Evaluation of structural and physicochemical properties of octenyl succinic anhydride modified sweet potato starch with different degrees of substitution

Enhanced barrier properties in sweet potato starch films via dual modification by octenyl succinylation and heat moisture treatment for use as plant-based sausage casings

This study assesses the impact of dual modification [octenyl succinylation (OSA) and heat-moisture treatment (HMT)] of sweet potato starch (SPS) on the physicochemical, mechanical, and permeability properties of SPS film. The intrinsic limitations of starch films, such as sensitivity to high humidity, inferior mechanical properties, and weak barrier capabilities, have restricted their use in sausage casings. Nonetheless, the dual-modified SPS film (OSA@HMT-SPS film) demonstrated significantly reduced solubility (P < 0.05), moisture content, water vapor permeability (WVP), and O2 permeability compared to the SPS film. Furthermore, its flexibility and elasticity, indicated by its elongation at break, was notably superior. When used as sausage casings, the OSA@HMT-SPS film effectively mitigated lipid oxidation in sausages better than both the SPS film and commercial collagen casings, owing to its low O2 permeability. As a result, the OSA@HMT-SPS casing presents significant promise as a plant-based sausage casing alternative.

Preparation, characterization and in vitro digestion of octenyl succinic anhydride-modified porous starch with different degrees of substitution

Octenyl succinic anhydride modified porous starch (OSA-PS) with degrees of substitution (DS) from 0.0123 to 0.0427 were prepared by aqueous phase method. From SEM, PS had a porous structure which showed a rough and corrosive surface after esterification with OSA. FT-IR revealed the characteristic peaks of OSA-PS at 1725 cm-1 and 1570 cm-1. From 1H NMR spectra, OSA-PS displayed extra chemical signal peaks at 0.85 ppm, 1.25 ppm and 1.96 ppm. These results fully demonstrated that OSA groups were successfully grafted onto PS. Furthermore, as DS increased, the specific surface area (5.6464 m2/g), pore volume (0.9959 × 10-2 cm3/g) and methylene blue adsorption capacity (24.3962 mg/g) of OSA-PS reached the maximum, while its relative crystallinity (26.8112 %) and maximum thermal decomposition temperature (291.96 °C) were the minimum. In vitro digestion studies showed that with the increase of DS, OSA-PS' contents of rapidly digestible starch and slowly digestible starch decreased from 9.06 % to 6.27 % and 28.38 % to 14.61 %, respectively. In contrast, its resistant starch had an increase in content from 62.56 % to 79.12%. The results provided an effective method for obtaining a double-modified starch with high specific surface area and anti-digestibility, thus broadening the industrial application of starch.

Enhanced Bioaccessibility of Microencapsulated Puerarin Delivered by Pickering Emulsions Stabilized with OSA-Modified Hydrolyzed Pueraria montana Starch: In Vitro Release, Storage Stability, and Physicochemical Properties

Puerarin is a bioactive flavonoid isolated from Kudzu roots that possesses numerous health benefits. However, its poor bioavailability and existing complex delivery systems with safety issues are challenging tasks for its incorporation into functional foods. Preparing modified-starch-stabilized Pickering emulsions containing microencapsulated puerarin with improved bioaccessibility was the key objective of the present research work. Acid-hydrolyzed high-amylose Pueraria montana starch (PMS) was modified with octenyl succinic anhydride (OSA) and evaluated as an emulsifier to prepare emulsions. The FTIR, SEM, and XRD results showed that PMS was successfully modified. Furthermore, the emulsification index (EI), mean droplet size, and ζ-potential values showed that modified starch with a higher degree of substitution (DS) enhanced the storage stability of emulsions. Similarly, the retention degree and encapsulation efficiency results of puerarin proved the assumption after storage of 16 d. The Pickering emulsions also helped in the controlled release of microencapsulated puerarin in vitro. The study outcomes proved that Pickering emulsions stabilized with OSA-modified PMS have promising applicability in functional foods as efficient food-grade delivery systems, enhancing oral supplementation and accessibility of puerarin.

Study of Changes in Crystallinity and Functional Properties of Modified Sago Starch (Metroxylon sp.) Using Physical and Chemical Treatment

Sago starch has weaknesses such as low thermal stability and high syneresis. Modifications were made to improve the characteristics of native sago starch. In this study, sago starch was modified by autoclave-heating treatment (AHT), osmotic-pressure treatment (OPT), octenyl-succinic anhydride modification (OSA), and citric acid cross-linking (CA). This study aimed to examine the changes in chemical composition, crystallinity, and functional properties of the native sago starch after physical and chemical modifications. The results show that physical modification caused greater granule damage than chemical modification. All modification treatments did not alter the type of crystallinity but decreased the relative crystallinity of native starch. New functional groups were formed in chemically modified starches at a wavelength of 1700-1725 cm-1. The degree of order (DO) and degree of double helix (DD) of the modified starches were also not significantly different from the native sample, except for AHT and OPT, respectively. Physical modification decreased the swelling volume, while chemical modification increased its value and is inversely proportional to solubility. AHT and OPT starches have the best freeze-thaw stability among others, indicating that both starches have the potential to be applied in frozen food.

