Evaluation of Mechanical Properties of Glass Fiber Posts Subjected to Laser Surface Treatments

Is the Er:YAG laser affect the surface characteristics and bond strength of Y-TZP?

This study evaluated the surface characteristics and bond strength of Y-TZP treated with Er:YAG laser at different focal distances. 120 Y-TZP blocks were divided into five groups (n=24), according to the surface treatment: no treatment (C-); sandblasting with silica-coated aluminum oxide particles (C+); and Er:YAG laser application at focal distances of 1mm (Er:YAG-1), 4mm (Er:YAG-4), and 7mm (Er:YAG-7). Surface characteristics were analyzed using Vickers microhardness, confocal laser microscope, scanning electron microscopy (SEM), and X-ray diffractometer (XRD). For the bond strength test, 100 Y-TZP blocks were subdivided into two subgroups (n=10), according to the resin cement used: with (MDP+) or without 10-methacryloyloxydecyl dihydrogen phosphate (MDP-). The Vickers microhardness and surface roughness were analyzed by one-way ANOVA and bond strength by two-way ANOVA and Tukey's test for both (α=0.05). Vickers microhardness differences were not observed between the groups (p>0.05); C+ showed higher surface roughness values. SEM images showed micromorphological differences between the groups. The XRD data detected tetragonal crystals for C- and, for the other groups, tetragonal and monoclinic peaks. For bond strength, no statistically difference significance were observed among the cements with or without MDP (p>0.05) but showed significant difference between the surface treatments (C+ > C- = Er:YAG1 > Er:YAG4 = Er:YAG7) (p<0.05). Suggested that the Er:YAG laser cannot replace conventional treatment with aluminum oxide particles and the presence of MDP in the resin cement had no influence on the bond strength.

Mechanical properties of glass-fibre-reinforced composite posts after laser irradiation with different energy densities

The aim of the present study was to evaluate the effect of the surface treatments on flexural strengths and flexural modulus of glass-fibre-reinforced composite (GFRC) posts. Sixty-three posts were randomly divided into 9 groups (n = 7), and various surface treatments were performed. The control group was left untreated. Other groups were treated with 9% hydrofluoric acid, sandblasting with 120 µm Al₂ O₃ particles and Er,Cr:YSGG laser irradiation with different powers (1 W, 2 W, 3 W, 4 W, 5 W and 6 W). The samples were subjected to 3-point bending test, and data were calculated. Statistical analysis was performed. The flexural strengths of fibre posts treated with sandblasting, hydrofluoric acid, 1 W and 2 W laser were statistically similar with control group (P > 0.01). However, the flexural strength of fibre posts treated with 3 W, 4 W, 5 W and 6 W laser was statistically lower than control group (P < 0.01). High laser irradiations cause melting on the post surface and breaks in fibrils.