A novel cost-effective postural tracking algorithm using marker-based video processing

Recently, many postural analysis techniques have been developed in order to reduce the risk of musculoskeletal problems. Methods such as rapid entire body assessment are capable of analyzing the most constant or awkward positions, but the selection of these postures is subjective. To make an objective postural analysis, devices such as electromagnetic trackers can be used continuously during the job task, but utilizing such devices is costly. Therefore, in this study a cost-effective marker-based video processing algorithm is developed for measuring three-dimensional (3D) information regarding both the location and the orientation of human posture. To investigate the precision of the measurements, an experiment was designed. With the average of 2.88 mm and 1.34° for location and orientation, respectively, the algorithm was able to measure six degrees of freedom information regarding 3D space. Furthermore, the precision of the algorithm is found to be significantly affected by the marker pattern.

An Uncontrolled Manifold Analysis of Arm Joint Variability in Virtual Planar Position and Orientation Telemanipulation

OBJECTIVE

In teleoperated robot-assisted tasks, the user interacts with manipulators to finely control remote tools. Manipulation of robotic devices, characterized by specific kinematic and dynamic proprieties, is a complex task for the human sensorimotor system due to the inherent biomechanical and neuronal redundancies that characterize the human arm and its control. We investigate how master devices with different kinematics structures and how different task constraints influence users capabilities in exploiting arm redundancy.

METHODS

A virtual teleoperation workbench was designed and the arm kinematics of seven users was acquired during the execution of two planar virtual tasks, involving either the control of position only or position-orientation of a tool. Using the uncontrolled manifold analysis of arm joint variability, we estimated the logarithmic ratio between the task irrelevant and the task relevant manifolds ( R_v).

RESULTS

The R_v values obtained in the position-orientation task were higher than in the position only task, while no differences were found between the master devices. A modulation of R_v was found through the execution of the position task and a positive correlation was found between task performance and redundancy exploitation.

CONCLUSION

Users exploited additional portions of arm redundancy when dealing with the tool orientation. The R_v modulation seems influenced by the task constraints and by the users possibility of reconfiguring the arm position.

SIGNIFICANCE

This paper advances the general understanding of the exploitation of arm redundancy in complex tasks, and can improve the development of future robotic devices.

On the Value of Estimating Human Arm Stiffness during Virtual Teleoperation with Robotic Manipulators

Teleoperated robotic systems are widely spreading in multiple different fields, from hazardous environments exploration to surgery. In teleoperation, users directly manipulate a master device to achieve task execution at the slave robot side; this interaction is fundamental to guarantee both system stability and task execution performance. In this work, we propose a non-disruptive method to study the arm endpoint stiffness. We evaluate how users exploit the kinetic redundancy of the arm to achieve stability and precision during the execution of different tasks with different master devices. Four users were asked to perform two planar trajectories following virtual tasks using both a serial and a parallel link master device. Users' arm kinematics and muscular activation were acquired and combined with a user-specific musculoskeletal model to estimate the joint stiffness. Using the arm kinematic Jacobian, the arm end-point stiffness was derived. The proposed non-disruptive method is capable of estimating the arm endpoint stiffness during the execution of virtual teleoperated tasks. The obtained results are in accordance with the existing literature in human motor control and show, throughout the tested trajectory, a modulation of the arm endpoint stiffness that is affected by task characteristics and hand speed and acceleration.