Cardiac Cine Imaging at 3 Tesla

Postmortem whole-body MRI in traumatic causes of death

OBJECTIVE

The aim of this study was to determine the sensitivity and specificity of postmortem whole-body MRI for typical injuries resulting from traumatic causes of death.

MATERIALS AND METHODS

Forty cases of accidental death were evaluated with postmortem whole-body MRI. Imaging was conducted according to a standard protocol, and each examination had an average duration of 90 minutes. The imaging findings were correlated with the autopsy findings, which served as the reference standard.

RESULTS

MRI showed the main pathologic process leading to death in 39 of the 40 cases. The sensitivity of postmortem MRI ranged from 100% (pneumothorax) to 40% (fractures of the upper extremities). In general, MRI had a high level of performance for depicting soft-tissue lesions, such as subcutaneous hematoma (e.g., galeal hematoma with a sensitivity 95%). The sensitivity of MRI was remarkably lower for lesions of the upper abdominal organs (liver, 80%; spleen, 50%; pancreas, 60%; kidneys, 66%).

CONCLUSION

Postmortem whole-body MRI had overall good performance for depicting traumatic findings in corpses and therefore may serve an important role as an adjunct to classic autopsy for the forensic examination of cases of traumatic cause of death. However, the reduced sensitivity of postmortem MRI for lacerations of the upper abdominal organs and the observed superimposition of antemortem findings and postmortem findings (e.g., in the pulmonary tissue) in this retrospective study suggest that whole-body postmortem MRI not be recommended as a replacement for classic autopsy.

Clinical applications for cardiovascular magnetic resonance imaging at 3 tesla

Cardiovascular magnetic resonance (CMR) imaging has evolved rapidly and is now accepted as a powerful diagnostic tool with significant clinical and research applications. Clinical 3 Tesla (3 T) scanners are increasingly available and offer improved diagnostic capabilities compared to 1.5 T scanners for perfusion, viability, and coronary imaging. Although technical challenges remain for cardiac imaging at higher field strengths such as balanced steady state free precession (bSSFP) cine imaging, the majority of cardiac applications are feasible at 3 T with comparable or superior image quality to that of 1.5 T. This review will focus on the benefits and limitations of 3 T CMR for common clinical applications and examine areas in development for potential clinical use.

Improved radial GRAPPA calibration for real-time free-breathing cardiac imaging

To generate real-time, nongated, free-breathing cardiac images, the undersampled radial trajectory combined with parallel imaging in the form of radial GRAPPA has shown promise. However, this method starts to fail at high undersampling factors due to the assumptions that must be made for the purposes of calibrating the GRAPPA weight sets. In this manuscript, a novel through-time radial GRAPPA calibration scheme is proposed which greatly improves image quality for the high acceleration factors required for real-time cardiac imaging. This through-time calibration method offers better image quality than standard radial GRAPPA, but it requires many additional calibration frames to be acquired. By combining the through-time calibration method proposed here with the standard through-k-space radial GRAPPA calibration method, images with high acceleration factors can be reconstructed using few calibration frames. Both the through-time and the hybrid through-time/through-k-space methods are investigated to determine the most advantageous calibration parameters for an R = 6 in vivo short-axis cardiac image. Once the calibration parameters have been established, they are then used to reconstruct several in vivo real-time, free-breathing cardiac datasets with temporal resolutions better than 45 msec, including one with a temporal resolution of 35 msec and an in-plane resolution of 1.56 mm(2) .

Current status of 3-T cardiovascular magnetic resonance imaging

Continued advances in radiofrequency hardware and tailored software have, in recent times, greatly increased the power and performance of magnetic resonance imaging for noninvasive evaluation of cardiovascular diseases. Magnetic resonance imaging can uniquely be manipulated to trade temporal resolution and spatial resolution against each other, depending on whether detailed structural or functional information is required. However, to date, a number of cardiovascular magnetic resonance applications have been somewhat limited due to signal-to-noise ratio constraints, reflecting the narrow imaging window imposed by physiological cardiac motion. By increasing the operating field strength from 1.5 to 3 T, it is possible (in principle) to double the signal-to-noise ratio, which in turn may be "traded" for improvements in spatial resolution, coverage, or imaging speed. In this context, the development of parallel imaging has set the stage for impressive performance improvements in contrast-enhanced magnetic resonance angiography at 3 T. Indeed, one could argue that without parallel acquisition, the bang for the buck in going from 1.5 to 3 T would be limited. In this paper, we discuss the current status of 3-T magnetic resonance imaging for cardiovascular imaging, considering the relative gains and limitations relative to 1.5 T.

