Coronal Leakage of Sealer-Only Backfill: An In Vitro Evaluation

Performance of obturation techniques in anatomical irregularities located at different thirds of the root canal system

This study aimed to compare the quality of root canal obturation (ratio of area occupied by gutta-percha (G), sealer (S), and presence of voids (V)) in different anatomical irregularities (intercanal communications, lateral irregularities, and accessory canals) located at different thirds of the root canal system of mandibular molar replicas. Sixty-seven 3D printed replicas of an accessed mandibular molar were prepared using ProGlider and ProTaper Gold rotatory systems. Three specimens were randomly selected to be used as controls and did not receive further treatment. The rest were randomly distributed in 4 experimental groups to be obturated using either cold lateral compaction (LC), continuous wave of condensation (CW), and core-carrier obturation (ThermafilPlus (TH) or GuttaCore (GC)) (n=16 per group). AHPlus® sealer was used in all groups. The three controls and a specimen from each experimental group were scanned using micro-computed tomography. The rest of the replicas were sectioned at the sites of anatomical irregularities and examined at 30× magnification. The G, S, and V ratios were calculated dividing the area occupied with each element by the total root canal area and then compared among groups using the Kruskal-Wallis test. Voids were present in all obturation techniques with ratios from 0.01 to 0.15. CW obtained a significantly higher G ratio in the irregularity located in the coronal third (0.882) than LC (0.681), TH (0.773), and GC (0.801) (p<0.05). TH and GC achieved significantly higher G ratios in those located in the apical third (p<0.05). The worst quality of obturation was observed in the loop accessory canal with all obturation techniques. Whitin the limitations of this study, it can be concluded that CW and core-carrier obturation are respectively the most effective techniques for obturating anatomical irregularities located in the coronal and the apical third.

Root canal hydrophobization by dentinal silanization: improvement of silicon-based endodontic treatment tightness

A new strategy to improve silicon-based endodontic treatment tightness by dentine hydrophobization is presented in this work: root dentine was silanized to obtain a hydrophobic dentine-sealer interface that limits fluid penetration. This strategy was based on the grafting of aliphatic carbon chains on the dentine through a silanization with the silane end groups [octadecyltrichlorosilane (OTS) and octadecyltriethoxysilane]. Dentine surface was previously pretreated, applying ethylenediaminetetraacetic acid and sodium hypochlorite, to expose hydroxyl groups of collagen for the silane grafting. Collagen fibers exposure after pretreatment was visible with scanning electron microscopy, and Fourier transform infrared (FTIR) spectroscopy showed their correct exposition for the silanization (amide I and II, with 1630, 1580, and 1538 cm⁻¹ peaks corresponding to the vibration of C=O and C--N bonds). The grafting of aliphatic carbon chains was confirmed by FTIR (peaks at 2952 and 2923 cm⁻¹ corresponding to the stretching of C--H bonds) and by the increasing of the water contact angle. The most efficient hydrophobization was obtained with OTS in ethyl acetate, with a water contact angle turning from 51° to 109°. Gas and liquid permeability tests showed an increased seal tightness after silanization: the mean gas and water flows dropped from 2.02 × 10⁻⁸ to 1.62 × 10⁻⁸ mol s⁻¹ and from 10.8 × 10⁻³ to 5.4 × 10⁻³ µL min⁻¹, respectively. These results show clear evidences to turn hydrophilic dentine surface into a hydrophobic surface that may improve endodontic sealing.

In vitro study assessing apical leakage of sealer-only backfills in root canals of primary teeth

AIM

To assess the sealing ability of zinc oxide-eugenol (ZOE), Apexit, and Sealapex used as sealer-only backfills in root canals of primary teeth using the high-pressure replica technique.

METHODOLOGY

Two hundred and seventy root canals of deciduous molars as well as primary anterior teeth were randomly assigned to three groups (n=90). Root canals were prepared to size 35 and filled with either zinc oxide-eugenol (ZOE), Apexit, or Sealapex using a lentulo filler. Twenty-four hours after setting of the materials the roots were nail-varnished (except for the apical tip), and half of the specimens (n=45) were penetrated by a coloured (rhodamine B) epoxy resin. The resin was infiltated into the pores and cavities of the teeth in a high-pressure vessel. The remaining groups (n=45) were stored in 100% humidity, and infiltration of the resin followed after 40d. Apical leakage was assessed by means of a grinding technique using eight steps of 0.5mm each.

RESULTS

ZOE and Apexit failed to seal the root canals in both subgroups. This was significantly different from the root canals filled with Sealapex where in both subgroups some 30% of the specimens revealed a tight seal up to a distance of 2.9mm of the apex.

CONCLUSIONS

Under the conditions of this study it can be concluded that Sealapex shows less leakage than ZOE and Apexit. With regard to the three materials tested, Sealapex should be a viable alternative for sealer-only obturation of pulpectomized primary teeth. The high-pressure replica technique seems to be suitable for assessing leakage of root canal filling materials.

Leakage of Bovine Serum Albumin in Root Canals Obturated with Super-EBA and IRM

The aim of this study was to determine the leakage of SuperEBA and intermediate restorative material (IRM) in root canal samples, with or without orthograde filling, by evaluating bovine serum albumin (BSA) microleakage using spectrophotometry. Thirty-five single-rooted teeth were divided into five groups, instrumented, and had apices resected. Root-end cavities in groups I and II were filled with SuperEBA and IRM. The samples from the groups III, IV, and V were filled with gutta-percha and sealer. In groups IV and V, root-end cavities were filled with SuperEBA and IRM. After 60 days, the greatest microleakage of BSA was observed in group II (4.1 +/- 0.0011 ng), followed by group III (3.4 +/- 0.0064 ng), and then group I (2.6 +/- 0.0019 ng). Samples from groups IV and V leaked the least (0.7 +/- 0.0014 ng). Significantly less leakage (p < 0.05) occurred in samples filled with orthograde and root-end fillings than did in samples filled only with an orthograde approach and the samples with IRM root-end fillings.