X-ray reflectivity measurements and Landau theory of smectic wetting in liquid crystal-benzyl alcohol mixtures

Semiflexible polymers confined in a slit pore with attractive walls: two-dimensional liquid crystalline order versus capillary nematization

Semiflexible polymers under good solvent conditions interacting with attractive planar surfaces are investigated by Molecular Dynamics (MD) simulations and classical Density Functional Theory (DFT). A bead-spring type potential complemented by a bending potential is used, allowing variation of chain stiffness from completely flexible coils to rod-like polymers whose persistence length by far exceeds their contour length. Solvent is only implicitly included, monomer-monomer interactions being purely repulsive, while two types of attractive wall-monomer interactions are considered: (i) a strongly attractive Mie-type potential, appropriate for a strictly structureless wall, and (ii) a corrugated wall formed by Lennard-Jones particles arranged on a square lattice. It is found that in dilute solutions the former case leads to the formation of a strongly adsorbed surface layer, and the profile of density and orientational order in the z-direction perpendicular to the wall is predicted by DFT in nice agreement with MD. While for very low bulk densities a Kosterlitz-Thouless type transition from the isotropic phase to a phase with power-law decay of nematic correlations is suggested to occur in the strongly adsorbed layer, for larger densities a smectic-C phase in the surface layer is detected. No "capillary nematization" effect at higher bulk densities is found in this system, unlike systems with repulsive walls. This finding is attributed to the reduction of the bulk density (in the center of the slit pore) due to polymer adsorption on the attractive wall, for a system studied in the canonical ensemble. Consequently in a system with two attractive walls nematic order in the slit pore can occur only at a higher density than for a bulk system.

Surface order at surfactant-laden interfaces between isotropic liquid crystals and liquid phases with different polarity

We present an ellipsometry study of the interface between thermotropic liquid crystals and liquid phases consisting of various binary mixtures of water and glycerol. The liquid-crystal samples contain a small constant amount of a surfactant which induces a homeotropic anchoring at the interface. We determine the smectic or nematic order at the interface in the temperature range above the liquid-crystal-isotropic transition while the water to glycerol ratio is varied, corresponding to a systematic modification of the polarity of the liquid phase. The surface-induced order becomes less pronounced with increasing glycerol concentration in the liquid phase. The observed behavior is compared with previous studies in which the surfactant concentration in the liquid-crystal bulk phase was varied. The results indicate that in both cases the magnitude of the surfactant coverage at the interface is the key quantity which determines the liquid-crystal surface order at the interface.

Anisotropic behavior of water in ferroelectric liquid crystals

The outcome of water addition in ferroelectric liquid crystal (FLC) has been investigated in uniform and defect-free homogeneous and homeotropically aligned monodomain sample cells from electro-optical and dielectric spectroscopic measurements. The lagging in optical response between nonconducting (spatially variable switching) and conducting (conventional switching) portions of water added FLC sample cell has been observed by frequency-dependent electro-optical studies. The bias-dependent water related new relaxation peak near the conventional Goldstone mode relaxation process has been observed only in the homogeneous alignment and not in the homeotropic one. Further, the significant increment in dielectric anisotropy as well as faster diffusion of water along long molecular axis than short molecular axis has also been monitored. These studies strongly suggest that the distribution of water is anisotropic in FLC medium and could be the reason for new relaxation peak in the water added FLC sample.

Surface triple points and multiple-layer transitions observed by tuning the surface field at smectic liquid-crystal-water interfaces

We present an ellipsometric study of the interface between a smectic liquid crystal and water in the presence of a nonionic surfactant. The surfactant concentration serves as a handle to tune the surface field. For sufficiently large surfactant concentrations, a smectic phase is present at the interface in the temperature range above the smectic-A-isotropic bulk transition; when the bulk transition is approached, the thickness of this surface phase grows via a series of layer-by-layer transitions at which single smectic layers are formed. At lower surfactant concentrations, transitions appear at which the thickness of the surface phase jumps by multiple smectic layers, thereby implying the existence of triple points at which surface phases with different smectic layer numbers coexist. This is the first experimental demonstration of such surface triple points which are predicted by theoretical models.

