Re-anatomization of Anterior Eroded Teeth by Stratification with Direct Composite Resin

Effects of surrounding and underlying shades on the color adjustment potential of a single-shade composite used in a thin layer

Objectives

This study aimed to evaluate the surrounding and underlying shades' effect on the color adjustment potential (CAP) of a single-shade composite used in a thin layer.

Materials and Methods

Cylinder specimens (1.0 mm thick) were built with the Vittra APS Unique composite, surrounded (dual specimens) or not (simple specimens) by a control composite (shade A1, A2, or A3). Simple specimens were also built only with the control composites. Each specimen's color was measured against white and black backgrounds or the simple control specimens with a spectrophotometer (CIELAB system). The whiteness index for dentistry (WI_D) and translucency parameters (TP₀₀) were calculated for simple specimens. Differences (ΔE₀₀) in color between the simple/dual specimens and the controls were calculated. The CAP was calculated based on the ratios between data from simple and dual specimens.

Results

The Vittra APS Unique composite showed higher WI_D and TP₀₀ values than the controls. The highest values of ΔE₀₀ were observed among simple specimens. The color measurements of Vittra APS Unique (simple or dual) against the control specimens presented the lowest color differences. Only surrounding the single-shade composite with a shaded composite barely impacted the ΔE₀₀. The highest CAP values were obtained using a shaded composite under simple or dual specimens.

Conclusions

The CAP of Vittra APS Unique was strongly affected by the underlying shade, while surrounding this composite with a shaded one barely affected its color adjustment.

Background and surrounding colors affect the color blending of a single-shade composite

This study evaluated the background and effect of surrounding colors on the color blending of a single-shade composite used in a thin layer. Disc-shaped specimens (1.0 mm thickness) were built with the Vittra APS Unique composite surrounded (dual specimens) or not surrounded (simple specimens) by a control composite (shade A1, A2, or A3). Simple specimens were also built with only control composites. The specimen color was measured against white and black backgrounds with a spectrophotometer (CIELAB system). The whiteness index for dentistry (WID) was calculated for simple specimens. Differences (ΔE00) in color and translucency parameters (ΔTP00) between the simple/dual specimens and the controls were calculated. The translucency adjustment potential (TAP) and color adjustment potential (CAP) were estimated based on the ratios between data from simple and dual specimens. The Vittra APS Unique composite showed higher WID values than the controls. No differences between ΔTP00_SIMPLE and ΔTP00_DUAL were observed for any of the shades. The composite shade did not affect TAP values. The lowest values of ΔE00_SIMPLE and ΔE00_DUAL were observed for shade A1 regardless of the background color. For the white background, ΔE00_SIMPLE values did not differ from those of ΔE00_DUAL for all shades. Only A1 showed ΔE00_DUAL values lower than ΔE00_SIMPLE when the black background was used. The highest modulus of CAP (negative values for the white background) was observed when shade A1 surrounded the Vittra APS Unique composite. The color blending ability of the single-shade resin composite used in a thin layer was affected by both the surrounding shade and background color.

Performance of MDP-based system in eroded and carious dentin associated with proteolytic inhibitors: 18-Month exploratory study

The aim of this study was to explore the impact of the interaction between an MDP-based universal adhesive system in etch-and-rinse mode and two proteolytic inhibitors on the longevity of restorations bonded to artificially-affected-dentin substrates. 90 sound human third molars were randomly distributed into three groups according to the substrate: N-no challenges-control (stored in artificial saliva), ACD-artificial caries dentin (6 h DE + 18 h-RE/5 days + 48 h RE) and ERO-artificial erosion dentin (3 × 5 min/5 days with orange juice). They were further redistributed according to dentin pretreatment: W- water (control), CHX-2% digluconate chlorhexidine and E64- 5 μM E64-Trans-Epoxysuccinyl-L-Leucylamido-(4-guanidino) butane, which resulted in the following 9 groups (n = 10): N-W, N-CHX, N-E64, ACD-W, ACD-CHX, ACD-E64, ERO-W, ERO-CHX and ERO-E64. All specimens were restored with Adper Single Bond Universal (Etch-and-rinse mode)/Filtek Z250. Sticks (0.64 mm²) were obtained and subjected to microtensile test (μTBS) in a universal testing machine at 0.5 mm/min for 7-days, 6 and 18-month analyses. Failure modes were classified using optical microscopy (40X). Data were statistically analyzed by three-way ANOVA and Tukey tests (p < 0.05). All individual factors (p < 0.0001) and interaction between factors were statistically significant (substrate X pretreatment (p = 0.00093); substrate X time (p = 0.01035) and pretreatment X time (p = 0.0035). Caries-affected substrate was the most compromised one, disregarding the pretreatment. CHX was mostly affected compared with E64 up to 18 months, possibly due to its calcium-dependent mechanism.

