Indirect caries-preventive effect of silver diamine fluoride on adjacent dental substrate: A single-section demineralization study

Effect of Three Chemical Agents on Stain Removal from Dentin Caries Lesions Treated with Silver Diamine Fluoride

INTRODUCTION

This in vitro study aimed to evaluate the effect of three different chemical agents on stain removal and mineral uptake of artificial dentin caries (ADC) lesions treated with silver diamine fluoride (SDF).

METHODS

Baseline L*a*b* values were determined in polished human permanent dentin blocks, and ADC lesions were induced with an acid gel for 1 week. Samples were assigned to four groups; in three groups, half of each sample received SDF (30% SDF for 3 min), while the other half received SDF followed by a bleaching treatment protocol (garlic extract, bentonite, or 35% hydrogen peroxide). The fourth group had one SDF-treated half and one half without SDF. Color changes (ΔE) were measured by spectrometry, and transversal microradiography was used to quantify integrated mineral loss (ΔZ) 24 h after treatment (SDF or SDF + bleaching). A two-way mixed ANOVA was applied to thirty percent.

RESULTS

SDF application increased mineral uptake by ADC (p = 0.001). The type of chemical agent evaluated (p < 0.0001), time (p = 0.01), and their interaction (p < 0.0001) bleached the ADC treated with SDF. However, 35% hydrogen peroxide was the only compound with a bleaching effect (p < 0.001), without returning to baseline color. None of the compounds altered the mineral uptake effect of SDF (p = 0.30).

CONCLUSION

This in vitro study showed mineral uptake effect in ACD within 24 h after SDF application and the ability of hydrogen peroxide to partially remove (reduction of 24%) the staining caused by SDF without affecting its mineral uptake effect.

Evaluation of the remineralizing capacity of silver diamine fluoride on demineralized dentin under pH-cycling conditions

OBJECTIVE

(1) to determine the effects of the silver diamine fluoride (SDF) and sodium fluoride (NaF) in demineralized dentin exposed to an acid challenge by pH-cycling, (2) to evaluate the remineralizing capacity of SDF/NaF products based on the physicochemical and mechanical properties of the treated dentin surfaces.

METHODOLOGY

In total, 57 human molars were evaluated in different stages of the experimental period: sound dentin - negative control (Stage 1), demineralized dentin - positive control (Stage 2), and dentin treated with SDF/NaF products + pH-c (Stage 3). Several commercial products were used for the SDF treatment: Saforide, RivaStar, and Cariestop. The mineral composition and crystalline and morphological characteristics of the dentin samples from each experimental stage were evaluated by infrared spectroscopy (ATR-FTIR), X-ray diffraction, and electron microscopy (SEM-EDX) analytical techniques. Moreover, the mechanical response of the samples was analyzed by means of the three-point bending test. Statistics were estimated for ATR-FTIR variables by Wilcoxon test, while the mechanical data analyses were performed using Kruskal-Wallis and Mann Whitney U tests.

RESULTS

Regarding the chemical composition, we observed a higher mineral/organic content in the SDF/NaF treated dentin + pH-c groups (Stage 3) than in the positive control groups (Saforide p=0.03; Cariestop p=0.008; RivaStar p=0.013; NaF p=0.04). The XRD results showed that the crystallite size of hydroxyapatite increased in the SDF/NaF treated dentin + pH-c groups (between +63% in RivaStar to +108% in Saforide), regarding the positive control. SEM images showed that after application of the SDF/NaF products a crystalline precipitate formed on the dentin surface and partially filled the dentin tubules. The flexural strength (MPa) values were higher in the dentin treated with SDF/NaF + pH-c (Stage 3) compared to the positive control groups (Saforide p=0.002; Cariestop p=0.04; RivaStar p=0.04; NaF p=0.02).

CONCLUSIONS

The application of SDF/NaF affected the physicochemical and mechanical properties of demineralized dentin. According to the results, the use of SFD/NaF had a remineralizing effect on the dentin surface even under acid challenge.

Effects of Silver Diamine Nitrate and Silver Diamine Fluoride on Dentin Remineralization and Cytotoxicity to Dental Pulp Cells: An In Vitro Study

Silver diamine nitrate (SDN) is expected to help control caries similar to silver diamine fluoride (SDF). The aim of this study was to determine the mineral precipitation in demineralized dentin and the cytotoxicity of SDN and SDF to dental pulp cells. Demineralized dentin specimens were prepared, and SDF, SDN, or water (control) was applied. The specimens were then remineralized in simulated body fluid for 2 weeks. The mineral precipitation in the specimens was examined using FTIR-ATR, SEM-EDX, and synchrotron radiation X-ray tomographic microscopy (SRXTM). Additionally, the cytotoxicity of SDF and SDN to human dental pulp stem cells was analyzed using an MTT assay. The increase in FTIR spectra attributable to apatite formation in demineralized dentin in the SDF group was significantly higher compared to the SDN and control groups (p < 0.05). Dentinal tubule occlusion by the precipitation of silver salts was detected in both SDF and SDN groups. The mineral density as shown in SRXTM images and cytotoxicity of both SDN and SDF groups were comparable (p > 0.05). In conclusion, SDF demonstrated superior in vitro apatite formation compared to SDN. However, the degree of mineral precipitation and cytotoxic effects of both were similar.

Effects of Different Application Times of Silver Diamine Fluoride on Mineral Precipitation in Demineralized Dentin

Silver diamine fluoride (SDF) is a cost-effective method for arresting active dental caries. However, the limited cooperation of patients may lead to an SDF application time that is shorter than the recommended 1-3 min for carious lesions. Therefore, the aim of this study was to assess the effect of different application times of SDF on the degree of mineral precipitation in demineralized dentin. Demineralized dentin specimens from permanent maxillary molars were treated by applying 38% SDF for 30, 60, or 180 s. Water was applied in the control group. The specimens were immersed in simulated body fluid for 2 weeks, and the mineral precipitation in demineralized dentin was then analyzed using FTIR-ATR, SEM-EDX, and synchrotron radiation X-ray tomographic microscopy (SRXTM). The FTIR-ATR results showed a significant increase in mineral precipitation in the 180 s group after 1 week. However, after 2 weeks, the SRXTM images indicated comparable mineral density between the 30, 60, and 180 s groups. The precipitation of silver chloride and calcium phosphate crystals that occluded dentinal tubules was similar in all experimental groups. In conclusion, an application time of either 30, 60, or 180 s promoted a comparable degree of mineral precipitation in demineralized dentin.