MEASUREMENT AND EVALUATION OF ELECTRIC FIELD STRENGTH LEVELS IN PRIMARY AND SECONDARY SCHOOLS IN A PILOT REGION

Comparison of personal exposure to Radiofrequency Electromagnetic Fields from Wi-Fi in a Spanish university over three years

In this work we present the personal exposure levels to Radiofrequency Electromagnetic Fields (RF-EMF) from Wireless Fidelity (Wi-Fi) 2.4 GHz and 5.85 GHz bands in a Spanish university, specifically, at the Faculty of Computer Science Engineering at the University of Castilla-La Mancha (Albacete, Spain). We present results from three years, 2017, 2018 and 2019 in the same study place and points; and measurements carried out in 2022 inside a classroom and inside a professor's office, with the aim to compare the measurements and verify compliance with reference levels established by the International Commission on Non-Ionizing Radiation Protection (ICNIRP). The minimum average was 0.0900 μW/m² in the 2.4 GHz Wi-Fi, in 2019, and the maximum average was 211 μW/m² in the 5.85 GHz Wi-Fi in 2017, around the building. Comparing the measurements carried out inside the classroom with students and without students, we identified that the maximum value was 278 μW/m² (classroom with students, in the 5.85 GHz Wi-Fi band) and the minimum value was 37.9 μW/m² (classroom without students, in the 5.85 GHz Wi-Fi band). Finally, comparing the results of all the measurements (average values) inside the classroom and inside a professor's office, the maximum value was 205 μW/m² (in the 5.85 GHz Wi-Fi band) inside the classroom with students, and the minimum value was 0.217 μW/m² inside a professor's office (in the 2.4 GHz Wi-Fi band). These values in no case exceed the limits established by the International Commission on Non-Ionizing Radiation Protection, 10 W/m² for general public exposure.

Instruments to measure environmental and personal radiofrequency-electromagnetic field exposures: an update

Modern human populations are exposed to anthropogenic sources of radiofrequency-electromagnetic fields (RF-EMFs), primarily to telecommunication and broadcasting technologies. As a result, ongoing concerns from some members of the public have arisen regarding potential health effects following RF-EMF exposures. In order to monitor human RF-EMF exposures and investigate potential health effects, an objective assessment of RF-EMF exposures is necessary. Accurate dosimetry is essential for any investigation of potential associations between RF-EMF exposure and health effects in human populations. This review updates state-of-the-art knowledge of currently available RF-EMF exposure assessment tools applicable in human epidemiological studies. These tools cater for assessing RF-EMF exposures in human environments; through mobile phone-based tools or other standalone tools. RF-EMF exposure assessment has been significantly improved through the application of some of these tools in recent years.

Comprehensive radiofrequency electromagnetic field measurements and assessments: a city center example

In this study, radiofrequency electromagnetic field (RF-EMF) measurements were carried out between 2016 and 2018 in one the largest provinces of Turkey; measurement results are compared with the limit values determined by International Commission on Non-Ionizing Radiation Protection (ICNIRP) and Turkey's Information and Communication Technologies Authority (ICTA). In the first stage of a three-phase evaluation, short-term RF-EMF measurements were conducted in 500 locations over a 2-year period. In the second stage, short-term RF-EMF measurement results were analyzed to determine selected locations for long-term RF-EMF measurements to be carried out, including variation of RF-EMF during the day. In the last stage, band selective measurements were taken and the main sources of RF-EMF in the environment were determined. Overall, RF-EMF values do not exceed the limits determined by ICNIRP and ICTA, and they are below levels that threaten public health. In the short-term RF-EMF measurements, RF-EMF levels doubled after fourth generation (4G) systems were introduced. In the long-term RF-EMF measurements, RF-EMF values in the day are 35.4% more than at night. The total measured RF-EMF within the city center is 99.3% base station sourced. Among the six main RF-EMF sources, the devices operating in UMTS2100 band have the most contribution to total RF-EMF of medium with 31.2%. Additionally, we found short-term average electric field strength data are best described by the "exponential distribution," while long-term RF-EMF measurement data is best described by the "Burr distribution."

Radio Frequency Electromagnetic Fields Exposure Assessment in Indoor Environments: A Review

Exposure to radiofrequency (RF) electromagnetic fields (EMFs) in indoor environments depends on both outdoor sources such as radio, television and mobile phone antennas and indoor sources, such as mobile phones and wireless communications applications. Establishing the levels of exposure could be challenging due to differences in the approaches used in different studies. The goal of this study is to present an overview of the last ten years research efforts about RF EMF exposure in indoor environments, considering different RF-EMF sources found to cause exposure in indoor environments, different indoor environments and different approaches used to assess the exposure. The highest maximum mean levels of the exposure considering the whole RF-EMF frequency band was found in offices (1.14 V/m) and in public transports (0.97 V/m), while the lowest levels of exposure were observed in homes and apartments, with mean values in the range 0.13⁻0.43 V/m. The contribution of different RF-EMF sources to the total level of exposure was found to show slightly different patterns among the indoor environments, but this finding has to be considered as a time-dependent picture of the continuous evolving exposure to RF-EMF.

AN EMPIRICAL STUDY: THE IMPACT OF THE NUMBER OF USERS ON ELECTRIC FIELD STRENGTH OF WIRELESS COMMUNICATIONS

As a result of the drastic increase in the number of mobile device users, there is considerable public debate about possible health hazards especially due to base stations and Wi-Fi access points. For this reason, in this study the effects of the number of users in a base station and wireless fidelity (Wi-Fi) access point on electric field strength (E) levels were investigated using real-time measurements. Two-stage E measurements were performed on Ondokuz Mayıs University's (OMU) Kurupelit Campus with a PMM-8053 and SRM-3006 electromagnetic field (EMF) meter. In the first stage, 24-h measurements were performed with PMM-8053 at the location where the maximum E was measured and from which the busiest times of the day were then determined. The relationship among band selective E values was assessed using the number of users per minute provided by three cellular system operators for the location. Upper and lower bounds of E according to the number of users were calculated, and then an empirical model that helps calculate the E of medium with 86% accuracy was proposed. In the second stage, the effect of the number of users in a Wi-Fi access point on E level was investigated. For this purpose, the measurement environment was set as including one Wi-Fi access point with needed measurement devices. The number of users was increased as per user per minute. The number of users was validated with the data obtained from OMU IT Department. Using the measurement result, a model with a 96% accuracy between the E value in the environment and the number of users accessing the Wi-Fi system is proposed. With the use of these models, E level in the medium can be determined without using any EMF meters, thus precautions can be taken to stay within regulatory limits.