A method of semi-quantitative microradiographic analysis of root surface lesion remineralization

Effect of fluoride-releasing adhesive system on decalcified dentin

The aim of this study was to evaluate the effect of fluoride-releasing adhesive systems on human decalcified dentin in vitro. Two fluoride-releasing adhesive systems, Reactmer bond (RB, Shofu) and ABF (AF, Kuraray), an experimental system, and a commercial adhesive system without fluoride release, SE bond (SE, Kuraray), were used in this study. The amount of fluoride release from adhesive in deionized water was measured every week for 10 weeks. Class V cavities were prepared on extracted human pre-molars and decalcified dentin was promoted by using a bacterial caries induction system at the cavity floor. The cavities preserving decalcified dentin were restored with resin composite (AP-X, Kuraray) after treatment by each adhesive system. The specimens without treatment by adhesive system and restoration were used for control. The specimens with restoration were then incubated for 4 weeks at 37 degrees C, 100% humidity. Microradiographs of the specimens showed that the radiopacities of the decalcified dentin layers in RB and AF groups with fluoride release were significantly higher than those in SE or control groups without fluoride release. This result suggested that the fluoride-releasing adhesive systems enhanced mineralization of decalcified dentin.

In vitro demineralization by strains of Actinomyces viscosus and Streptococcus sobrinus of sound and demineralized root surfaces

Root sections were inoculated with one of two strains of Actinomyces viscosus or a strain of Streptococcus sobrinus and then incubated for 9 days in Trypticase soy broth (TSB) containing 0.25% glucose or TSB supplemented with 0.25% sucrose (TSB+S). Lesion progression was measured from microradiographs. One section from each group was examined with a transmission electron microscope. Lesion progression was associated with a fall in the pH of the medium. However, lesion progression was not correlated with the mean 48-hour pH of the medium. In both TSB and TSB + S, lesion progression with A. viscosus was significantly greater than in the S. sobrinus group. However, the mean 48-hour pH value in TSB + S was lower than that in the S. sobrinus group. Plaque formation in TSB was, subjectively, least in the S. sobrinus group. Examination of transmission electron micrographs revealed bacteria penetrating the surfaces of the sections and extending into the lesion in the A. viscosus groups but not in the S. sobrinus group. This in vitro bacterial plaque model of root caries may be suitable for investigations of the bacterial etiology of root-surface caries and the virulence factors associated with pathogenicity.

A review of quantitative methods for studies of mineral content of intra-oral caries lesions

Modern prospective caries studies require the measurement of small changes in tooth mineral content. Quantitative measurements of changes in mineral content in a single caries lesion is desirable. Quantitative methods can be either destructive or non-destructive. The latter type permits longitudinal studies to be conducted. Various methods available for the analysis of lesion parameters are reviewed. The basic principle of each method is summarized, and its characteristics are discussed. For each method, the correlation between the measured parameter and mineral loss, the useful range of mineral loss, the discrimination threshold, and the repeatability, are presented. Where such quantities were not available in the original papers, they were calculated from literature data. A comprehensive table of specifications of all methods is given.

Wavelength-independent microradiography: a method for non-destructive quantification of enamel and dentin mineral concentrations using polychromatic x-rays

Wavelength-independent Microradiography (WIM), described in this paper, used polychromatic, high-energy (less than or equal to 60 kV) x-rays for determination of mineral concentrations in tooth material non-destructively. This was done with the aid of a reference step-wedge made of 94% aluminum, 6% zinc. The mass attenuation coefficient of this material has a wavelength-independent ratio to the mass attenuation coefficients of enamel and dentin. With this method, mineral concentrations of enamel and dentin samples, with a thickness up to 500 microns, were determined at 20- and at 60-kV tube voltage. The samples were demineralized for 72 and 144 h and measured again. Comparison of the data showed that mineral quantification was within 1.5%, independent of the x-rays used. Finally, these mineral concentrations--obtained from the Wavelength-independent Microradiography--were compared with measurements of the same samples by Longitudinal Microradiography. A correlation of 0.99 was found for enamel and one of 0.96 for dentin.