Study of macromolecular interactions in low-fat brined cheese modified with Zedu gum

Properties of lime peel pectin as mainly influenced by ethanol and protein-based purification methods

BACKGROUND

Lime peel, obtained from juice factory waste, is considered as a source of pectin. Lime peel pectin samples, extracted by three extraction procedures of 90 °C heating for 120 min, 90 °C heating for 90 min and then 32 min of ultrasound, and 80 °C heating for 60 min and then 22 min of ultrasound, and purified by two methods using ethanol and sodium caseinate (SC), were prepared and characterized.

RESULTS

The results showed that the purification method significantly affected the lime pectin samples properties. Pectin samples purified with SC had a transparent and film-like appearance, whereas the ethanol-purified pectin samples showed an amorphous and opaque appearance. Pectin samples purified with ethanol showed higher extraction recovery (approximately 20%), whereas the lowest pectin yield was observed for the purification with SC (approximately 10%). Although SC purification did not enhance the pectin yield, it diminished the level of 'non-pectin' components and resulted in purer pectin. The bands at 1045-1076 cm-1 , relating to neutral sugars, had higher intensities in ethanol-purified pectin samples, indicating their higher sugar contents. Also the samples purified with SC exhibited more thermal stability, probably as a result of the presence of protein in their structure.

CONCLUSION

In the present study, under the same or varying extraction conditions, the most important element distinguishing pectins in terms of appearance, physicochemical, thermal and Fourier transform infrared characteristics was the type of purification method. Purification with SC may result in pectins with more non-esterified galacturonic acids from the homogalacturonan fraction. © 2023 Society of Chemical Industry.

FT-MIR Analysis of Water-Soluble Extracts during the Ripening of Sheep Milk Cheese with Different Phospholipid Content

The purpose of this work was to study the suitability of the water-soluble extracts (WSE) of semi-hard sheep milk cheese for analysis by diffuse reflectance Fourier transform mid-infrared spectroscopy (FT-MIR) and the development of classification models using discriminant analysis and based on cheese age or phospholipid content. WSE was extracted from three types of sheep milk cheeses (full-fat, reduced-fat and reduced-fat fortified with lyophilized sweet sheep buttermilk) at various stages of ripening from six to 168 days and lyophilized. The first model used 1854–1381 and 1192–760 cm−1 regions of the first-derivative spectra and successfully differentiated samples of different age, based on changes in the water-soluble products of ripening biochemical events. The second model used the phospholipid absorbance spectral regions (3012–2851, 1854–1611 and 1192–909 cm−1) to successfully discriminate cheeses of markedly different phospholipid content. Cheese WSE was found suitable for FT-MIR analysis. According to the results, a fast and simple method to monitor cheese ripening based on water-soluble substances has been developed. Additionally, the results indicated that a considerable amount of phospholipids migrates to the cheese WSE and that FT-MIR can be a useful tool for their assessment.