Development of Capillary Zone Electrophoresis Method for the Simultaneous Separation and Quantification of Metformin and Pioglitazone in Dosage Forms; and Comparison with HPLC Method

A capillary zone electrophoretic (CZE) method was developed, validated, and applied for the assay of metformin (MET) and pioglitazone (PIO) in pharmaceutical formulations. The optimum running buffer composition was found to be 75 mmol/L phosphate buffer containing 30% acetonitrile (ACN) at pH 4.0. The optimum instrumental conditions were found to be injection time, 10 s; applied voltage, 25 kV; hydrodynamic injection pressure, 0.5 psi for 10 s, capillary temperature, 25 °C; and the detection wavelength, 210 nm. The quantifications were calculated based on the ratio of the peak areas of analytes to atenolol as an internal standard. The CZE method was validated in terms of accuracy (98.21-104.81%), intra- and inter-day precision of migration time and peak area (relative standard deviation ≤ 5%), linearity (correlation coefficients ≥ 0.9985), limit of detection (≤0.277 μg/mL), and limit of quantitation (≤0.315 μg/mL). The proposed method was applied for the analysis of PIO and MET both individually and in a combined dosage tablet formulation. All electrophoretic parameters were calculated and evaluated. A previously reported high-performance liquid chromatographic (HPLC) method was also applied to the same samples. A comprehensive comparison was then carried out for the analytical features of both methods CZE and HPLC. Comparable results were obtained with the advantage of reagent consumption and separation efficiency of CZE over HPLC and shorter analysis time by HPLC compared with CZE.

Research on Detection of Sterol Doping in Sports by Electrochemical Sensors: A Review

The use of doping by athletes to improve performance is prohibited. Therefore, doping testing is an important step to ensure fairness in sports. Doping is gradually metabolized in the body and is therefore difficult to detect immediately by a common method. At the same time, the emergence of new doping agents poses a challenge for highly sensitive detection. Electrochemical sensors are a fast, highly sensitive, and inexpensive analytical detection technology. It provides qualitative and quantitative determination of analytes by altering the electrochemical signal of the analyte or probe at the electrode. In this min-review, we summarized the different electrochemical sensing strategies for sterol doping detection. Some of the representative papers were interpreted in detail. In addition, we compare different sensing strategies.

Application of supercritical fluid chromatography for separation and quantitation of 15 co-formulated binary anti-hypertensive medications using a single elution protocol

A facile supercritical fluid chromatography method is proposed to analyse 15 co-formulated binary anti-hypertensive drug combinations using a customized elution procedure. The effect of mobile phase composition, column back pressure and temperature was suitably optimized for adequate retention, analyte response and resolution. The chromatographic separation of the different drug combinations was performed on a DCPak poly(4-vinylpyridine) column (250 × 4.6 mm, 5 μm) at 125-bar pressure and 40°C using a photodiode array detector. A linear gradient of CO₂ and 0.1% formic acid in methanol provided the best elution conditions for all drug combinations. Baseline separation of the drugs was possible with resolution factor R_s ranging from 1.42 to 12.58. The method was validated for specificity, sensitivity, accuracy and precision, recovery and robustness. The limit of detection and limit of quantitation for aliskiren, amlodipine, atenolol, candesartan, hydrochlorothiazide, lisinopril, losartan, metoprolol, olmesartan, telmisartan and valsartan were in the range of 0.26-2.56 and 0.77-7.75 μg/mL, respectively. The thermodynamic study revealed that interactions of the drugs with the stationary phase were spontaneous as evident from the negative free energy values, and the separation process was enthalpy driven. The developed method was successfully employed to analyse these drugs in their co-formulated tablet formulations.

Multivariate optimization of capillary electrophoresis methods: a critical review

In this article a review on the recent applications of multivariate techniques for optimization of electromigration methods, is presented. Papers published in the period from August 2007 to February 2013, have been taken into consideration. Upon a brief description of each of the involved CE operative modes, the characteristics of the chemometric strategies (type of design, factors and responses) applied to face a number of analytical challenges, are presented. Finally, a critical discussion, giving some practical advices and pointing out the most common issues involved in multivariate set-up of CE methods, is provided.