Production of monoclonal antibodies for immunoaffinity purification and quantitation of Blo t 1 allergen in mite and dust extracts

A robust method for the estimation and visualization of IgE cross-reactivity likelihood between allergens belonging to the same protein family

Among the vast number of identified protein families, allergens emanate from relatively few families which translates to only a small fraction of identified protein families. In allergy diagnostics and immunotherapy, interactions between immunoglobulin E and allergens are crucial because the formation of an allergen-antibody complex is necessary for triggering an allergic reaction. In allergic diseases, there is a phenomenon known as cross-reactivity. Cross-reactivity describes a situation where an individual has produced antibodies against a particular allergenic protein, but said antibodies fail to discriminate between the original sensitizer and other similar proteins that usually belong to the same family. To expound the concept of cross-reactivity, this study examines ten protein families that include allergens selected specifically for the analysis of cross-reactivity. The selected allergen families had at least 13 representative proteins, overall folds that differ significantly between families, and include relevant allergens with various potencies. The selected allergens were analyzed using information on sequence similarities and identities between members of the families as well as reports on clinically relevant cross-reactivities. Based on our analysis, we propose to introduce a new A-RISC index (Allergens’–Relative Identity, Similarity and Cross-reactivity) which describes homology between two allergens belonging to the same protein family and is used to predict the likelihood of cross-reactivity between them. Information on sequence similarities and identities, as well as on the values of the proposed A-RISC index is used to introduce four categories describing a risk of a cross-reactive reaction, namely: high, medium-high, medium-low and low. The proposed approach can facilitate analysis in component-resolved allergy diagnostics, generation of avoidance guidelines for allergic individuals, and help with the design of immunotherapy.

Specific IgY anti-group 1 dust mite allergens induced by unglycosylated synthetic oligopeptides

Introduction: The use of specific antibodies capable of detecting allergens of the group 1 of house dust mites represents a potential strategy to reduce exposure and clinical symptomatology associated with asthma and allergic rhinitis. Objective: To produce and purify chicken antibodies specific for the dust mites Dermatophagoides sp. and B. tropicalis using the IgY technology. Materials and methods: We designed and synthesized oligopeptides showing immunogenic epitopes of Der p1, Der f1, and Blo t1. These were used to produce IgY antibodies in Hy Line Brown chickens. IgY were extracted from egg yolk using thiophilic chromatography. The immunogenicity and specificity were assayed by indirect ELISA and Dot Blot. Results: We obtained high reactivity of IgY antibodies against epitopes of allergens present in whole body mites extracts of D. farinae, D. pteronyssinus, and B. tropicalis. The highest IgY levels were registered between days 32 and 40 after immunization. The antibodies showed high immunoreactivity and specificity towards D. farinae proteins with detection limits above 0.03 μg of mite proteins under the experimental conditions used. Purified IgY did not show significant reactivity when binding to Periplaneta americana extract. Conclusion: The IgY technology allowed the production of specific antibodies against house dust mites group 1 allergens using non-glycosylated synthetic peptides. To our knowledge, this is the first time that this immunochemicals are used in the detection of mites of medical relevance.

Consideration of methods for identifying mite allergens

House dust mites are small arthropods that produce proteins—found in their feces, body parts, and eggs—that are major triggers of human allergies worldwide. The goal of this review is to describe the current methods used to identify these allergens. A literature search for allergen identification methods employed between 1995 and 2016 revealed multiple techniques that can be broadly grouped into discovery and confirmation phases. The discovery phase employs screening for mite proteins that can bind IgEs in sera from animals or patients allergic to dust mites. The confirmation phase employs biochemical methods to isolate either native or recombinant mite proteins, confirms the IgE binding of the purified allergens, and uses either in vitro or in vivo assays to demonstrate that the purified antigen can stimulate an immune response. The methods used in the two phases are defined and their strengths and weaknesses are discussed. The majority of HDM-allergic patients may respond to just a small subset of proteins, but new protein discovery methods are still warranted in order to develop a complete panel of HDM allergens for component resolved diagnosis and patient-tailored therapies.

The structure of the mite allergen Blo t 1 explains the limited antibody cross-reactivity to Der p 1

The Blomia tropicalis (Blo t) mite species is considered a storage mite in temperate climate zones and an important source of indoor allergens causing allergic asthma and rhinitis in tropical and subtropical regions. Here, we report the crystal structure of one of the allergens from Blo t, recombinant proBlo t 1 (rproBlo t 1), determined at 2.1 Å resolution. Overall, the fold of rproBlo t 1 is characteristic for the pro-form of cysteine proteases from the C1A class. Structural comparison of experimentally mapped Der f 1/Der p1 IgG epitopes to the same surface patch on Blo t 1, as well as of sequence identity of surface-exposed residues, suggests limited cross-reactivity between these allergens and Blo t 1. This is in agreement with ELISA inhibition results showing that, although cross-reactive human IgE epitopes exist, there are unique IgE epitopes for both Blo t 1 and Der p 1.

