Crossover scaling of apparent first-order wetting in two-dimensional systems with short-ranged forces

First-order wedge wetting revisited

We consider a fluid adsorbed in a wedge made from walls that exhibit a first-order wetting transition and revisit the argument as to why and how the pre-filling and pre-wetting coexistence lines merge when the opening angle is increased approaching the planar geometry. We clarify the nature of the possible surface phase diagrams, pointing out the connection with complete pre-wetting, and show that the merging of the coexistence lines lead to new interfacial transitions. These occur along the side walls and are associated with the unbinding of the thin-thick interface, rather than the liquid-gas interface (meniscus), from the wedge apex. When fluctuation effects, together with the influence of dispersion forces are included, these transitions display strong non-universal critical singularities that depend on the opening angle itself. Similar phenomena are also shown to occur for adsorption near an apex tip.

Classical density functional study of wetting transitions on nanopatterned surfaces

Even simple fluids on simple substrates can exhibit very rich surface phase behaviour. To illustrate this, we consider fluid adsorption on a planar wall chemically patterned with a deep stripe of a different material. In this system, two phase transitions compete: unbending and pre-wetting. Using microscopic density-functional theory, we show that, for thin stripes, the lines of these two phase transitions may merge, leading to a new two-dimensional-like wetting transition occurring along the walls. The influence of intermolecular forces and interfacial fluctuations on this phase transition and at complete pre-wetting are considered in detail.

Thermostability analysis of line-tension-associated nucleation at a gas-liquid interface

The influence of line tension on the thermostability of a droplet nucleated from an oversaturated vapor at the interface of the vapor and another immiscible liquid is investigated. Along with the condition of mechanical equilibrium, the notion of extremization of the reversible work of formation is considered to obtain the critical parameters related to heterogeneous nucleation. From the energetic formulation, the critical reversible work of formation is found to be greater than that of homogeneous nucleation for high value of the positive line tension. On the other hand, for high value of the negative line tension, the critical reversible work of formation becomes negative. Therefore, these thermodynamic instabilities under certain substrate wettability situations necessitate a free-energetics-based stability of the nucleated droplet, because the system energy is not minimized under these conditions. This thermostability is analogous to the transition-based stability proposed by Widom [B. Widom, J. Phys. Chem. 99, 2803 (1995)]10.1021/j100009a041 in the case of partial wetting phenomena along with the positive line tension. The thermostability analysis limits the domain of the solution space of the present critical-value problem as the thermodynamic transformation in connection with homogeneous and workless nucleation is considered. Within the stability range of the geometry-based wetting parameters, three limiting modes of nucleation, i.e., total-dewetting-related homogeneous nucleation, and total-wetting-associated and total-submergence-associated workless nucleation scenarios, are identified. Either of the two related limiting wetting scenarios of workless nucleation, namely, total wetting and total submergence, is found to be favorable depending on the geometry-based wetting conditions. The line-tension-associated nucleation on a liquid surface can be differentiated from that on a rigid substrate, as in the former, the stability based on mechanical equilibrium and a typical case of workless nucleation with complete submergence are observed.