Microwave sensing of increased intracranial water content

Multifrequency Analysis of Single Inductive Coil Measurements Across a Gel Phantom Simulation of Internal Bleeding in the Brain

The present study is part of an ongoing effort to develop a simple diagnostic technology for detecting internal bleeding in the brain, which can be used in lieu or in support of medical imaging and thereby reduce the cost of diagnostics in general, and in particular, would make diagnostics accessible to economically disadvantaged populations. The study deals with a single coil inductive device to be used for detecting cerebral hemorrhage. It presents a first-order experimental study that examines the predictions of our recently published theoretical study. The experimental model employs a homogeneous cylindrical phantom in which internal head bleeding was simulated by way of a fluid inclusion. We measured the changes in amplitude and phase across the coil with a network vector analyzer as a function of frequency (100-1,000 MHz), volume of blood simulating fluid, and the site of the fluid injection. We have developed a new mathematical model to statistically analyze the complex data produced in this experiment. We determined that the resolution for the fluid volume increase following fluid injection is strongly dependent on frequency as well as the location of liquid accumulation. The experimental data obtained in this study supports the predictions of our previous theoretical study, and the statistical analysis shows that the simple single coil device is sensitive enough to detect changes due to fluid volume alteration of two milliliters. Bioelectromagnetics. 2020;41:21-33 © 2019 Bioelectromagnetics Society.

Microwave sensing of physiological movement and volume change: a review

The ability non-invasively to detect and monitor the movement of tissues and organs from outside the body provides many worthwhile areas of potential biomedical applications. Several non-invasive microwave techniques for contact and remote sensing of circulatory and respiratory movements and volume changes have been developed. In general, these systems consist of a microwave generator, a sampling device, a transmitting-receiving antenna, a set of signal-conditioning and processing devices, and a display unit. They operate at continuous-wave frequencies between 1 and 35 GHz and make use of amplitude and phase information derived from the received signal. The average power density of energy radiated by present systems ranges from approximately 0.001-1.0 mW/cm2. These systems are capable of registering instantaneous changes in fluid volume, pressure pulse, heart rate, and respiration rate in contact with body surface or at distances greater than 30 m, or behind thick layers of non-conductive walls.

Active microwave computed brain tomography: the response to a challenge

The potential application of active microwave techniques to brain imaging is studied by numerical simulations and experimentally using a recently developed cylindrical microwave scanner. The potential advantages and limitations of this method in static and dynamic brain imaging are presented and compared with other imaging techniques.