Treatment preferences for deep caries lesions among Australian dentists

The management of deep carious lesions and the exposed pulp in fully developed and immature teeth with irreversible pulpitis: a questionnaire-based study among Greek dentists

OBJECTIVES

The study aimed to identify the preferred management techniques used by dentists in Greece for treating deep carious lesions or pulp exposure during the removal of carious tissue in teeth with irreversible pulpitis. Additionally, the study sought to explore how patient-related factors (such as age and symptoms) and operator-related factors (like material choice and the use of antibiotics) influence these management decisions.

MATERIALS AND METHODS

The questionnaire, developed by five investigators, was divided into two parts: the first gathered respondent demographics, and the second presented clinical scenarios of deep carious lesions, requesting treatment strategies, materials used, and antibiotic prescription practices. The scenarios described patients with intense spontaneous pain and very deep carious lesions, differentiated by age and tooth development status.Data collection was via Google Drive, with analysis performed using SPSS 28, Chi-square, and Fisher's exact tests, with significance set at p < 0.05.

RESULTS

The study polled 453 Greek dentists about their treatment choices, for deep carious lesions in mature and immature teeth with irreversible pulpitis The majority favored root canal treatment for mature teeth, however quite a few opted for partial or cervical pulpotomy. MTA emerged as the preferred capping material, emphasizing its biocompatibility. Hemostasis management varied, with saline and sodium hypochlorite as popular choices. In cases of immature teeth, a shift towards vital pulp therapy was evident, reflecting a preference for preserving healthy pulp to avoid complex procedures.

CONCLUSIONS

Challenges identified include varying treatment preferences, the significance of bleeding control in vital pulp therapy, and the limited use of antibiotics for irreversible pulpitis. While the study has limitations, including sample size and potential biases, its findings offer valuable insights into the decision-making processes of Greek dentists.

CLINICAL RELEVANCE

Future research and ongoing education within the dental community could contribute to standardizing treatment approaches and optimizing outcomes for patients with deep carious lesions and irreversible pulpitis.

Assessment of Mechanical/Chemical Properties and Cytotoxicity of Resin-Modified Glass Ionomer Cements Containing Sr/F-Bioactive Glass Nanoparticles and Methacrylate Functionalized Polyacids

This study prepared low-toxicity, elemental-releasing resin-modified glass ionomer cements (RMGICs). The effect of 2-hydroxyethyl methacrylate (HEMA, 0 or 5 wt%) and Sr/F-bioactive glass nanoparticles (Sr/F-BGNPs, 5 or 10 wt%) on chemical/mechanical properties and cytotoxicity were examined. Commercial RMGIC (Vitrebond, VB) and calcium silicate cement (Theracal LC, TC) were used as comparisons. Adding HEMA and increasing Sr/F-BGNPs concentration decreased monomer conversion and enhanced elemental release but without significant effect on cytotoxicity. Rising Sr/F-BGNPs reduced the strength of the materials. The degree of monomer conversion of VB (96%) was much higher than that of the experimental RMGICs (21-51%) and TC (28%). The highest biaxial flexural strength of experimental materials (31 MPa) was significantly lower than VB (46 MPa) (p < 0.01) but higher than TC (24 MPa). The RMGICs with 5 wt% HEMA showed higher cumulative fluoride release (137 ppm) than VB (88 ppm) (p < 0.01). Unlike VB, all experimental RMGICs showed Ca, P, and Sr release. Cell viability in the presence of extracts from experimental RMGICs (89-98%) and TC (93%) was significantly higher than for VB (4%). Experimental RMGICs showed desirable physical/mechanical properties with lower toxicity than the commercial material.

In vitro investigation of the impact of contemporary restorative materials on cariogenic bacteria counts and gene expression

OBJECTIVES

The aim of this study was to compare the antibacterial effect of different fluoride-containing and bioactive restorative materials, and their effect on the expression of specific biofilm-associated genes and therefore the caries process.

