A comparative evaluation of student experience with artificial teeth used in pre-clinical fixed prosthodontics post-core undergraduate teaching programs

The influence of different cement spaces on the marginal gap of lithium disilicate crowns constructed by two scanner and milling unit combinations

BACKGROUND

This study compared the marginal gaps of CAD/CAM lithium disilicate (LDS) crowns constructed using a contemporary and older scanner/milling unit combination at three different cement spaces.

METHODS

Twenty-four undergraduate students prepared a Columbia model lower left first molar for an LDS crown in a simulated environment. From each crown preparation, one LDS crown was constructed using an E4D scanner/E4D milling unit (E4DS/E4DM) and TRIOS 3 scanner/Sirona inLab MC X5 milling unit (TRIO/MCX5) at cement space settings of 50, 100 and 200 μm. Each LDS crown was positioned onto the original crown preparation, and then a stereomicroscope was used to make three vertical marginal gap measurements at four locations (mid-buccal, mid-lingual, mid-mesial and mid-distal). The mean marginal gap (MMG) was calculated for each crown and each individual tooth surface.

RESULTS

The MMGs of CAD/CAM LDS crowns constructed by TRIO/MCX5 were 72.31 at 50, 63.73 at 100 μm and 46.23 μm at 200 μm, which were smaller than E4DS/E4DM at each cement space.

CONCLUSIONS

Increasing the cement space decreased the MMG in both scanner/milling unit combinations. The smallest MMG was found using the newer scanner/milling unit at the 200 μm cement space. © 2024 Australian Dental Association.

Orthodontic shear bond strength and ultimate load tests of CAD/CAM produced artificial teeth

OBJECTIVES

To investigate whether artificial CAD/CAM processed (computer-aided design/manufacturing) teeth could be a feasible option for the production of dental in vitro models for biomechanical testing.

MATERIAL AND METHODS

Disks (n = 10 per group) made from two different CAD/CAM-materials, one fiber-reinforced composite (FRC; Trinia, Bicon) and one polymethylmethacrylate-based resin (PMMA; Telio CAD, Ivoclar Vivadent), as well as bovine teeth (n = 10), were tested for their shear bond strength (SBS) and scored according to the adhesive remnant index (ARI). In addition, CAD/CAM-manufactured lower incisor teeth were tested for their ultimate load (F_u).

RESULTS

With regard to SBS, both PMMA (17.4 ± 2.2 MPa) and FRC (18.0 ± 2.4 MPa) disks showed no significant difference (p = 0.968) compared to bovine disks (18.0 ± 5.4 MPa). However, the samples differed with regard to their failure mode (PMMA: ARI 4, delamination failure; FRC: ARI 0 and bovine: ARI 1.6, both adhesive failure). With regard to F_u, FRC-based teeth could withstand significantly higher loads (708 ± 126 N) than PMMA-based teeth (345 ± 109 N) (p < 0.01).

CONCLUSION

Unlike PMMA-based teeth, teeth made from FRC showed sufficiently high fracture resistance and comparable SBS. Thus, FRC teeth could be a promising alternative for the production of dental in vitro models for orthodontic testing.

CLINICAL RELEVANCE

CAD/CAM-processed teeth made from FRC enable the use of standardized geometry and constant material properties. Using FRC teeth in dental in vitro studies has therefore the potential to identify differences between various treatment options with rather small sample sizes, while remaining close to the clinical situation.