Platelet deposition estimation: A novel method for emulating the pump thrombosis potential of blood pumps

Numerical analysis of different cardiac functions and support modes on blood damage potential in an axial pump

BACKGROUND

Cardiac functions and support modes of left ventricular assist device (LVAD) will influence the pump inner flow field and blood damage potential.

METHODS

Computational fluid dynamics (CFD) method and lumped-parameter-model (LPM) were applied to investigate the impacts of cardiac functions under full (9000 rpm) and partial (8000 rpm) support modes in an axial pump.

RESULTS

The constitution of hemolysis index (HI) in different components of the pump was investigated. HI was found to be more sensitive to positive incidence angles (i) compared with negative incidence angles in rotors. Negative incidence angles had little impact on HI both in rotors and the outlet guide vanes. The improved cardiac function made only a minor difference in HIave (estimated average HI in one cardiac cycle) by 9.88%, as the flow rate expanded mainly to higher flow range. Switching to partial support mode, however, would induce a periodic experience of severe flow separation and recirculation at low flow range. This irregular flow field increased HIave by 47.97%, remarkably increasing the blood damage potential.

CONCLUSION

This study revealed the relationship between the blade incidence angle i and HI, and recommended negative-incidence-angle blade designs as it yielded lower HI. Moreover, to avoid flow range below 50% of the design point, careful evaluations should be made before switching support modes as weaning procedures in clinical applications.

Effect of Conical Spiral Flow Channel and Impeller Parameters on Flow Field and Hemolysis Performance of an Axial Magnetic Blood Pump

For a blood pump, the blood flow channel and impeller parameters directly affect the performance of the pump and the resulting blood circulation. The flow channel in particular has a great impact on the hydraulic performance of the pump (e.g., flow and pressure), which directly determines the overall performance of the blood pump. Traditional bearing-supported blood pumps can cause mechanical damage to blood cells, leading to hemolysis and thrombosis. In this study, therefore, we designed a conical spiral axial blood pump with magnetic levitation. The blood pump was supported by electrodynamic bearings in the radial direction and electromagnetic bearings in the axial direction. The impeller and the front and rear hubs were integrated to minimize blood stagnation and reduce the formation of thrombosis. The hub had a conical spiral flow channel design, which not only reduced the size of the impeller but also increased blood flow and pressure while meeting the design requirements. Computational fluid dynamics (CFD) analysis was used to analyze the flow field of the axial blood pump, a power function model was used to establish a hemolysis prediction model, and the particle tracking method was used to obtain the flow trajectories of individual blood cells, thereby predicting hemolysis-related performance of the blood pump. The simulation results showed that the main high shear stress area in the blood pump was located in the impeller inlet and the clearance between the top of the impeller and the inner chamber of the blood pump. When the hub taper angle of the blood pump was 0.72° and the clearance was 0.3 mm, the average hemolysis prediction value was 0.00216. This prediction value was smaller than that of traditional axial blood pumps. These findings can provide an important reference for the structural design of axial blood pumps and for reducing the hemolysis prediction value.