EFFECTIVE DOSE IN TWO DIFFERENT DENTAL CBCT SYSTEMS: NEWTOM VGi AND PLANMECA 3D MID

MEASUREMENT OF ENTRANCE SKIN DOSE AND ABSORBED DOSE TO DIFFERENT ORGANS IN DUAL-ENERGY X-RAY ABSORPTIOMETRY SCANS USING THERMOLUMINESCENCE DOSIMETRY

Thermoluminescence dosimetry is considered as an effective method in estimating the absorbed doses to organs in different imaging modalities. The present study focuses on dosimetry in dual-energy X-ray absorptiometry scans, for patients, and phantoms in various imaging centres. The cubical LiF (Mg, Ti) thermoluminescence dosemeters were inserted inside the holes of the Rando phantom slabs, to measure the absorbed dose to different organs in the whole body and lumbar scans. According to the results the maximum entrance skin dose was found to be 202.06 μGy for Hologic discovery W, which uses the fan beam scanning mode. The Norland XR-800 device took the scans with a much lower dose, as it uses the pencil beam for scanning the patients. The results of the study show that the radiation beam type, patient thickness, imaging technique and scan time may affect the radiation dose received by patient.

Effective dose estimation in cone-beam computed tomography for dental use by Monte-Carlo simulation optimizing calculation numbers using a step-and-shoot method

OBJECTIVE

The objective of this study was to perform effective dose estimation in cone-beam CT for dental use (CBCT) using a Monte-Carlo simulation employing a step-and-shoot method as well as to determine the optimal number of steps.

METHODS

We simulated 3DX Accuitomo FPD8 as a CBCT model and estimated the effective doses of a large and a small field of view (FOV) examination against the virtual Rando phantom using a particle and heavy ion transport code system. We confirmed the results compared to those from a thermo-luminescence dosemeter (TLD) system in a real phantom and investigated how the reduced angle calculations could be accepted.

RESULTS

The effective doses of both FOVs estimated with each one degree were almost the same as those estimated from the TLD measurements. Considering the effective doses and the itemized organ doses, simulation with 5° and 10° is acceptable for the large and small FOV, respectively. We tried to compare an effective dose with a large FOV as well as with multiple small FOVs covering the corresponding area and found that the effective dose from six small FOVs was approximately 1.2 times higher than that of the large FOVs.

CONCLUSION

We successfully performed a Monte-Carlo simulation using a step-and-shoot method and estimated the effective dose in CBCT. Our findings indicate that simulation with 5° or 10° is acceptable based on the FOV size, while a small multiple FOV scan is recommended from a radiation protection viewpoint.

Measurement of Entrance Skin Dose and the Dose Received by Different Organs in Panoramic Dental Imaging

Background:

Thermoluminescence dosimetry(TLD) has been known as one of the most effective methods for dose estimation in diagnostic radiology. Orthopantomogram (OPG) imaging is used by many dentists, oral and maxillofacial surgeons as an effective tool for choosing an appropriate treatment plan.

Objective:

This study aims to measure the entrance skin dose and the dose values received by different head and neck organs in OPG imaging using TLD dosimeters (TLD-100).

Material and Methods:

In this experimental study, the entrance skin dose and doses of various organs during imaging were measured by TLD dosimeters inside and on the surface of the Rando-Phantom. Doses to various organs, including thyroid, eye, esophagus, parotid and sublingual and submandibular salivary glands were measured. The measurements were repeated twice, and the dose values obtained in the two steps were compared.

Results:

Based on the results obtained in this study, the minimum dose values were found in Esophagus; 65.81, and 59.31 µGy, respectively. The maximum organ dose value was found for left parotid glands, 3842.42, and 3399.58 for the two measurements, respectively.

Conclusion:

The results show that the dose values can vary based on devices, exposure conditions, and TLD positioning.