MATERIALS AND METHODS

The restorative materials utilized in this study included: 1. Filtek Z250, 2. Fuji II LC, 3. Beautifil II, 4. ACTIVA, and 5. Biodentine. For each material, disc-shaped specimens were prepared. The inhibitory effects against Streptococcus mutans, Lactobacillus acidophilus, and Leptotrichia shahii were tested. After incubation for 24 hours and 1 week, colony-forming units (CFUs) were enumerated. From the plates dedicated for biomass quantification and RNA purification, the target glucosyltransferase B (gtfB) and glucan-binding protein B (gbpB) genes were chosen for S. mutans. For L. acidophilus, a gene involved in exopolysaccharide synthesis (epsB) was chosen.

RESULTS

Except for Filtek Z250, all four materials showed statistically significant inhibitory effects on the biofilms of all three species. When biofilms were grown in the presence of the same four materials, the expression of S. mutans gtfB and gbpB genes, was significantly reduced. For L. acidophilus, the decrease in the expression of gtfB gene in the presence of ACTIVA was the highest change seen. The epsB gene expression also decreased. Compared to fluoride-releasing materials, bioactive materials had more inhibitory effect against L. acidophilus, both at 24 hours and 1 week.

CONCLUSIONS

Both fluoride releasing and bioactive materials exhibited a significant inhibitory effect on the biofilm growth. The expression of the targeted biofilm-associated genes was downregulated by both material groups.

CLINICAL SIGNIFICANCE

The findings from this study give insight into the antibacterial effect of fluoride-containing and bioactive materials which would help to reduce the chances for secondary caries and therefore increase the lifetime of dental restorations placed for patients.

Monomer Conversion, Dimensional Stability, Biaxial Flexural Strength, Ion Release, and Cytotoxicity of Resin-Modified Glass Ionomer Cements Containing Methacrylate-Functionalized Polyacids and Spherical Pre-Reacted Glass Fillers

The aim of this study was to prepare RMGICs for pulp protection that contain polyacids functionalized with methacrylate groups (CMs) to enable light-activated polymerization without the need for toxic 2-hydroxyethyl methacrylate (HEMA) monomers. The effects of using CM liquids with 0 or 5 wt% HEMA on the physical/mechanical properties and cytotoxicity of the experimental RMGICs were assessed. Spherical pre-reacted glass fillers (SPG) were used as the powder phase. The experimental RMGICs were prepared by mixing SPG with CM liquid (0 wt% HEMA, F1) or CMH liquid (5 wt% HEMA, F2). Commercial materials (Vitrebond, VB; TheraCal LC, TC) were used for the comparisons. The degree of monomer conversion and fluoride release of both F1 and F2 were significantly lower than those of VB. F1 showed comparable biaxial flexural strength with VB but higher strength than TC. The dimensional stability (mass/volume changes) of the experimental materials was comparable with that of the commercial materials. F1 and F2 exhibited higher Sr/Ca ion release and relative cell viability than VB. The use of CMH liquid reduced the strength but enhanced the fluoride release of the experimental RMGICs. In conclusion, the experimental RMGICs showed comparable strength but lower cytotoxicity compared to the commercial RMGICs. These novel materials could be used as alternative materials for pulp protection.

Rheological Properties, Surface Microhardness, and Dentin Shear Bond Strength of Resin-Modified Glass Ionomer Cements Containing Methacrylate-Functionalized Polyacids and Spherical Pre-Reacted Glass Fillers

