Study of the effect of atrial contraction on mitral prosthetic valve by high speed video camera

Effects of mechanical valve orifice direction on the flow pattern in a ventricular assist device

We have been developing a pneumatic ventricular assist device (PVAD) system consisting of a diaphragm-type blood pump. The objective of the present study was to evaluate the flow pattern inside the PVAD, which may greatly affect thrombus formation, with respect to the inflow valve-mount orientation. To analyze the change of flow behavior caused by the orifice direction (OD) of the valve, the flow pattern in this pump was visualized. Particle image velocimetry was used as a measurement technique to visualize the flow dynamics. A monoleaflet mechanical valve was mounted in the inlet and outlet ports of the PVAD, which was connected to a mock circulatory loop tester. The OD of the inlet valve was set at six different angles (OD = 0 degrees, 45 degrees, 90 degrees, 135 degrees, 180 degrees, and 270 degrees, where the OD opening toward the diaphragm was defined as 0 degrees ) and the pump rate was fixed at 80 bpm to create a 5.0 l/min flow rate. The main circular flow in the blood pump was affected by the OD of the inlet valve. The observed regional flow velocity was relatively low in the area between the inlet and outlet port roots, and was lowest at an OD of 90 degrees. In contrast, the regional flow velocity in this area was highest at an OD of 135 degrees. The OD is an important factor in optimizing the flow condition in our PVAD in terms of preventing flow stagnation, and the best flow behavior was realized at an OD of 135 degrees.

Effects of Atrial Arrhytmias on the Regurgitation of a Monoleaflet Prosthetic Heart Valve

Many patients who receive a prosthetic heart valve also have or acquire cardiac arrhythmias. However, most in vitro studies of prosthetic valves examine them under normal rhythms. In this study, a monoleaflet prosthetic heart valve was tested in vitro under conditions that simulated normal sinus rhythm, first degree atrioventricular heart block, and atrial fibrillation (fixed and variable ventricular rates). Atrial contraction was simulated by an active atrial chamber. The timing between the atrium and ventricle was adjusted to simulate various types of arrhythmias. The closing, leakage, and total regurgitant volumes and fractions increased for each type of atrial arrhythmia when compared to normal sinus rhythm. The peak regurgitant flow increased for first degree atrioventricular heart block and atrial fibrillation with a fixed ventricular rate compared to normal sinus rhythm.

Preliminary study on the new self-closing mechanical mitral valve

Anatural mitral valve starts closing before systole. Conventional mechanical mitral valves start their closing motion after systole. In order to let the mechanical mitral valves start closing before systole, we propose a new self-closing valve by adjusting the center of gravity of the leaflet. As a first step, we adjusted the center of gravity by attaching a block of lead to the leaflet of a CarboMedics bileaflet valve and evaluated it using a pulse duplicator and an x-ray high-speed video camera. Comparative study was conducted under 60 bpm and 4 L/min as the mean flow rate. It was clarified that the self-closing valve started closing before systole, no influence on inflow volume was found, the final closing speed of the self-closing valve just before complete closure was slower than the conventional valve (1.9-0.34 m/s), a design strategy of a self-closing valve (sewing ring diameter 29 mm) was obtained from the experiment that momentum of inertia of the leaflet should be less than 14.9 x 10-9 kg.m2 and the torque caused by gravity should be more than 4.2 x 10-6 N. m, and only one leaflet should be designed as self-closing, and surgeons need to pay attention to the positioning of the two leaflets. In conclusion, the preliminary study showed the ability of starting to close before systole and the design strategy for future prototyping.