Cardiac MRI of ischemic heart disease at 3 T: potential and challenges

Cardiac MRI has become a routinely used imaging modality in the diagnosis of cardiovascular disease and is considered the clinically accepted gold standard modality for the assessment of cardiac function and myocardial viability. In recent years, commercially available clinical scanners with a higher magnetic field strength (3.0 T) and dedicated multi-element coils have become available. The superior signal-to-noise ratio (SNR) of these systems has lead to their rapid acceptance in cranial and musculoskeletal MRI while the adoption of 3.0 T for cardiovascular imaging has been somewhat slower. This review article describes the benefits and pitfalls of magnetic resonance imaging of ischemic heart disease at higher field strengths. The fundamental changes in parameters such as SNR, transversal and longitudinal relaxation times, susceptibility artifacts, RF (B1) inhomogeneity, and specific absorption rate are discussed. We also review approaches to avoid compromised image quality such as banding artifacts and inconsistent or suboptimal flip angles. Imaging sequences for the assessment of cardiac function with CINE balanced SSFP imaging and MR tagging, myocardial perfusion, and delayed enhancement and their adjustments for higher field imaging are explained in detail along with several clinical examples. We also explore the use of parallel imaging at 3.0 T to improve cardiac imaging by trading the SNR gain for higher field strengths for acquisition speed with increased coverage or improved spatial and temporal resolution. This approach is particularly useful for dynamic applications that are usually limited to the duration of a single breath-hold.

Cardiac MR imaging: new advances and role of 3T

Over the last decade, cardiac magnetic resonance imaging has increasingly evolved into a useful diagnostic tool among the radiology and cardiology communities. Ongoing improvements in MR imaging hardware, processing speed, and pulse sequence development have laid the foundation for rapid progress in cardiac MR imaging. This article summarizes developing techniques and technique-related aspects, and the advantages and possible pitfalls of 3T in particular.

Highly accelerated cardiovascular MR imaging using many channel technology: concepts and clinical applications

Cardiovascular magnetic resonance imaging (CVMRI) is of proven clinical value in the non-invasive imaging of cardiovascular diseases. CVMRI requires rapid image acquisition, but acquisition speed is fundamentally limited in conventional MRI. Parallel imaging provides a means for increasing acquisition speed and efficiency. However, signal-to-noise (SNR) limitations and the limited number of receiver channels available on most MR systems have in the past imposed practical constraints, which dictated the use of moderate accelerations in CVMRI. High levels of acceleration, which were unattainable previously, have become possible with many-receiver MR systems and many-element, cardiac-optimized RF-coil arrays. The resulting imaging speed improvements can be exploited in a number of ways, ranging from enhancement of spatial and temporal resolution to efficient whole heart coverage to streamlining of CVMRI work flow. In this review, examples of these strategies are provided, following an outline of the fundamentals of the highly accelerated imaging approaches employed in CVMRI. Topics discussed include basic principles of parallel imaging; key requirements for MR systems and RF-coil design; practical considerations of SNR management, supported by multi-dimensional accelerations, 3D noise averaging and high field imaging; highly accelerated clinical state-of-the art cardiovascular imaging applications spanning the range from SNR-rich to SNR-limited; and current trends and future directions.

Reconstruction and visualization of fiber and laminar structure in the normal human heart from ex vivo diffusion tensor magnetic resonance imaging (DTMRI) data

OBJECTIVE

The human heart is composed of a helical network of muscle fibers organized to form sheets that are separated by cleavage planes responsible for the orthotropic mechanical properties of cardiac muscle. The purpose of this study is the reconstruction and visualization of these structures in 3 dimensions.

METHODS

Anisotropic least square filtering followed by fiber and sheet tracking techniques were applied to diffusion tensor magnetic resonance imaging data of the excised human heart. Fibers were reconstructed using the first eigenvectors of the diffusion tensors. The sheets were reconstructed using the second and third eigenvectors and visualized as surfaces.

RESULTS

The fibers are shown to lie in sheets that have transmural structure, which correspond to histologic studies published in the literature. Quantitative measurements show that the sheets as appose to the fibers are organized into laminar orientations without dominant populations.

