A review of recent literature on the biomechanics of spinal instrumentation:

Simulation of an anterior spine instrumentation in adolescent idiopathic scoliosis using a flexible multi-body model

Anterior spinal instrumentation is an alternative option to posterior instrumentation for surgical treatment of adolescent idiopathic scoliosis (AIS). However, optimal instrumentation configuration and strategies are not yet clearly defined. A biomechanical kinematic model using flexible mechanism was developed to study instrumentation strategies. Preoperative 3D reconstruction of scoliotic patient's spine was used to define the patient-specific geometry of the model. Mechanical properties were adjusted to consider the discectomy and surgical manoeuvres were reproduced. Anterior spine surgeries of ten patients were simulated and results were compared to immediate post-operative data and showed differences of <5 degrees for the Cobb angles. The validated model was used to find optimal instrumentation configurations for one patient prior to surgery. Six strategies were tested out of which the optimal one was identified while two were not recommended for surgery since screw forces exceeded published pullout forces. This study demonstrates the possibility to simulate anterior spine instrumentations.

Biomechanical comparison of anterior cervical spine locked and unlocked plate-fixation systems

Three different anterior plate-fixation systems are available for the stabilisation of the cervical spine: (1) the cervical spine locking plate (CSLP), (2) dynamic plates allowing vertical migration of the fixation screws, and (3) various types of plates that are secured with either monocortical or bicortical unlocked screws. Unicortical screw purchase does not involve the risk of posterior cortex penetration and possible injuries to the spinal cord. The development of locking plates with unicortical screw-fixation and intrinsic stability of the screw-plate interface, via an angle-stabilised connection, was an attempt to increase the stability of unicortical screw-fixation systems. The aim of the study was to compare the biomechanical properties of a non-locking, anterior-plate system with 4.5 mm screw fixation and a locking anterior-plate system, in a single destabilised cervical spine-motion segment. Using fresh cadaveric cervical spine specimen C3-C7, multidirectional flexibility was measured at the C4-C5 level in an unconstrained test system, before and after destabilisation and fixation with an anterior plate with either locked or unlocked screw purchase. Direct comparison of the fixed cervical spine segments with unlocked and locked anterior-plate fixation did not demonstrate significant differences. This in vitro study documented that neither locked nor unlocked anterior-plate fixation can increase stability in all modes of testing. H-plate spondylodesis with unlocked screws seems to provide sufficient mechanical integrity in most cases of monosegmental lesions.