Effect of stress nonhomogeneity on the shear melting of a thin boundary lubrication layer

Fluorescence microscopy visualization of the roughness-induced transition between lubrication regimes

We investigate the transition between different regimes of lubrication and directly observe the thickness of nanometric lubrication films with a sensitivity of a single molecular layer at a multi-asperity interface through fluorescence microscopy. We redefine specific film thickness as the ratio of the lubricant film thickness and the surface roughness measured only at those regions of the interface where the gap is "minimal." This novel definition of specific film thickness successfully captures the transition from full elastohydrodynamic lubrication to mixed and boundary lubrication. The transition can be triggered by increasing the surface roughness and is accurately predicted by using the new film thickness definition. We find that when the liquid carries part of the load, its apparent viscosity is greatly increased by confinement, and show how the transition between different lubrication regimes is well described by the viscosity increase and subsequent glass transition in the film.

Stick-slip boundary friction mode as a second-order phase transition with an inhomogeneous distribution of elastic stress in the contact area

This article presents an investigation of the dynamical contact between two atomically flat surfaces separated by an ultrathin lubricant film. Using a thermodynamic approach we describe the second-order phase transition between two structural states of the lubricant which leads to the stick-slip mode of boundary friction. An analytical description and numerical simulation with radial distributions of the order parameter, stress and strain were performed to investigate the spatial inhomogeneity. It is shown that in the case when the driving device is connected to the upper part of the friction block through an elastic spring, the frequency of the melting/solidification phase transitions increases with time.