CONCLUSIONS

A visualization algorithm was developed to demonstrate the complex 3-dimensional orientation of the fibers and sheets in human myocardium.

Advances in magnetic resonance (2007)

Advances in clinical magnetic resonance (MR) are discussed in this review in the context of publications from Investigative Radiology during 2006 and 2007. The articles relevant to this topic, published during this 2 year time period, are considered as organized by anatomic region. An additional final focus of discussion is in regards to those studies involving MR contrast media.

Body and Cardiovascular MR Imaging at 3.0 T

Potential advantages of magnetic resonance (MR) imaging at 3 T include higher signal-to-noise ratios, better image contrast, particularly in gadolinium-enhanced applications, and better spectral separation for spectroscopic applications. In terms of clinical imaging, these advantages can mean higher-spatial-resolution images, faster imaging, and improved MR spectroscopy. However, achieving superior imaging and spectroscopic quality at 3 T can be challenging. This review discusses many of the problems encountered in body and cardiovascular MR imaging at 3 T, such as increased susceptibility, B1 field inhomogeneity, and increased specific absorption rate. The article also considers solutions that are being pursued, such as parallel imaging, variable-rate selective excitation, and variable flip angle sequences. A review of the most commonly used pulse sequences provides practical tips on how these can be optimized for 3-T imaging. In the coming few years, substantial improvements in 3-T technology for clinical imaging and spectroscopy will undoubtedly be seen. An understanding of the basic principles on which these developments are based will help radiologists translate the advances into better imaging studies and, ultimately, better patient care.

Parallel magnetic resonance imaging

Parallel MRI started with the introduction of coil arrays in improving radiofrequency (RF) acquisition (what is called parallel imaging) and continued with an analogous development for RF transmission (parallel transmission). Based on differences in the spatial sensitivity distributions of the involved array elements, both techniques try to shorten the respective k-space trajectory. Parallel imaging refers to the acquisition of k-space data, whereas parallel transmission is dealing with the deposition of RF energy packages in the excitation k-space. However, parallel transmission is not simply the reciprocal of parallel imaging. The main goal of parallel imaging is the shortening of the acquisition time. The main goal of parallel transmission is the shortening of the pulse duration of spatially selective RF pulses. The present article describes the basic concept, the state of the art, and the similarities and differences of both technologies.

High-resolution complementary spatial modulation of magnetization (CSPAMM) rat heart tagging on a 1.5 Tesla Clinical Magnetic Resonance System: a preliminary feasibility study

The purpose of this study was to assess the feasibility of cardiac magnetic resonance (MR) tagging in rats on a standard clinical 1.5T MR system. Small animal models have been largely used as an experimental model in cardiovascular disease studies but mainly on high field systems (>4T) dedicated to research. Given the larger availability of routine clinical MR systems in centers with active cardiac research programs, it is of great interest to perform small animal imaging on whole-body MR systems of moderate field strength. The feasibility study was performed on 7 rats within 6 to 8 hours after myocardial infarction and 3 normal control rats. Myocardial strain was measured successfully in normal rats using the harmonic phase (ie, HARP) method, and a transmural gradient was demonstrated. In a rat model of acute occlusion/reperfusion, the myocardial circumferential strains were decreased, but the transmural strain gradient was preserved. This study demonstrated the feasibility of cardiac MR tagging in rats with a subendocardial resolution using a clinical 1.5T system.

High-field-strength magnetic resonance: potential and limits

OBJECTIVE

To expatiate on the possible advantages and disadvantages of high magnetic field strengths for magnetic resonance imaging and, in particular, for magnetic resonance angiography.

METHODS AND RESULTS

A review of the available literature is given, presenting many of the advantages and disadvantages of imaging at higher field strengths. Focus is put on imaging at 3 to 7 T. Early results at 7 T are presented; these results indicate that several of the angiographic techniques commonly used at lower field strengths show promise for improvement by taking advantage of the higher signal and susceptibility sensitivity at 7 T.

CONCLUSIONS

The drive toward higher field strengths, both for the purpose of fundamental research and for clinical diagnostic imaging, is likely to continue. New applications using the unique properties of high field strength will almost certainly emerge as researchers gain more experience. The ultimate limiting factor is likely to be the physiological effects at high field strengths. However, this limit seems to lie at field strengths higher than 7 T because early experience shows good tolerance of 7 T examinations.