Inhalable Excipient-Free Dry Powder of Tigecycline for the Treatment of Pulmonary Infections

Tigecycline (TIG) is a broad-spectrum antibiotic that has been approved for the treatment of a number of complicated infections, including community-acquired bacterial pneumonia. Currently it is available only as an intravenous injection that undergoes rapid chemical degradation and limits the use to in-patient scenarios. The use of TIG as an inhaled dry powder inhaler may offer a promising treatment option for patients with multidrug-resistant respiratory tract infections, such as Stenotrophomonas maltophilia (S. maltophilia). This study explores the feasibility of engineering an inhaled powder formulation of TIG that could administer relevant doses at a wide range of inhalation flow rates while maintaining stability of this labile drug. Using air-jet milling, micronized TIG had excellent aerosolization efficiency, with over 80% of the device emitted dose being within the respirable range. TIG was also readily dispersed using different inhaler devices even when tested at different pressure drops and flow rates. Additionally, micronized TIG was stable for 6 months at 25 °C/60% RH and 40 °C/75% RH. Micronized TIG maintained a low minimum inhibitory concentration (MIC) and minimum biofilm eradication concentration (MBEC) of 0.8 μM and >0.5 μM, respectively in S. maltophilia cultures in vitro. These results strongly suggest that the micronization of TIG results in a stable and respirable formulation that can be delivered via the pulmonary route for the treatment of lung infections.

Concurrent Determination of Tigecycline, Tetracyclines and Their 4-Epimer Derivatives in Chicken Muscle Isolated from a Reversed-Phase Chromatography System Using Tandem Mass Spectrometry

A quantitative and qualitative method using a high-performance liquid chromatography–tandem mass spectrometry (HPLC–MS/MS) detection approach was developed and validated for the analysis of tigecycline, four tetracyclines and their three 4-epimer derivatives in chicken muscle. Samples were extracted repeatedly with 0.1 mol/L Na2EDTA–McIlvaine buffer solution. After vortexing, centrifugation, solid-phase extraction, evaporation and reconstitution, the aliquots were separated using a C8 reversed-phase column (50 mm × 2.1 mm, 5 µm) with a binary solvent system consisting of methanol and 0.01 mol/L trichloroacetic acid aqueous solution. The typical validation parameters were evaluated in accordance with the acceptance criteria detailed in the guidelines of the EU Commission Decision 2002/657/EC and the U.S. Food and Drug Administration Bioanalytical Method Validation 05/24/18. The matrix-matched calibration curve was linear over the concentration range from the limit of quantitation (LOQ) to 400 μg/kg for doxycycline, and the calibration graphs for tetracycline, chlortetracycline, oxytetracycline, their 4-epimer derivatives and tigecycline showed a good linear relationship within the concentration range from the LOQ to 200 μg/kg. The limits of detection (LODs) for the eight targets were in the range of 0.06 to 0.09 μg/kg, and the recoveries from the fortified blank samples were in the range of 89% to 98%. The within-run precision and between-run precision, which were expressed as the relative standard deviations, were less than 5.0% and 6.9%, respectively. The applicability was successfully demonstrated through the determination of residues in 72 commercial chicken samples purchased from different sources. This approach provides a novel option for the detection of residues in animal-derived food safety monitoring.

In situ green analytical methods for the rapid and sensitive determination of a newly launched orphan anticancer drug; Tigecycline in infusion bags: comparative study

Background

Tigecycline (TIG), an antimicrobial agent indicated for complex bacterial infections, is now approved by FDA as an orphan chemotherapeutic agent for the treatment of acute myeloid leukemia due to its inhibitory effects on pathways of activating, signaling and abnormal mitochondrial function in cancer cells. TIG is mainly administered as intravenous infusion through centralized unit of oncology centers. This necessitates the continuous analytical quality control of the prepared solution in order to identify and quantify TIG for safe intravenous administration to patients. Moreover, the clinical staff exposure risk to toxic drugs during daily handling must be considered. Such concerns require a fast, cost-effective and green analytical procedure for sensitive determination of TIG directly in infusion bags. In this work, we propose a simple, rapid and green capillary zone electrophoretic (CZE) method for the sensitive assay of TIG directly in infusion bags, in addition to three simple and green spectrophotometric methods.