The aim of this study was to prepare experimental resin-modified glass ionomer cements (RMGICs) containing low levels of hydroxyethyl methacrylate (HEMA) for pulp protection. Liquid and powder phases of the experimental RMGICs were polyacid functionalized with methacrylate groups and spherical pre-reacted glass fillers (SPG). Two types of liquid phase containing 0 wt. % HEMA (CM liquid) or 5 wt. % HEMA (CMH liquid) were formulated. The experimental RMGICs were prepared by mixing SPG fillers with CM liquid (F1) or CMH liquid (F2). Rheological properties were examined using a strain-controlled rheometer (n = 5). The Vickers microhardness (n = 5) and dentin shear bond strength (SBS) (n = 10) of the materials were tested. Commercial pulp protection materials (Vitrebond and TheraCal LC) were used as comparisons. The viscosity and surface microhardness of F1 (22 m Pa·s, 18 VHN) and F2 (18 m Pa·s, 16 VHN) were significantly higher than those of Vitrebond (6 mPa·s, 6 VHN) and TheraCal (0.1 mPa·s, 7 VHN). The SBS of F1 (10.7 MPa) and F2 (11.9 MPa) was comparable to that of Vitrebond (15.4 MPa) but higher than that of TheraCal LC (5.6 MPa). The addition of 5 wt. % HEMA showed no significant effect on viscosity, surface microhardness, or SBS of the experimental RMGICs. The experimental materials showed higher viscosity and microhardness but similar SBS when compared with the commercial RMGIC.

Deep carious lesions management in children and adolescents: a questionnaire survey among dentists practicing paediatric dentistry in France

INTRODUCTION

While many questionnaire surveys have been undertaken worldwide to investigate practices toward deep carious lesion (DCL) management in adults, very few are related to children and adolescents. The present cross-sectional study aimed to assess DCL management in children and adolescents among dentists practicing paediatric dentistry in France (Fr-DPPDs). The secondary objective was to compare practices between Fr-DPPDs and dentists registered in the European Academy of Paediatric Dentistry (EAPD).

METHODS

A questionnaire was electronically administrated to members of the CEOP (Collège des Enseignants en Odontologie Pédiatrique), the SFOP (Société Française d'Odontologie Pédiatrique), and the EAPD. Descriptive analyses, Chi-square and McNemar tests, ANOVA, crude and adjusted binary logistic regression analyses were performed.

RESULTS

A total of 99 Fr-DPPDs and 146 EAPD members answered the questionnaire. Among the Fr-DPPDs, the preferred caries removal (CR) methods were the complete CR in one step for primary teeth and mature permanent teeth (respectively, 70% and 48%) and in two steps for immature permanent teeth (39%). EAPD members were more likely, than Fr-DPPDs, to choose selective CR versus complete CR in primary teeth (odds ratio = 2.60; 95% CI 1.39-4.85). Moreover, for primary or immature permanent teeth, general practitioners were less likely to choose selective CR than specialists and exclusive practitioners in paediatric dentistry, (p < 0.001).

CONCLUSION

Tooth type [primary, permanent (immature or mature)] seemed to influence DCL management. Fr-DPPS should prioritise pulpal vitality when managing DCL.

An Evaluation on Deep Caries Removal Method and Management Performed by Undergraduate Dental Students: A Malaysia Experience

OBJECTIVES

 The aim of this study was to investigate the current knowledge and attitude of deep caries removal method among dental students in Malaysia.

MATERIALS AND METHODS

 A total of 303 students (n = 303) responded to the online questionnaire. The first part of questionnaire was to evaluate the demographic data of the respondents and focused on the technique and management approach used for deep caries lesion. The second part investigated the preferred treatment used for deep caries based on the designated clinical case, while the third part assessed the factors that affected the decision on deep caries management.

STATISTICAL ANALYSIS

 Independent t-test was used to compare difference between the two groups.

RESULTS

 Seventy four percent of the students have the knowledge of the different methods of caries removal, while 25.8% were only familiar with complete caries removal. The preferred method for deep caries removal in permanent teeth was partial caries removal (53%). For primary dentition, 45.6% of the students prefer to perform pulpotomy as compared with other techniques. There was no significant difference in caries removal method for permanent teeth between undergraduate year of study (p > 0.05), which was partial caries removal at 52.7 and 53.5%, respectively. For primary dentition, the preferred caries removal method was pulpotomy for year 4 (39.8%) and year 5 (52%) students. The popular material to restore deep caries was resin composite (42%) followed by glass ionomer cement (23.3%).

CONCLUSIONS

 This study showed that partial caries removal was the preferred method despite partial understanding on the identification of the clinical indicators of the technique.