Surface freezing of chain molecules at the liquid–liquid and liquid–air interfaces

Surface freezing (SF) is the formation of a crystalline monolayer at the free surface of a melt at a temperature Ts, a few degrees above the bulk freezing temperature, Tb. This effect, i.e. Ts > Tb, common to many chain molecules, is in a marked contrast with the surface melting effect, i.e. Ts < or = Tb, shown by almost all other materials. Depending on chain length, n, the SF layer shows a variety of phases, in some cases tuneable by bulk additives. The SF behaviour of binary mixtures of different-length alkanes and alcohols is governed by the relative chain length mismatch, /delta n/n/2, yielding a quasi-"universal" behaviour for the freezing of both bulk and surface. While SF at the liquid air interface was studied rather extensively, Lei and Bain (Phys. Rev. Lett., 2004, 94, 176103) have shown only very recently that interfacial freezing (IF) can be induced also at the water: tetradecane interface by adding the ionic surfactant CTAB to the water phase. We present measurements of the interfacial tension of the water: hexadecane interface, as a function of temperature and the ionic surfactant STAB, revealing IF at a STAB-concentration-dependent temperature Ti > Tb. The measurements indicate that a single frozen monolayer is formed, with a temperature-existence range of up to 10 degrees C, much larger than the 1.2 degrees C found for SF at the free surface of the melt. We also find a new effect, where the IF allows tuning of the interfacial tension between the two bulk phases to zero for a range of temperatures, deltaT = Tmix - Tb < or = Ti - Tb by cooling the system below Ti. We discuss qualitatively the factors stabilizing the frozen layer and their variation from the liquid-air to the liquid-liquid interfaces. The surfactant concentration dependence of Ti is also discussed and a tentative theoretical explanation is suggested.

Surface ordering above the isotropic-smectic-A transition at a silane-treated substrate

Surface ordering in a homologous series of alkyl cyanobiphenyl (nCB) liquid crystals having a direct isotropic-smectic-A (I-A) transition was investigated using evanescent-wave ellipsometry. The liquid crystal was bounded by a solid substrate treated with a silane surfactant which induced homeotropic (perpendicular) ordering of the liquid crystal molecules in the smectic-A phase. In the isotropic phase, one of the liquid crystals (10CB) partially wet the interface with an orientationally ordered, homeotropically aligned layer. The ordered interfacial layer grew without layering transitions but remained finite in thickness as the bulk I-A transition was approached. The interfacial layer has significantly lower orientational order than is observed in the smectic phase, indicating the possibility that the surface region of 10CB may be in a surface-induced, nonspontaneous nematic phase. The other liquid crystals (11 and 12CB) showed no surface ordering behavior whatsoever. Models describing the ordered surface layer of 10CB are presented. The results can be interpreted as a sharp transition in the surface ordering behavior as the chain length of the liquid crystal is varied, at the I-A transition of a liquid crystal.

X-ray reflectivity study of smectic wetting and prewetting at the free surface of isotropic liquid crystals

We study the structures of free-surface-wetting layers above the isotropic to smectic-A transition of three liquid-crystal compounds that show different kinds of growth of the wetting film as the bulk transition is approached: layer-by-layer, continuous, and continuous with prewetting. The smectic-A surface phase of the layer-by-layer compound consists of well-defined layers and possesses a sharp boundary to the isotropic bulk phase, whereas in the two continuous compounds sinusoidal density oscillations with a continuously decaying amplitude are found. In the continuous case with prewetting, the wetting film below the prewetting transition does not show an essential difference to the continuous case without prewetting.

Wetting behavior above the liquid-crystal-isotropic transition in a homologous series

An ellipsometric study of the wetting behavior at the free surface above the isotropic to nematic or isotropic to smectic-A transition of nine homologous compounds with even alkyl chain lengths n in the range from four to twenty carbon atoms is presented. All compounds show a pretransitional increase of the nematic or smectic surface coverage as the bulk isotropic to liquid-crystal transition is approached from above. The behavior of the nematic compounds (n=4 to 10) can be interpreted, within the framework of a Landau model, as complete wetting. In short nematic homologs the divergence of the nematic coverage is strongly reduced by a decrease of the nematic susceptibility of the isotropic phase. The elastic coefficient L of the Landau model shows a pronounced increase with increasing n, resulting in the occurrence of a discontinuous prewetting transition in the shortest smectic homolog (n=12) that is still describable by the nematic Landau model. In the longer smectic homologs (n=14 to 20), layering steps appear in the pretransitional increase of the coverage. The results indicate probable partial wetting for the longest homolog, whereas for the other smectic compounds the distinction between complete and partial wetting is difficult on the basis of ellipsometry.