Wheat Starch Modified with Ligustrum robustum (Rxob.) Blume Extract and Its Action Mechanism

We investigated the modification of wheat starch with Ligustrum robustum (Rxob.) Blume extract (LRE) and determined the action mechanism. Based on differential scanning calorimetry, LRE decreased the gelatinization enthalpy of wheat starch from 19.14 to 7.15 J/g and changed gelatinization temperatures (including the variation in gelatinization onset temperature, peak temperature and conclusion temperature in different degrees). Moreover, LRE affected the pasting viscosity curve of wheat starch, and changed its rheological parameters (including the decrease in storage modulus and loss modulus, as well as the increase in loss tangent). Based on the analysis of scanning electron microscopy and wide-angle X-ray diffraction, LRE increased the hole size and the roughness of the gel microstructure, and decreased the crystallinity of wheat starch. Meanwhile, the evaluation results of the texture analyzer and the colorimeter showed that LRE could change the quality properties (including decrease hardness, fracturability and L* values, as well as increase a* and b* values) of wheat starch biscuits after hot air baking (170 °C). Furthermore, with molecular dynamics simulation analysis, phenolic compounds of LRE combined with starch molecules via H-bonds and affected the formation of molecular bonds (including intra- and intermolecular hydrogen bonds), so as to change the spatial conformation and properties of wheat starch during gelatinization and retrogradation. The present results suggest that LRE can modify the physicochemical properties of wheat starch and further improve its processing properties, indicating its potential in the design and development of starch foods (such as steamed buns, bread, biscuits, etc.).

Preparation and characterization of octenyl succinic anhydride-modified ginkgo seed starch with enhanced physicochemical and emulsifying properties

A quick preparation of octenylsuccinylated (OS)-ginkgo seed starch was proposed by lipase-coupling esterification within 30 min, and the physicochemical and emulsifying properties of OS-ginkgo seed starch were evaluated. High-performance liquid chromatography results revealed that ginkgolic acid in ginkgo seed starch was too low to be detected, which improved the biosafety and application range of OS-ginkgo seed starch. The degree of substitution (DS) of OS-ginkgo starch varied from 0.006 to 0.0169 depending on the lipase concentration increased from 0% to 1% (w/w, based on the volume of starch solution), and the reaction efficiency obtained the highest value of 68.5% at the lipase concentration of 1%. Fourier transform infrared spectra of OS-ginkgo seed starch confirmed ester carbonyl splicing in the starch molecular with the characteristic peaks at 1722 and 1567 cm^-1 . Scanning electron microscopy observations revealed that the esterification occurred mainly in the amorphous regions with slight morphological modification. X-ray diffractions suggested that no crystal change occurred on the starch granule. The thermal analysis revealed that OS-ginkgo seed starch showed a lower temperature and endothermic enthalpy for gelatinization, and presented enhanced and DS-dependent emulsifying properties and in vitro antidigestion properties. PRACTICAL APPLICATION: Results indicated that OS-ginkgo seed starch prepared by lipase-coupling esterification would be an alternative emulsion stabilizer for encapsulation and delivery of hydrophobic components. This study would provide an alternative method for the efficient and economical production of OS-ginkgo seed starch, thereby broadening its application in commercial exploitation.

Revealing substitution priority and pattern of octenylsuccinic groups along the starch chain under a continuous mode

Octenylsuccinic (OS) groups distribution was considered random under traditional batch mode (BM) process due to excessive available octenyl succinic anhydride (OSA) at early stage, making the functionality optimization of OSA starch under restricted substitution degree (DS) difficult. To reveal the priority rule of substituent position at starch molecular level, a continuous mode (CM, dropwise OSA addition) was applied for OSA starch preparation. Initial OSA substitution was predominately at the branching points of amylopectin backbone, then successive at the branching points of shorter and longer chains with increasing DS. As DS increased over 1.49%, substitution started occurring along the chains and moved towards the non-reducing ends until DS reached 6.65%. At similar DS, more branching point substitutions occurred at CM starch, showing superior emulsifying property over BM starch. OSA substitution priority rule does exist under controlled OSA supply, which would facilitate OSA starch design with specific substitution pattern and favored functionality.