Kinetic description of heat-induced cross-linking reactions of whey protein-free casein solutions

Investigation of the flowability, thermal stability and emulsification properties of two milk protein concentrates having different levels of native whey proteins

Milk protein concentrate-85 (MPC85) is a dairy ingredient which has a diverse range of applications in food products. The technofunctional properties of two MPC85 samples having similar gross composition but different levels of native whey protein (WP), i.e., MPC85S1 and MPC85S2 with 16.6 and 6.0 g native WP/100 g protein, respectively, were compared. Rheometeric analysis showed that under an applied normal stress of 1.0-15.0 kPa, the compressibility, the air permeability and the cohesiveness of MPC85S2 was higher compared to MPC85S1. Differential scanning calorimetry showed that protein denaturation in MPC85S1 began at 63 °C while for MPC85S2 it began at 70 °C. The heat coagulation time (HCT at 140 °C) for 4.2% (w/v, on a protein basis) reconstituted MPC85S1 and MPC85S2 was 2.2 and 2.7 min, respectively. While a higher lightness for MPC85S1 was evidenced using colourimeter analysis, the colour stability on oven drying at 95 °C for MPC85S2 was higher than MPC85S1. The emulsion produced with MPC85S1 flocculated after 1 d and phase separation occurred after 14 d. In the case of MPC85S2, flocculation began after 4 d while phase separation was observed at 33 d. The viscosity of MPC85S2 (4.2% (w/v) protein) was higher than MPC85S1. This study showed differences between the flowability, viscosity, colour properties, thermal stability (in powder and in reconstituted format), emulsification and buffering capacity for MPC samples having two different levels of WP denaturation. The results demonstrated that the MPCs studied having two different levels of WP denaturation could be targeted for different functional applications. The minimal/maximum level of denaturation required to induce technofunctional property differences requires further study.

Invited review: Heat stability of milk and concentrated milk: Past, present, and future research objectives

The ability of milk and concentrated milk to withstand a defined heat treatment without noticeable changes such as flocculation of protein is commonly denoted as heat stability. A heat treatment that exceeds the heat stability limit of milk or concentrated milk, which has a much lower heat stability, may result in undesired changes, such as separation of milk fat, grittiness, sediment formation, and phase separation. Most laboratory-scale batch heating methods were developed in the early 20th century to simulate commercial sterilization, and these methods have since been standardized. Heat stability studies have been motivated by different objectives during that time, addressing different processing issues and targets in the framework of available technology, legislation, and consumer demand. Although milk hygiene has improved during the last couple of decades, rendering milk less sensitive to coagulation, different standard methods suffered from poor comparability of results, even when comparing results for the same milk sample, indicating that unknown procedural steps affect heat stability. The prediction of heat stability of concentrated milk from the heat stability results of the corresponding unconcentrated milk for rapid quality testing purposes has been difficult, mainly due to different experimental conditions. The objective of this study is to review literature on heat stability, starting from studies in the early 20th century, to summarize the vast number of studies on compositional aspects of milk affecting heat stability, and to lead the way to the most recent work related to compositional changes in concentrates produced by membrane concentration and fractionation, respectively. Particular attention is paid to early and most recent developments and findings, such as the application of kinetic models to predict and limit protein aggregation to assess and describe heat stability as a temperature-time-total milk solids continuum.