Drying-induced stresses in poroelastic drops on rigid substrates

Deposit of Red Blood Cells at low concentrations in evaporating droplets is dominated by a central edge growth

Evaporation of blood droplets and diluted blood samples is a topic of intensive research, as it is considered a potential low-cost diagnostic tool. So far, samples with a volume fraction down to a few percent of red blood cells have been studied, and these were reportedly dominated by a "coffee-ring" deposit. In this study, samples with lower volume fractions were used to investigate the growth of the evaporative deposit from sessile droplets in more detail. We observed that blood samples and salt solutions with less than 1% volume fraction of red blood cells are dominated by a central deposit. We characterized the growth process of this central deposit by evaporating elongated drops and determined that it is consistent with the Kardar-Parisi-Zhang process in the presence of quenched disorder. Our results showed a sensitivity of the deposit size to fibrinogen concentration and the shape of red blood cells, suggesting that this parameter could be developed into a new and cost-effective clinical marker for inflammation and red blood cell deformation.

Crack densification in drying colloidal suspensions

As sessile drops of aqueous colloidal suspensions dry, a close-packed particle deposit forms that grows from the edge of the drop toward the center. To compensate for evaporation over the solid's surface, water flows radially through the deposit, generating a negative pore pressure in the deposit associated with tensile drying stresses that induce the formation of cracks. As these stresses increase during drying, existing cracks propagate and additional cracks form, until the crack density eventually saturates. We rationalize the dynamics of crack propagation and crack densification with a local energy balance between the elastic energy released by the crack, the energetic cost of fracture, and the elastic energy released by previously formed cracks. We show that the final spacing between radial cracks is proportional to the local thickness of the deposit, while the aspect ratio of the crack segments depends on the shape of the deposit.

Directional drying of a colloidal dispersion: quantitative description with water potential measurements using water clusters in a poly(dimethylsiloxane) microfluidic chip

We have developed a poly(dimethylsiloxane) (PDMS) microfluidic chip to study the directional drying of a colloidal dispersion confined in a channel. Our measurements on a dispersion of silica nanoparticles once again revealed the phenomenology commonly observed for such systems: the formation of a porous solid with linear growth in the channel at short times, slowing down at longer times as the evaporation rate decreases. The growth of the solid is also accompanied by mechanical stresses that are released by the delamination of the solid from the channel walls and the formation of cracks. In addition to these observations, we report original measurements using hydrophilic filler in the PDMS formulation used (Sylgard-184). When the PDMS matrix is in contact with water, water molecules pool around these hydrophilic sites, resulting in the formation of microscopic water clusters whose size depends on the water potential ψ. In our work, we have used these water clusters to estimate the water potential profile in the channel as the porous solid grows. Using a transport model that also takes into account solid delamination in the channel, we then linked these water potential measurements to the hydraulic permeability of the porous solid. These measurements finally enabled us to show that the slowdown in the evaporation rate is due to the invasion of the porous solid by air/water nanomenisci at a critical capillary pressure ψcap.