Virtual Surgical Planning and One-Stage Treatment of Active Hemimandibular Hyperplasia

'Adaptable condylectomy' for acquired facial asymmetry and malocclusion caused by temporomandibular joint condylar hyperplasia

This article describes the 'adaptable condylectomy' and highlights two innovative treatment protocols for the variety of acquired facial asymmetry and associated malocclusion caused by condylar hyperplasia, as illustrated by the cases of seven patients presenting different manifestations of condylar hyperplasia. Protocol I (three cases) is applied for condylar hyperplasia with a normal occlusion and involves a high condylectomy, with the goal of guiding the mandible back to the original occlusion. Protocol II (four cases) is applied for condylar hyperplasia with diverse acquired malocclusions and involves condylectomy at a level adapted to the malocclusion, allowing the mandible to be guided back to the occlusion that pre-existed the active change caused by the condylar hyperplasia, or to a position as close to the midline as possible. Both protocols are followed by gradual self-correction of the acquired facial asymmetry. These protocols often obviate the need for further surgical intervention and, if further correction is needed, it is much simpler.

Can Condylectomy Alone Achieve Facial Symmetry in Patients With Hemimandibular Hyperplasia (Condylar Hyperplasia Type 2)?

The purpose of the present study was to evaluate the 3-dimensional orofacial changes occurring after proportional condylectomy in patients with unilateral condylar hyperplasia type 2 (hemimandibular hyperplasia). Eight patients underwent proportional condylectomy that was not followed by orthognathic surgery or orthodontic treatment for at least 1 year. The precondylectomy and postcondylectomy photographs and radiographs were analyzed cephalometrically and compared. The average length of the condylar segment removed was 13 mm and this resulted in almost equal heights of the ramus-condyle units of both sides. Evaluations in the vertical plane improved after surgery; however, when the preoperative asymmetry was significant, the residual asymmetry continued to be notable after condylectomy. Transverse plane evaluations improved after condylectomy, and chin position was satisfactorily centralized in all patients. In the horizontal plane, mandibular setback occurred, and this was considered favorable when the preoperative skeletal profile was class III, whereas the opposite was when the patient was class I before surgery. The occlusion improved gradually over the postoperative months by the intrusion on the affected side and extrusion on the unaffected side into a bilaterally balanced posterior contacts with residual anterior open bite. In conclusion, condylar hyperplasia type 2 patients with mild asymmetry and low esthetic demands can benefit from proportional condylectomy as the sole treatment to both stop the hyperplastic condylar growth and improve the asymmetry to some extent. Surgeons should be able to predict the change that is expected to occur after proportional condylectomy and discuss this with the patient before surgery.

Virtual Surgical Planning and Three-Dimensional Printing to Aid the Anatomical Reduction of an Old Malunited Fracture of the Mandible

ABSTRACT

Mandible fracture is a common injury in maxillofacial surgery. It causes not only maxillofacial dysfunction but also facial deformities. Malunited fractures of the mandible have been a vast challenge in clinical treatment due to the misalignment of the broken ends and the occurrence of occlusal disorders. This case report describes using virtual surgical planning and three-dimensional printing to treat a patient with malunited fracture of the mandible. Failing to perform mandibular surgery due to severe brain trauma after the car accident, the patient got malunited healing of mandible. The authors applied virtual surgical planning to perform preoperative analysis and surgical design on this patient, three-dimensional printing to fabricate occlusal plate, and models of the preoperative and postoperative mandible to guide the operation. Finally, the authors achieved the reduction and reconstruction of the mandible with satisfactory clinical results.