Effects of plasma collection systems and processing parameters on the quality of factor IX concentrate

Biochemical and cellular markers differentiate recovered, in-line filtered plasma, and plasma obtained by apheresis methods

BACKGROUND AND OBJECTIVES

Assessment of plasma quality often focuses on the common safety tests for minimizing the risk of transmitting blood-borne pathogens. Little attention is paid to the possible quality attributes that ensure a consistent biochemical composition of plasma for fractionation. We therefore investigated the suitability of selected biochemical and haematological attributes that could be used as markers of plasma quality obtained by different separation and pre-treatment procedures.

MATERIAL AND METHODS

We characterized six plasma types, including source plasma, plasma recovered by classic means and in-line filtered plasma, by determining the analytical attributes protein content, coagulation factors and markers of coagulation, contact and complement activation. Residual cell content and cell-specific variables were also measured.

RESULTS

We found relevant differences between the plasma types in complement activation, as indicated by C3a measurements, while thrombin antithrombin complex values and, to a minor extent, activated factor XII concentrations indicated only moderate differences in activation levels of coagulation and contact systems. The most striking differences, however, were detected in residual cell content and concentrations of the platelet-associated proteins, platelet factor 4 and β-thromboglobulin. We showed that leucocyte reduction filters disrupt cells. This includes platelets, thereby releasing the platelet-associated proteins platelet factor 4 and β-thromboglobulin, and leucocytes as demonstrated by the release of elastase from polymorphonuclear leucocytes. Furthermore, the filtration processing of whole blood can lead to activation of the complement system.

CONCLUSION

Our results show that biochemical and cellular surrogate markers are valuable discriminators of plasma types.

Quality Assurance in Hemapheresis: Quality of Fresh Frozen Plasma

The Authors analyse how established criteria for quality assurance of FFP may be applied to apheresis plasma produced for fractionation into derivatives.

Modulation of fibrinogen content in cryoprecipitate by temperature manipulation during plasma processing

In routine blood bank production of single-donation cryoprecipitate, the introduction of a 16-hour hold at 4 degrees C, with the frozen plasma units packed into polystyrene containers, resulted in plasma prethaw temperatures of -4 degrees C to -8 degrees C. This in turn resulted in cryoprecipitate fibrinogen levels that were 214 percent of those obtained when units were thawed immediately after removal from -30 degrees C storage. In scale-model production of factor VIII concentrate, plasma warmed from -30 to -10 to -15 degrees C over 18 hours before pooling and thawing yielded cryoprecipitate fibrinogen levels that were 66 percent of those found in plasma warmed to -2 to -5 degrees C over the same period. Processing -30 degrees C plasma without a warming period led to cryoprecipitate fibrinogen levels that were 40 percent of those obtained from plasma warmed to -2 to -5 degrees C. These differences were accentuated after purification of the cryoprecipitates to an intermediate-purity factor VIII concentrate. These results suggest that simple modifications in production methods allow the fibrinogen content of cryoprecipitate to be tailored to specific uses.