Attaching Suspension Cells to Slides for Staining

Protocol for cytoskeleton staining of the semi-adherent multiple myeloma cell line RPMI 8226 by immunofluorescence

Preservation of fine cellular details of semi-adherent or suspension cells for imaging by immunofluorescence is challenging. This protocol enables staining of floating cells with minimal morphological distortions, as we demonstrate with the semi-adherent multiple myeloma cell line RPMI 8226. We describe steps to better preserve structural details by fixing, permeabilizing, and staining cells in solution, while minimizing the number of centrifugation steps and centrifugation g-force. For complete details on the use and execution of this protocol, please refer to Osei-Amponsa et al.1.

Cell Staining

When labeled antibodies are used to detect antigens in cells or tissues, several characteristics of an antigen can be readily determined. Most importantly, cell staining will show both the presence and subcellular localization of an antigen. Double-labeling techniques permit the simultaneous detection of two antigens, allowing comparisons of the relative distribution of different antigens. Many cell-staining methods can also be used in conjunction with conventional histological stains and autoradiographic methods to compare the localization of the antigen with other markers. Cell staining can also be used in pathology studies for determining such variables as the type of infectious organism, the progenitor of a neoplastic cell, or the presence of an inflammatory response. With certain modifications, the procedure can be used to purify cells on the basis of the antigenic composition of their cell surface. Cell staining is a versatile technique and, if the antigen is highly localized, can detect as few as a thousand antigen molecules in a cell or tissue. In some circumstances, cell staining may also be used to determine the approximate concentration of an antigen. Improvements in antibody labeling methods, microscopes, cameras, and image analyzers are rapidly extending the sensitivity of cell-staining procedures and are making these techniques more quantitative. Even without these improvements, cell staining can yield important qualitative and semiquantitative data. This introduction describes protocols for cell staining techniques and includes a discussion of major constraints, antibody selection, and troubleshooting.

Poly-l-lysine-caused cell adhesion induces pyroptosis in THP-1 monocytes

Pyroptosis is a kind of cell necrosis mediated by inflammasomes. The caspase 1-induced cleavage of gasdermin D (GSDMD) is a canonical pathway to cause membrane pores and eventually cell pyroptosis. Poly-l-lysine (PLL) is widely used to enhance cell adhesion during experiments. Human THP-1 cells are a typical cell line used to study pyroptosis due to their monocytic and macrophage-like characteristics. However, it was found that THP-1 cells seeded on the PLL-coated slides died. To figure out the reason, we observed the morphology of THP-1 cells on PLL-coated slides, which showed obvious pore forming on the cell membranes and cell swelling. The indicated pyroptosis-related protein expression was evaluated and it showed that the conventional caspase-1 pathway of pyroptosis was activated through the NLRP3 inflammasome in THP-1 monocytes on the PLL-coated slides. Hence, PLL-guided cell adhesion induces cell pyroptosis in THP-1 monocytes, which calls for THP-1 dominant studies of pyroptosis to avoid the use of PLL-coated slides or PLL-related drugs.