Dual Orientation 16-MHz Single-Element Ultrasound Needle Transducers for Image-Guided Neurosurgical Intervention

Miniaturized ultrasound detector arrays in silicon photonics using pulse transmission amplitude monitoring

Silicon photonics holds promise for a new generation of ultrasound-detection technology, based on optical resonators, with unparalleled miniaturization levels, sensitivities, and bandwidths, creating new possibilities for minimally invasive medical devices. While existing fabrication technologies are capable of producing dense resonator arrays whose resonance frequency is pressure sensitive, simultaneously monitoring the ultrasound-induced frequency modulation of numerous resonators has remained a challenge. Conventional techniques, which are based on tuning a continuous wave laser to the resonator wavelength, are not scalable due to the wavelength disparity between the resonators, requiring a separate laser for each resonator. In this work, we show that the Q-factor and transmission peak of silicon-based resonators can also be pressure sensitive, exploit this phenomenon to develop a readout scheme based on monitoring the amplitude, rather than frequency, at the output of the resonators using a single-pulse source, and demonstrate its compatibility with optoacoustic tomography.

Development of Multi-Layer Lateral-Mode Ultrasound Needle Transducer for Brain Stimulation in Mice

Ultrasound, a non-invasive stimulation method, has proved effective in neurostimulation. Previous studies have demonstrated that low-frequency ultrasound (less than 1 MHz) is preferable owing to better penetrability through tissue and skull. However, the large size of low-frequency transducers, which are used in ultrasound neurostimulation studies, makes it difficult to perform multiple-target neurostimulation, especially in small animals such as mice. In this paper, a proposed low-frequency ultrasound needle transducer based on the multi-layer lateral-mode coupling method with a miniature aperture of 0.6 mm × 0.6 mm and a thickness of 1.65 mm was designed and fabricated. The measured electrical impedance of the fabricated 8-layer lateral-mode PZT-5H ceramic was 50.76 Ω at a resonant frequency of 866 kHz. The -6 dB bandwidth of 8-layer lateral-mode transducer was 29% at a center frequency of 876 kHz. The maximum ultrasound peak pressure amplitude at 820 kHz reached approximately 300 kPa, 4-5 times higher than that of the single-layer thickness-mode transducer with 200 V input voltage. The ultrasound beam showed no attenuation and low shift through mouse skull. To verify the feasibility of using the needle transducer to perform multiple-target nerve stimulation in mice brains, we constructed an ultrasound stimulus system to simultaneously stimulate two areas (M2 and V1) of the mouse brain in vivo and detected the c-Fos expression by immunofluorescence to evaluate the effect of stimulation. The results showed that a high ultrasound peak pressure amplitude with this transducer configuration is useful for ultrasound neurostimulation and multiple-target stimulation in mice.

High-Performance Ultrasound Needle Transducer Based on Modified PMN-PT Ceramic With Ultrahigh Clamped Dielectric Permittivity

A modified Pb(Mg_1/3Nb_2/3)O₃-PbTiO₃ (PMN-PT) polycrystalline ceramic with ultrahigh relative clamped dielectric permittivity ( ) and high piezoelectric properties ( pC/N, ) was used to fabricate high-frequency miniature ultrasound transducers. A 39-MHz high-frequency ultrasound needle transducer with a miniature aperture of 0.4 mm mm was designed and successfully characterized. The fabricated needle transducer had an electromechanical coupling factor of 0.55, large bandwidth of 80% at -6 dB, and low insertion loss of -13 dB. A wire phantom and porcine eyeball imaging study showed good imaging capability of this needle transducer. The transducer performance was found to be superior to that of other needle transducers with miniature apertures, making this modified PMN-PT ceramic-based needle transducer quite promising for minimally invasive procedures in medical applications.