Microbial activity in aquatic environments measured by dimethyl sulfoxide reduction and intercomparison with commonly used methods

A new method to determine microbial (bacterial and fungal) activity in various freshwater habitats is described. Based on microbial reduction of dimethyl sulfoxide (DMSO) to dimethyl sulfide (DMS), our DMSO reduction method allows measurement of the respiratory activity in interstitial water, as well as in the water column. DMSO is added to water samples at a concentration (0.75% [vol/vol] or 106 mM) high enough to compete with other naturally occurring electron acceptors, as determined with oxygen and nitrate, without stimulating or inhibiting microbial activity. Addition of NaN(3), KCN, and formaldehyde, as well as autoclaving, inhibited the production of DMS, which proves that the reduction of DMSO is a biotic process. DMSO reduction is readily detectable via the formation of DMS even at low microbial activities. All water samples showed significant DMSO reduction over several hours. Microbially reduced DMSO is recovered in the form of DMS from water samples by a purge and trap system and is quantified by gas chromatography and detection with a flame photometric detector. The DMSO reduction method was compared with other methods commonly used for assessment of microbial activity. DMSO reduction activity correlated well with bacterial production in predator-free batch cultures. Cell-production-specific DMSO reduction rates did not differ significantly in batch cultures with different nutrient regimes but were different in different growth phases. Overall, a cell-production-specific DMSO reduction rate of 1.26 x 10(-17) +/- 0. 12 x 10(-17) mol of DMS per produced cell (mean +/- standard error; R(2) = 0.78) was calculated. We suggest that the relationship of DMSO reduction rates to thymidine and leucine incorporation is linear (the R(2) values ranged from 0.783 to 0.944), whereas there is an exponential relationship between DMSO reduction rates and glucose uptake, as well as incorporation (the R(2) values ranged from 0.821 to 0.931). Based on our results, we conclude that the DMSO reduction method is a nonradioactive alternative to other methods commonly used to assess microbial activity.

Determination of microbial activity in activated sewage sludge by dimethyl sulphoxide reduction : Evaluation of method and application

A method was developed to determine the dimethyl sulphoxide (DMSO) reduction rate in activated sewage sludge at nearly natural conditions.Linearity of microbially produced dimethyl sulphide with incubation time and sample size was shown. Apart from a fast, sensitive and highly reproducible automatic analysis of dimethyl sulphide, simultaneous determination of mineralisation, respiration and phenol degradation rates was possible.The DMSO reduction rate of samples taken from a municipal sewage plant ranged between 2 and 3 μmol/(g dry matter · h), respiration and mineralisation rates between 30 and 80 μmol/(g · h). Added(13)C6-phenol was completely degradated after 96 h of incubation. A half-life of 14 h was calculated assuming first order decay. Dose response curves were obtained by incubating samples for 2, 6, 25, and 96 hours after addition of pentachlorophenol. At an incubation time of 6 h, the EC50 values ranged from 20 mg/L (DMSO reduction) to 30 mg/L (phenol degradation) up to 180 mg/L (respiration and mineralisation). Increasing the incubation time to 96 h resulted in a lower EC50 of 9 mg/L for DMSO reduction, whereas it increased to 500 mg/L for respiration and mineralisation.