Prevalence of Dentofacial Injuries and Concussions Among College Athletes and Their Perceptions of Mouthguards

Influence of Using a Puncturing Method and Cooldown Period Before Pressing the Second-Layered Sheet on the Final Thickness of Double-Layered Sports Mouthguards: An Experimental Study

AIM

The thickness of the mouthguard is a crucial factor in its protective ability for athletes. This study aimed to investigate the final thickness of double-layered sports mouthguards, which were fabricated using different methods before pressing the second layer.

MATERIALS AND METHODS

Seven upper working models (n = 7 per group) were prepared for mouthguard fabrication. The first 3-mm mouthguard sheet underwent heating, pressing, and vacuuming onto the model, followed by various protocols before the second 3-mm sheet was pressed. Group 1: The second sheet was pressed immediately. Group 2: The first sheet underwent a 1-h cooldown period before pressing the second sheet. Group 3: The interproximal areas of the first sheet were punctured followed by immediate pressing of the second sheet. Group 4: The first sheet was punctured followed by a 1-h cooldown before pressing the second sheet. After 24 h, the mouthguard thickness was measured at various points on the left and right central incisors and first molars using a digital caliper. The thickness analysis was performed using SPSS 29.0 with one-way ANOVA and Tukey post hoc analysis.

RESULTS

At the labial surface of the central incisors, Group 4 exhibited the highest thickness, while Group 3 had the lowest (p < 0.001). Groups 1 and 2 did not show significant differences in thickness. At the incisal edges, Group 3 again had the lowest thickness (p < 0.05), with no significant differences observed among the other groups. There were no significant differences in thickness across all areas at the first molars, including cusp tips, pits, and buccal surfaces (p > 0.05). Group 4 demonstrated greater uniformity at the central incisors in thickness compared with the other groups.

CONCLUSIONS

Using the puncturing method at interproximal areas combined with a cooldown period could enhance mouthguard thickness at the labial surfaces of the central incisors and improve its thickness uniformity.

Knowledge of traumatic dental injuries and mouthguard behavior among Croatian soccer players

OBJECTIVES/AIM

Sports-related dental injuries occur frequently among athletes due to inadequate knowledge and prevention measures. The aim of the study was to assess knowledge, attitudes, and practices of active soccer players from all leagues in Croatia regarding traumatic dental injuries and the use of mouthguards.

MATERIAL AND METHODS

393 respondents completed a questionnaire-based online survey from March 2022 to April 2022. The questionnaire consisted of 37 questions divided in four sections: demographic characteristics, experience with orofacial injuries, knowledge of emergency therapeutic procedures for dental injuries, and behaviors related to the use of a mouthguard.

RESULTS

Insufficient knowledge was confirmed by a total score of 2.8 ± 2.8 points, with a possible maximum of 11. Respondents' better knowledge can be associated with educational level (p = .002), playing position (p = .046), and personally experienced injuries to the face and jaw (p ≤ .001) and teeth (p = .022). Less than 40% of respondents suffered facial and jaw injuries while playing football and 18.6% suffered dental injuries. Although most respondents (93.9%) were familiar with mouthguards and 68.9% believed that they help prevent injuries while playing football, only 16% used them.

CONCLUSION

The study revealed significant gaps in knowledge regarding dental injuries and the practice of mouthguard usage among Croatian soccer players. Therefore, it is evident that additional education is needed to prevent dental injuries and take proper procedures when taking care of them among the examined population.

Mouthguards Based on the Shear-Stiffening Effect: Excellent Shock Absorption Ability with Softness Perception

Mouthguards are used to prevent craniomaxillofacial injuries when collisions happen during contact and high-speed sports. However, poor compliance with mouthguard wear in athletes is attributed to discomfort because of its thickness and hardness. These drawbacks significantly restrict their protective performance for oral tissues and applications during contact sports; as a result, the incidence of craniomaxillofacial injuries increases. In this study, non-Newton material is introduced into mouthguard material and then a mouthguard with shear-stiffening behavior is fabricated, which is named the shear-stiffening mouthguard (SSM). Compared with commercial mouthguard materials (Erkoflex and Erkoloc-pro), SSMs show remarkable enhancement of shock absorption ability with an approximately 60% reduction in peak force relative to commercial materials and approximately 3-fold extensive buffer time. Moreover, Young's modulus of SSMs (average 0.48 MPa) is extremely lower compared to commercial materials (22.88 MPa for Erkoflex and 26.71 MPa for Erkoloc-pro). This manifests that SSMs have not only excellent shock absorption ability but also softness perception. Moreover, SSMs show biocompatibility in vitro. In conclusion, this work provides a platform to develop a new type of thin and soft mouthguard with a shear-stiffening effect and broadens the horizon in protecting oral tissues with shear-stiffening materials.

Sports mouthguard overview: Materials, fabrication techniques, existing standards, and future research needs

Sports mouthguards are proven devices that reduce both the probability of and damage to orofacial tissues. While commonly used, clinicians may be unaware of the different sports mouthguard materials, proposed fabrication techniques, design recommendations, and newer digital fabrication methods. An overview of existing sports mouthguard standards is presented. It identifies that identify that the present requirements, while historically chosen in good faith, appear to be arbitrarily selected and not from clinical evidence-based derived data. In addition, identified sports mouthguard heterogeneous testing and data acquisition methods distinguishes that little possibility is afforded for the correlation of results. Furthermore, updated evidence with concussion prevention and/or alleviation is presented with evidence provided by sports mouthguard imbedded technology. The need for continued research is stressed to provide evidence-based data for concussion alleviation/prevention, digital fabrication methods and materials, and clinically based information for the revision of existing standards.

Traumatic Dental Injuries: Clinical Case Presentation and a 10-Year Epidemiological Investigation in an Italian Dental Emergency Service

Traumatic dental injuries (TDIs) are very common in the world population, and international literature reports several studies which helped in the definition of international guidelines. The aim of this study is to present two clinical cases of TDI and to investigate epidemiological and etiological aspects of TDIs in patients treated in Modena, Italy, between January 2010 and December 2020. The presented case reports are two explicative clinical cases of successful TDI management with a long-term follow-up. The epidemiological analysis was performed on patients who visited the Dental Emergency Service of the Dentistry and Oral-Maxillo-Facial Surgery Unit of Modena (Italy) over a period of 10 years. Data relating to age, gender, type of trauma, and place of accident were collected. Five-hundred-sixty-five TDIs that occurred to patients from 1 to 68 years old were reported, with a total of 860 injured teeth. The peak age at which TDIs are most represented varies between 2 and 3 years old, and they occurred frequently from 1 up to 7 years old. 57.5% were male, while 42.5% were female. The most common trauma resulted to be the uncomplicated crown fracture (20%), immediately followed by lateral luxation (19%), intrusive luxation (18%), avulsion (17%), and complicated crown fracture (15%). TDIs occurred at home in 44% of cases. The need for more prevention training must be highlighted, due to the fact that many TDIs occur at home and in a preschool age.