Interlayer magnetic coupling: Effect of interface roughness

Interface Structures on Mechanically Polished Surface of Spinel Ferrite and Its Effect on the Magnetic Domains

Soft magnetic spinel ferrites are indispensable parts in devices such as transformers and inductors. Mechanical surface processing is a necessary step to realize certain shapes and surface roughness in producing the ferrite but also has a negative effect on the magnetic properties of the ferrite. In the past few years, a new surface layer was always believed to form during the mechanical surface processing, but the change of atomic structure on the surface and its effect on the magnetic structure remain unclear. Herein, an interface structure consisting of a rock-salt sublayer, distorted NiFe2O4 sublayer, and pristine NiFe2O4 was found to form on mechanically polished single-crystal NiFe2O4 ferrite. Such an interface structure is produced by phase transformation and lattice distortion induced by the mechanical processing. The magnetic domain observation and electrical property measurement also indicate that the magnetic and electrical anisotropy are both enhanced by the interface structure. This work provides deep insight into the surface structure evolution of spinel ferrite by mechanical processing.

Competing exchange interactions in magnetic multilayers

We have studied alloying of the nonmagnetic spacer layer with a magnetic material as a method of tuning the interlayer coupling in magnetic multilayers. We have specifically studied the Fe/V(100) system by alloying the spacer V with various amounts of Fe. For some Fe concentrations in the spacer, it is possible to create a competition between antiferromagnetic Ruderman-Kittel-Kasuya-Yoshida exchange and direct ferromagnetic exchange coupling. The exchange coupling and transport properties for a large span of systems with different spacer concentrations and thicknesses were calculated and measured experimentally and good agreement between observations and theory was observed. A reduction in magnetoresistance of about 50% was observed close to the switchover from antiferromagnetic to ferromagnetic coupling.

On the sharpness of the interfaces in metallic multilayers

We show that the three most relevant magnetic properties (magnetic moment, critical temperature, and interlayer exchange coupling) of metallic multilayers can be reproduced with good accuracy by first principles theory, provided that the picture of atomically sharp interfaces is abandoned and one allows instead for both interface alloying and interface roughness. The interface of a metallic multilayer (exemplified by the Fe/V system) is demonstrated to, at best, have interdiffusion essentially over two to three atomic layers on each side of the interface. Our conclusions are the result of combining experimental work with theoretical modeling, and we argue that this approach is the best avenue to obtain accurate information about the interface quality of metallic multilayers.