A Biomimetic Circuit for Electronic Skin With Application in Hand Prosthesis

The neurophysiology of sensorimotor prosthetic control

Movement is a central behavior of daily living; thus lost or compromised movement due to disease, injury, or amputation causes enormous loss of productivity and quality of life. While prosthetics have evolved enormously over the years, restoring natural sensorimotor (SM) control via a prosthesis is a difficult problem which neuroengineering has yet to solve. With a focus on upper limb prosthetics, this perspective article discusses the neurophysiology of motor control under healthy conditions and after amputation, the development of upper limb prostheses from early generations to current state-of-the art sensorimotor neuroprostheses, and how postinjury changes could complicate prosthetic control. Current challenges and future development of smart sensorimotor neuroprostheses are also discussed.

Simulation Analysis of a Sandwich Cantilever Ultrasonic Motor for a Dexterous Prosthetic Hand

Currently, the driving motor used in a dexterous prosthetic hand is limited by the driving principle, and it has the characteristics of a complex structure, slow response, low positioning accuracy, and excessive volume. There are special requirements in terms of quality and quality, and traditional motor drives have greatly affected the progress of prosthetic robots. A motor (ultrasonic motor) has been developed over more than 30 years. It has the advantages of a small size, small mass, simple structure, accurate positioning, high power density, and fast response time, which is enough to improve the driving mechanism performance of the prosthetic hand with a connecting rod. In this paper, the structural characteristics of the prosthetic hand will be analyzed, and the modal analysis, harmonic response analysis, and transient analysis simulation of the longitudinal vibration linear motor stator used in the prosthetic hand with a connecting rod will be carried out in order to provide preliminary preparation for the feasible design and manufacture of the size of the ultrasonic driver structure used for the prosthetic hand with a connecting rod.

A flexible wearable e-skin sensing system for robotic teleoperation

Electronic skin (e-skin) is playing an increasingly important role in health detection, robotic teleoperation, and human-machine interaction, but most e-skins currently lack the integration of on-site signal acquisition and transmission modules. In this paper, we develop a novel flexible wearable e-skin sensing system with 11 sensing channels for robotic teleoperation. The designed sensing system is mainly composed of three components: e-skin sensor, customized flexible printed circuit (FPC), and human-machine interface. The e-skin sensor has 10 stretchable resistors distributed at the proximal and metacarpal joints of each finger respectively and 1 stretchable resistor distributed at the purlicue. The e-skin sensor can be attached to the opisthenar, and thanks to its stretchability, the sensor can detect the bent angle of the finger. The customized FPC, with WiFi module, wirelessly transmits the signal to the terminal device with human-machine interface, and we design a graphical user interface based on the Qt framework for real-time signal acquisition, storage, and display. Based on this developed e-skin system and self-developed robotic multi-fingered hand, we conduct gesture recognition and robotic multi-fingered teleoperation experiments using deep learning techniques and obtain a recognition accuracy of 91.22%. The results demonstrate that the developed e-skin sensing system has great potential in human-machine interaction.