A Double-Side CMOS-CNT Biosensor Array With Padless Structure for Simple Bare-Die Measurements in a Medical Environment

Wireless Power Harvesting During MRI

We present methods to harvest wireless power directly from the MRI RF field. The system includes a harvester coil to capture RF energy and an RF-DC converter for rectification. Energy harvesting by the harvester coil is modeled as a function of the MRI B₁ RF field. Rectification is modeled using power-dependent large signal S-parameter simulation. A novel reference impedance-based modeling approach is leveraged to cascade models for linear inductive coupling and nonlinear diode rectification, and validated. The method permits independent optimization of harvester coils and RF-DC converters to maximize harvesting efficiency. Feasibility of this technique is demonstrated by implementing concurrent in-bore wireless power harvesting and MRI scanning on a clinical system. The effect of artifacts on image quality is also investigated.Clinical Relevance- In-bore wireless harvesting can provide power for medical accessories during MRI, with minimal system modification and cost.

Evaluation of Surface Cleaning Procedures in Terms of Gas Sensing Properties of Spray-Deposited CNT Film: Thermal- and O₂ Plasma Treatments

The effect of cleaning the surface of single-walled carbon nanotube (SWNT) networks by thermal and the O₂ plasma treatments is presented in terms of NH₃ gas sensing characteristics. The goal of this work is to determine the relationship between the physicochemical properties of the cleaned surface (including the chemical composition, crystal structure, hydrophilicity, and impurity content) and the sensitivity of the SWNT network films to NH₃ gas. The SWNT networks are spray-deposited on pre-patterned Pt electrodes, and are further functionalized by heating on a programmable hot plate or by O₂ plasma treatment in a laboratory-prepared plasma chamber. Cyclic voltammetry was employed to semi-quantitatively evaluate each surface state of various plasma-treated SWNT-based electrodes. The results show that O₂ plasma treatment can more effectively modify the SWNT network surface than thermal cleaning, and can provide a better conductive network surface due to the larger number of carbonyl/carboxyl groups, enabling a faster electron transfer rate, even though both the thermal cleaning and the O₂ plasma cleaning methods can eliminate the organic solvent residues from the network surface. The NH₃ sensors based on the O₂ plasma-treated SWNT network exhibit higher sensitivity, shorter response time, and better recovery of the initial resistance than those prepared employing the thermally-cleaned SWNT networks.