Results

TIG solutions corresponding to clinical ranges were detected in 5%glucose. Validation of all the proposed methods was according to ICH guidelines. Greenness assessment was performed depending on Green Analytical Procedure Index (GAPI) and the Eco-scale approach which showed that the proposed methods are better eco-friendly methods than reported ones. It also revealed the superiority of our proposed methods in terms of simplicity and sensitivity for TIG determination in infusion bags. Quantification limits obtained were significantly lower than the administered range of TIG in infusion bags and lower than its maximum serum concentration (Cmax). This promotes the application of the proposed methods for the pharmacokinetics and bioavailability studies of TIG in various biological fluids.

Conclusions

This work reports, for the first time, CZE method for the direct and rapid determination of TIG and its separation from other components in intravenous infusion solution. The developed CZE method has several advantages over current chromatographic methods such as higher efficiency of separation within short analysis time, consumption of fewer quantities of chemicals and offering better resolution than HPLC. Moreover, three green spectrophotometric methods are also proposed for TIG determination that offer many advantages such as accuracy, precision, simplicity, specificity and facility of quantification and separation of the selected drug in infusion bags and pharmaceutical preparations without any techniques for extraction.

Development of a monoclonal antibody-based immunochromatographic strip for the rapid detection of tigecycline in human serum

In this study, a gold labelled immunochromatographic assay was developed to detect tigecycline (TGC) in human serum. For this purpose, an anti-TGC monoclonal antibody, 2G7, was produced and characterized, and was found to have a 50%-inhibitory concentration (IC50) of 2.303 ng mL-1 and a limit of detection (LOD) of 0.215 ng mL-1 for TGC. This strip assay had a visual limit of detection (vLOD) of 50 ng mL-1 and a cut-off value of 1000 ng mL-1 for TGC in human serum, when assessed by eye. With the aid of a strip scan reader, a quantitative determination of TGC was obtained with a calculated limit of detection (cLOD) of 15.03 ng mL-1. Analysis of TGC in human serum indicated that the results of our strip assay compared well with results obtained using ic-ELISA and LC-MS/MS. Therefore, this strip assay represents a sensitive and reliable method for the on-site detection of TGC in serum samples.

Flucloxacillin: A Review of Characteristics, Properties and Analytical Methods

Bacterial resistance is a growing and worrying factor. The high reproducibility of these resistant microorganisms tends to influence the development of new drugs and research related to product quality control. Among the existing antimicrobials, flucloxacillin (FLU) was designed for oral and injectable administration with bactericidal activity. FLU sodium is the form used in pharmaceutical formulations. It is an antimicrobial resistant against penicillinase, an enzyme responsible for cleaving the beta-lactam ring of penicilins, which leads to inactivity of the drug. Qualitative and quantitative analyzes are essential to ensure quality of pharmaceuticals and health of the population. It is important that quality control is effective and appropriate, only then we can win the battle against microbial resistance. In this work, we want to highlight tthe characteristics of FLU as an important antibiotic and methods for the determination of FLU in pharmaceutical products and biological matrices. Among the analytical methods described in the literature for the determination of FLU, high performance liquid chromatography (HPLC) stands out. Anyway, this method uses toxic solvents (e.g. acetonitrile) long columns, which provide long runs, as well as produces large amounts of waste. Currently, the priority changed to develop ecologically correct, conscious and sustainable methods. This new view on analytical methods should be applied to FLU analyzes and used to develop and improve existing methods.

Validation of analytical methodology for quantification of cefazolin sodium pharmaceutical dosage form by high performance liquid chromatography to be applied for quality control in pharmaceutical industry

A reversed-phase high performance liquid chromatography method was validated for the determination of cefazolin sodium in lyophilized powder for solution for injection to be applied for quality control in pharmaceutical industry. The liquid chromatography method was conducted on a Zorbax Eclipse Plus C18 column (250 x 4.6 mm, 5 μm), maintained at room temperature. The mobile phase consisted of purified water: acetonitrile (60: 40 v/v), adjusted to pH 8 with triethylamine. The flow rate was of 0.5 mL min-1 and effluents were monitored at 270 nm. The retention time for cefazolin sodium was 3.6 min. The method proved to be linear (r2=0.9999) over the concentration range of 30-80 µg mL-1. The selectivity of the method was proven through degradation studies. The method demonstrated satisfactory results for precision, accuracy, limits of detection and quantitation. The robustness of this method was evaluated using the Plackett–Burman fractional factorial experimental design with a matrix of 15 experiments and the statistical treatment proposed by Youden and Steiner. Finally, the proposed method could be also an advantageous option for the analysis of cefazolin sodium, contributing to improve the quality control and to assure the therapeutic efficacy.