower.

CONCLUSION

These artificially produced urinary calculi showed properties similar to those of natural stones. Thus, this seems to be a promising stone model for further investigations.

Chemolysis of artificial cystine stones (BON(N)-STONES) in vitro using a new dissolution device: first results

BACKGROUND AND PURPOSE

The treatment of cystine stones is a clinical problem. This in vitro study was performed to establish an experimental system that enables standardized and reproducible investigations on chemolysis of cystine stones to look for an improvement of dissolution strategies.

MATERIALS AND METHODS

Artificial spherical stones made of cystine (BON(N)-STONES) with a diameter of 0.9 cm were used. A new dissolution device was developed simulating the physiological conditions in the upper urinary tract with computer-assisted online measurement of data. For chemolysis of artificial cystine stones, different solvents (artificial urine, physiologic sodium chloride solution, 2 % acetylcysteine, 8.4 % sodium bicarbonate solution, THAM, and combinations) were used.

RESULTS

Chemolysis is an effective tool in the management of cystine stone disease. Statistical analysis showed significant differences (p < or = 0.05) for all solutions compared with artificial urine alone. A combination of THAM at pH 10 with acetylcysteine (2%) showed a 48-fold stronger ability to dissolve cystine calculi than did artificial urine.

CONCLUSION

By performing standardized in vitro investigations, new basics to improve the dissolution of cystine stones have been developed. It is recommended to use artificial stones made of cystine and a dissolution device simulating physiological conditions for investigations on chemolysis in the future.

Improving cystine stone therapy: an in vitro study of dissolution

OBJECTIVES

To perform an in vitro study analyzing the possibilities in therapeutic strategies for an effective treatment of cystine stones.

METHODS

Artificial stones made of cystine [Bon(n)-Stones] with a ball-shaped size of 0.9 cm in diameter were used. Chemolysis of artificial cystine stones with different solvents (artificial urine, physiologic sodium chloride solution, acetylcysteine, tris-(hydroxymethylene)-aminomethane [THAM], and combinations of these) was investigated. An experimental arrangement with computer-assisted online measurement of data simulating the physiologic conditions in the upper urinary tract at varying pH values was used.

RESULTS

All solutions showed a statistical improvement in the solubility of cystine stones compared with artificial urine and physiologic sodium chloride solution. The combination of THAM (pH 10) and 2% acetylcysteine was most effective (1 3.91 +/- 1.73 mg/hr) and demonstrated a 41 -fold higher ability to dissolve cystine calculi compared with artificial urine.

CONCLUSIONS

Our data indicate that local chemolysis with special solutions is an effective treatment modality in cystine stone therapy.

Experimental utilization of the holmium laser in a model of ureteroscopic lithotripsy: energy analysis

BACKGROUND AND OBJECTIVE

Medical lasers have rapidly expanded in both indications and utilization. We have developed a simple model for the investigation of various modalities of lithotripsy using readily available silicate stones of uniform mass.

MATERIALS AND METHODS

The holmium:YAG VersaPulse Select (Coherent, Palo Alto, CA) was used in these experiments to define the relation between fiber diameter and efficacy of stone fragmentation. For each fiber, lithotripsy was performed in an incremental fashion at 0.6, 0.8, and 1.0 J at a frequency of 10, 16, and 20 pulses per second at each energy level.

RESULTS

Total kilojoules did not differ between any fibers investigated, supporting the consistency of our methodology. The power density of the holmium laser energy, as expressed as total kJ/area, decreases in proportion to increasing fiber diameter. We expected an increase in fragmentation success as fiber diameter decreased (at equal energy output). However, peak lithotripsy occurred with the 365- and 550-microm fibers, whereas neither the 200- nor the 1000-microm fibers was effective.

CONCLUSION

This model utilizing a silicate stone phantom supports our clinical observation that the 365-microm fiber (and additionally the 550-microm fiber) provides the best method for efficient intracorporeal lithotripsy.