Large motor unit territories by scanning electromyography in patients with juvenile myoclonic epilepsy

Diffusion tensor imaging in photosensitive and nonphotosensitive juvenile myoclonic epilepsy

INTRODUCTION/BACKGROUND

Juvenile myoclonic epilepsy (JME) syndrome is known to cause alterations in brain structure and white matter integrity. The study aimed to determine structural white matter changes in patients with JME and to reveal the differences between the photosensitive (PS) and nonphotosensitive (NPS) subgroups by diffusion tensor imaging (DTI) using the tract-based spatial statistics (TBSS) method.

METHODS

This study included data from 16 PS, 15 NPS patients with JME, and 41 healthy participants. The mean fractional anisotropy (FA) values of these groups were calculated, and comparisons were made via the TBSS method over FA values in the whole-brain and 81 regions of interest (ROI) obtained from the John Hopkins University White Matter Atlas.

RESULTS

In the whole-brain TBSS analysis, no significant differences in FA values were observed in pairwise comparisons of JME patient group and subgroups with healthy controls (HCs) and in comparison between JME subgroups. In ROI-based TBSS analysis, an increase in FA values of right anterior corona radiata and left corticospinal pathways was found in JME patient group compared with HC group. When comparing JME-PS patients with HCs, an FA increase was observed in the bilateral anterior corona radiata region, whereas when comparing JME-NPS patients with HCs, an FA increase was observed in bilateral corticospinal pathway. Moreover, in subgroup comparison, an increase in FA values was noted in corpus callosum genu region in JME-PS compared with JME-NPS.

CONCLUSIONS

Our results support the disruption in thalamofrontal white matter integrity in JME, and subgroups and highlight the importance of using different analysis methods to show the underlying microstructural changes.

Masked least-squares averaging in processing of scanning-EMG recordings with multiple discharges

Removing artifacts from nearby motor units is one of the main objectives when processing scanning-EMG recordings. Methods such as median filtering or masked least-squares smoothing (MLSS) can be used to eliminate artifacts in recordings with just one discharge of the motor unit potential (MUP) at each location. However, more effective artifact removal can be achieved if several discharges per position are recorded. In this case, processing usually involves averaging the discharges available at each position and then applying a median filter in the spatial dimension. The main drawback of this approach is that the median filter tends to distort the signal waveform. In this paper, we present a new algorithm that operates on multiple discharges simultaneously and in the spatial dimension. We refer to this algorithm as the multi-masked least-squares smoothing (MMLSS) algorithm: an extension of the MLSS algorithm for the case of multiple discharges. The algorithm is tested using simulated scanning-EMG signals in different recording conditions, i.e., at different levels of muscle contraction and for different numbers of discharges per position. The results demonstrate that the algorithm eliminates artifacts more effectively than any previously available method and does so without distorting the waveform of the signal. Graphical abstract The raw scanning-EMG signal, which can be composed by several discharges of the MU, is processed by the MMLSS algorithm so as to eliminate the artifact interference. Firstly, artifacts are detected for each discharge from the raw signal, obtaining a multi-discharge validity mask that indicates the samples that have been corrupted by artifacts. Secondly, a least-squares smoothing procedure simultaneously operating in the spatial dimension and among the discharges is applied to the raw signal. This second step is performed using only the not contaminated samples according to the validity mask. The resulting MMLSS-processed scanning-EMG signal is clean of artifact interference.

A masked least-squares smoothing procedure for artifact reduction in scanning-EMG recordings

Scanning-EMG is an electrophysiological technique in which the electrical activity of the motor unit is recorded at multiple points along a corridor crossing the motor unit territory. Correct analysis of the scanning-EMG signal requires prior elimination of interference from nearby motor units. Although the traditional processing based on the median filtering is effective in removing such interference, it distorts the physiological waveform of the scanning-EMG signal. In this study, we describe a new scanning-EMG signal processing algorithm that preserves the physiological signal waveform while effectively removing interference from other motor units. To obtain a cleaned-up version of the scanning signal, the masked least-squares smoothing (MLSS) algorithm recalculates and replaces each sample value of the signal using a least-squares smoothing in the spatial dimension, taking into account the information of only those samples that are not contaminated with activity of other motor units. The performance of the new algorithm with simulated scanning-EMG signals is studied and compared with the performance of the median algorithm and tested with real scanning signals. Results show that the MLSS algorithm distorts the waveform of the scanning-EMG signal much less than the median algorithm (approximately 3.5 dB gain), being at the same time very effective at removing interference components.

Graphical Abstract

Classification of juvenile myoclonic epilepsy data acquired through scanning electromyography with machine learning algorithms

In this paper, classification of Juvenile Myoclonic Epilepsy (JME) patients and healthy volunteers included into Normal Control (NC) groups was established using Feed-Forward Neural Networks (NN), Support Vector Machines (SVM), Decision Trees (DT), and Naïve Bayes (NB) methods by utilizing the data obtained through the scanning EMG method used in a clinical study. An experimental setup was built for this purpose. 105 motor units were measured. 44 of them belonged to JME group consisting of 9 patients and 61 of them belonged to NC group comprising ten healthy volunteers. k-fold cross validation was applied to train and test the models. ROC curves were drawn for k values of 4, 6, 8 and 10. 100% of detection sensitivity was obtained for DT, NN, and NB classification methods. The lowest FP number, which was obtained by NN, was 5.