Hierarchy and molecular properties of house dust mite allergens

The allergenic load of house dust mite allergy is largely constituted by a few proteins with a hierarchical pattern of allergenicity. The serodominant specificities are the group 1&2 and the group 23 faecal allergens. The collective IgE binding to the group 1&2 allergens can measure unequivocal HDM sensitisation better than HDM extracts although discrepancies have been found in regions with complex acarofauna suggesting a need to investigate the specificity with allergen components. The group 4, 5, 7&21 allergens that each induce responses in about 40% of subjects are mid-tier allergens accounting for most of the remaining IgE binding. Their titres are proportional to the concomitant responses to Der p1&2. Group 2 allergen variants have different antibody binding. Body proteins only occasionally induce sensitisation although a higher prevalence of binding by atopic dermatitis patients provides a new avenue of research. A broad spectrum of IgE binding has been associated with diverse symptoms but not with the severity of asthma which is associated with low IgG antibody. Some allergens such as the group 14 large lipid binding proteins and the recently described proteins Der f 24-33, need further investigation but with the cognoscence that other denominated allergens have been found to be minor sensitisers by comparative quantitative analyses. Scabies is a confounder for diagnosis with extracts, inducing cross-reactive antibodies with Der p 4&20 as is seafood allergy with cross reactivity to Der p 10 a minor HDM allergen. The HDM genome sequence can now be used to verify allelic and paralogous variations.

Innate affairs of allergens

Activation of receptors of the innate immune system is a critical step in the initiation of immune responses. It has been shown that dominant allergens have properties that could allow them to interact with toll-like and C-type lectin receptors to favour Th2-biased responses and many bind lipids and glycans that could associate with ligands to mimic pathogen-associated microbial patterns. In accord with the proposed allergen-specific innate interactions it has been shown that the immune responses to different allergens and antigens from the same source are not necessarily coordinately regulated.

Characterization for binding complex formation with site-directly immobilized antibodies enhancing detection capability of cardiac troponin I

The enhanced analytical performances of immunoassays that employed site-directly immobilized antibodies as the capture binders have been functionally characterized in terms of antigen-antibody complex formation on solid surfaces. Three antibody species specific to cardiac troponin I, immunoglobulin G (IgG), Fab, and F(ab')(2) were site-directly biotinylated within the hinge region and then immobilized via a streptavidin-biotin linkage. The new binders were more efficient capture antibodies in the immunoassays compared to randomly bound IgG, particularly, in the low antibody density range. The observed improvements could have resulted from controlled molecular orientation and also from flexibility, offering conditions suitable for binding complex formations.

Production of monoclonal antibody by DNA immunization with electroporation

DNA immunization with in vivo electroporation is an efficient alternative protocol for the production of monoclonal antibodies (mAb). Generation of mAb by DNA immunization is a novel approach to circumvent the following technical hurdles associated with problematic antigens: low abundance and protein instability and use of recombinant proteins that lack posttranslational modifications. This chapter describes the use of a DNA-based immunization protocol for the production of mAb against a house dust mite allergen, designated as Blo t 11, which is a paramyosin homologue found in Blomia tropicalis mites. The Blo t 11 cDNA fused at the N terminus to the sequence of a signal peptide was cloned into the pCI mammalian expression vector. The DNA construct was injected intramuscularly with in vivo electroporation into mice, and the specific antibody production in mice was analyzed by enzyme-linked immunosorbent assay (ELISA). Hybridomas were generated by fusing mouse splenocytes with myeloma cells using the ClonaCell-HY Hybridoma Cloning Kit. Six hybridoma clones secreting Blo t 11 mAb were successfully generated, and these mAb are useful reagents for immunoaffinity purification and immunoassays.

Site-directed biotinylation of antibodies for controlled immobilization on solid surfaces

Site-directed biotinylation of antibodies at the hinge region was developed to immobilize antibodies in an oriented manner via biotin-streptavidin linkage. When intact antibody was biotinylated with maleimide-activated biotin after reduction, the reaction preferentially occurred at the sulfhydryl groups between the C(H1) and the C(L) domains and, provided that the reagent concentration exceeded a certain level, at those between the C(H2) and the C(H2) domains at the hinge. Based on this result, we devised an approach in which free maleimide was added to compete with the activated biotin for the preferential sites between the C(H1) and the C(L) domains. Since the smaller molecular size of free maleimide made it more accessible for the reaction than biotin, maleimide bound to the groups between the C(H1) and the C(L) domains first and thus conceded the groups between the C(H2) and the C(H2) domains to biotin under optimal conditions. In an alternative approach, selective biotinylation at the hinge was also achieved by reacting activated biotin with F(ab')(2) fragment prepared by enzymatic cleavage. This result indicated that, when free of Fc, the hinge structure, which contains the functional groups, of the fragment was open, allowing easy access to the biotin derivative from the aqueous medium. Both site-directed biotinylation preparations were tested as capture antibodies in sandwich-type immunoassays and compared to whole antibody randomly biotinylated at amino groups on the molecule. Preparations of both the intact antibody and the F(ab')(2) showed consistently enhanced detection capabilities that were 2.6 and 20 times that of the control, respectively.