The time-resolved hard X-ray diffraction endstation KMC-3 XPP at BESSY II

WaveGate: a versatile tool for temporal shaping of synchrotron beams

We present a full performance characterization of a solid state pulse picker for hard x-ray pulses at synchrotrons. The device is called WaveGate. Specifically, we quantify its efficiency (>30 %), timing capabilities (switching times between 100 ns and ms), on-off contrast (>104) and influence on the coherence properties of the incident x-ray beam. In addition, we discuss the implementation of the WaveGate in an optical pump - x-ray probe setup. Even if single pulse selection is performed by external detector gating, the WaveGate drastically increases the efficiency of a measurement. Finally, we introduce advanced timing schemes that can be realized by modulating the time structure of the synchrotron beam.

Concepts and use cases for picosecond ultrasonics with x-rays

This review discusses picosecond ultrasonics experiments using ultrashort hard x-ray probe pulses to extract the transient strain response of laser-excited nanoscopic structures from Bragg-peak shifts. This method provides direct, layer-specific, and quantitative information on the picosecond strain response for structures down to few-nm thickness. We model the transient strain using the elastic wave equation and express the driving stress using Grüneisen parameters stating that the laser-induced stress is proportional to energy density changes in the microscopic subsystems of the solid, i.e., electrons, phonons and spins. The laser-driven strain response can thus serve as an ultrafast proxy for local energy-density and temperature changes, but we emphasize the importance of the nanoscale morphology for an accurate interpretation due to the Poisson effect. The presented experimental use cases encompass ultrathin and opaque metal-heterostructures, continuous and granular nanolayers as well as negative thermal expansion materials, that each pose a challenge to established all-optical techniques.

Piezo-modulated active grating for selecting X-ray pulses separated by one nanosecond

We present a novel method of temporal modulation of X-ray radiation for time resolved experiments. To control the intensity of the X-ray beam, the Bragg reflection of a piezoelectric crystal is modified using comb-shaped electrodes deposited on the crystal surface. Voltage applied to the electrodes induces a periodic deformation of the crystal that acts as a diffraction grating, splitting the original Bragg reflection into several satellites. A pulse of X-rays can be created by rapidly switching the voltage on and off. In our prototype device the duty cycle was limited to ∼1 ns by the driving electronics. The prototype can be used to generate X-ray pulses from a continuous source. It can also be electrically correlated to a synchrotron light source and be activated to transmit only selected synchrotron pulses. Since the device operates in a non-resonant mode, different activation patterns and pulse durations can be achieved.