Assessment of home environments with a fungal index using hydrophilic and xerophilic fungi as biologic sensors

Environmental and sensitization variations among asthma and/or rhinitis patients between 2008 and 2018 in China

Background

Little is known about the changes in allergen sensitization in China secondary to the environmental variations over the past decade. We aimed at investigating the variations in sensitization among asthma and/or rhinitis patients in China between 2008 and 2018.

Methods

This study analyzed cross‐sectional data from national surveys conducted in China in 2008 and 2018. After finishing the questionnaire, participants underwent serum specific IgE measurements. A total of 2322 and 2798 patients were enrolled in 2008 and 2018, respectively. The significance of differences in sensitization rates among four regions of China were assessed. Correlation analysis was used to identify the associations of sensitization with climate change and planting of Artemisia desertorum between the two surveys.

Results

Compared with 2008, the general sensitization rate to mites significantly increased in 2018, which ranked highest among all tested allergens. Sensitization to pollens, especially Artemisia vulgaris, showed the greatest increase in the north. The annual mean temperature, rainfall and relative humidity in all four regions, and the Artemisia desertorum coverage in the northeastern area, increased significantly in 2018 as compared with 2008. From 2008 to 2018, an increase in Dermatophagoides pteronyssinus sensitization was significantly associated with an increase in relative humidity (r = 0.54, p = 0.037). The increase in A. vulgaris sensitization was significantly associated with the increase in the A. desertorum planting area (r = 0.67, p = 0.006) and with a decrease in rainfall (r = −0.59, p = 0.021).

Conclusions

House dust mites remain the most important allergen in Chinese individuals with asthma and/or rhinitis. Pollen sensitization dramatically increased in northern China. Increases in sensitization to dust mites and Artemisia were related to the increases in humidity and planting area of A. desertorum.

The Effect of Air leakage through the Air Cavities of Building Walls on Mold Growth Risks

Mold growth poses a high risk to a large number of existing buildings and their users. Air leakage through the air cavities of the building walls, herein gaps between walls and air conditioner pipes penetrating the walls, may increase the risks of interstitial condensation, mold growth and other moisture-related problems. In order to quantify the mold growth risks due to air leakage through air cavity, an office room in a historical masonry building in Nanjing, China, was selected, and its indoor environment has been studied. Fungi colonization can be seen on the surface of air conditioner pipes in the interior side near air cavity of the wall. Hygrothermometers and thermocouples logged interior and exterior temperature and relative humidity from June 2018 to January 2020. The measured data show that in summer the outdoor humidity remained much higher than that of the room, while the temperature near the air cavity stays lower than those of the other parts in the room. Hot and humid outdoor air may condense on the cold wall surface near an air cavity. A two-dimensional hygrothermal simulation was made. Air leakage through the air cavities of walls proved to be a crucial factor for mold growth.

Indoor Air Quality and Health in Newly Constructed Apartments in Developing Countries: A Case Study of Surabaya, Indonesia

In times of rapid urbanization, increasing usage of chemicals in buildings, and energy saving measures, the topic of indoor air quality (IAQ) demands reinforced attention. Nevertheless, especially in developing countries with urgent building construction needs, IAQ has hardly been examined. This study investigates the condition of IAQ and health of occupants in newly constructed high-rise apartments in contrast to traditional detached houses (Kampongs) in Surabaya, Indonesia. Information on building attributes, cleaning and ventilation behavior, interior sources, personal characteristics and health, especially multiple chemical sensitivity (MCS), was collected through 471 questionnaires. In addition, 76 measurements of TVOCs, formaldehyde and 30 measurements of mold risk were carried out. The results showed that the share of people in apartments with a very suggestive risk of MCS was twice as high as that in Kampongs (17.6% vs. 6.7%). Correlation analysis suggested that for both residential types, health problems, negative smell or perception of IAQ, and higher levels of stress determined higher degrees of MCS. For IAQ, high concentrations of formaldehyde and TVOCs were measured in apartments and corresponded to higher MCS risk, whereas severe mold issues were predicted in Kampongs. This study suggests major shortcomings in the indoor environment in newly constructed apartments for the physical and the mental health of occupants.

Measured moisture in buildings and adverse health effects: A review

It has not yet been possible to quantify dose-related health risks attributable to indoor dampness or mold (D/M), to support setting specific health-related limits for D/M. An overlooked target for assessing D/M is moisture in building materials, the critical factor allowing microbial growth. A search for studies of quantified building moisture and occupant health effects identified 3 eligible studies. Two studies assessed associations between measured wall moisture content and respiratory health in the UK. Both reported dose-related increases in asthma exacerbation with higher measured moisture, with 1 study reporting an adjusted odds ratio of 7.0 for night-time asthma symptoms with higher bedroom moisture. The third study assessed relationships between infrared camera-determined wall moisture and atopic dermatitis in South Korea, reporting an adjusted odds ratio of 14.5 for water-damaged homes and moderate or severe atopic dermatitis. Measuring building moisture has, despite extremely limited available findings, potential promise for detecting unhealthy D/M in homes and merits more research attention. Further research to validate these findings should include measured "water activity," which directly assesses moisture availability for microbial growth. Ultimately, evidence-based, health-related thresholds for building moisture, across specific materials and measurement devices, could better guide assessment and remediation of D/M in buildings.

Phylogeny of xerophilic aspergilli (subgenus Aspergillus) and taxonomic revision of section Restricti

Aspergillus section Restricti together with sister section Aspergillus (formerly Eurotium) comprises xerophilic species, that are able to grow on substrates with low water activity and in extreme environments. We adressed the monophyly of both sections within subgenus Aspergillus and applied a multidisciplinary approach for definition of species boundaries in sect. Restricti. The monophyly of sections Aspergillus and Restricti was tested on a set of 102 isolates comprising all currently accepted species and was strongly supported by Maximum likelihood (ML) and Bayesian inferrence (BI) analysis based on β-tubulin (benA), calmodulin (CaM) and RNA polymerase II second largest subunit (RPB2) loci. More than 300 strains belonging to sect. Restricti from various isolation sources and four continents were characterized by DNA sequencing, and 193 isolates were selected for phylogenetic analyses and phenotypic studies. Species delimitation methods based on multispecies coalescent model were employed on DNA sequences from four loci, i.e., ID region of rDNA (ITS + 28S), CaM, benA and RPB2, and supported recognition of 21 species, including 14 new. All these species were also strongly supported in ML and BI analyses. All recognised species can be reliably identified by all four examined genetic loci. Phenotype analysis was performed to support the delimitation of new species and includes colony characteristics on seven cultivation media incubated at several temperatures, growth on an osmotic gradient (six media with NaCl concentration from 0 to 25 %) and analysis of morphology including scanning electron microscopy. The micromorphology of conidial heads, vesicle dimensions, temperature profiles and growth parameters in osmotic gradient were useful criteria for species identification.

The vast majority of species in sect. Restricti produce asperglaucide, asperphenamate or both in contrast to species in sect. Aspergillus. Mycophenolic acid was detected for the first time in at least six members of the section. The ascomata of A. halophilicus do not contain auroglaucin, epiheveadride or flavoglaucin which are common in sect. Aspergillus, but shares the echinulins with sect. Aspergillus.