Adapted Three-step Restorative Technique: Recovering Dental Substrate Compromised by Complex Erosive Wear in a Young Patient

Clinical Relevance

This article presents the dental restoration of a young female patient complaining of erosive dental wear using a three-step restorative technique, an alternative approach with some novel adjustments.

SUMMARY

For successful tooth wear treatment, determining the etiological systemic and local factors is the main priority before deciding on effective and long-term preventive and/or therapeutic restorative approaches. In addition to professional intervention, achieving optimal outcomes requires patients to control their diet and/or gastric issues, thus minimizing the wear process. However, continuous wear constitutes the most challenging scenario, mainly when it affects young patients’ dentitions. This article describes the dental restoration of posterior teeth with reestablishment of occlusal vertical dimension before treating the anterior teeth, while educating the patient and providing medical monitoring. The three-step restorative technique seems to be properly applicable in cases of significant dental compromise due mainly to erosive wear and is based on direct procedures, which can assure a reliable and feasible approach.

The impact of etching time and material on bond strength of self-adhesive resin cement to eroded enamel

The purpose of this study was to assess the effect of pre-etching time and material on shear bond strength (SBS) of self-adhesive resin cements to eroded and sound enamel. Eroded enamel specimens were assigned into 5 groups (n=20 each) based on enamel surface treatment as follow: Group N, eroded enamel (without surface pre-treatment); Group PH15, 35% H₃PO₄ etching for 15 s; Group PH30, 35% H₃PO₄ etching for 30 s; Group L30, 20% lactic acid etching for 30 s and Group L60, 20% lactic acid etching for 60 s.Composite blocks were fabricated and cemented to enamel surfaces with one of two self-adhesive cements. Notched-edge SBS was assessed. Bond strength of self-adhesive cement to eroded enamel surface significantly enhanced following application of 20% lactic acid for 30 s.

Four-Year Follow-up of Increased Vertical Dimension of Occlusion using Resin Composites

The objectives of this case report were to treat a severe loss of the vertical dimension of occlusion with indirect composite and to evaluate the durability of the restorations. A 55-year-old male complains from severe wear of teeth, leading to a change in normal occlusal plane. Two major treatment modalities were proposed to this patient; a conventional invasive crown placement with root canal treatments or a minimally invasive approach relying on adhesion. The latter was adopted and used to treat this patient. This paper describes a step-by-step approach of the different treatment phases starting with teeth preparation, then provisional prostheses, and ending with the placement of indirect anterior veneers and posterior onlays, all made with laboratory resin composite. Satisfactory clinical results were observed over the 4-year follow-up, with minimum failures limited to one partial fracture of inlay treated with direct adhesive repair.

Using Cross-Polarized Photography as a Guide for Selecting Resin Composite Shade

The restoration of single discolored maxillary anterior teeth is still a difficult task, as not only shape and surface characterization play an important role in the success of the treatment, but the propagation of light throughout the restorative material does as well. In some cases, small changes in morphology, color, and brightness will be noticeable. These factors are sometimes very tricky, and shade guides alone are difficult to use for color selection. This article proposes a protocol of employing cross-polarization imaging for improving the accuracy of the shade selection of resin composites. The step-by-step technique is presented for the restoration of a single discolored tooth.

Prevalence of dental erosion among people with gastroesophageal reflux disease in China

STATEMENT OF PROBLEM

Gastroesophageal reflux disease (GERD) is typically diagnosed based on symptoms of regurgitation and heartburn, although it may also manifest as asthma-like symptoms, laryngitis, or dental erosion.

PURPOSE

The purpose of this prospective, cross-sectional study was to assess the prevalence of dental erosion in people with GERD and to evaluate the association between GERD and dental erosion.

MATERIAL AND METHODS

The presence, severity, and pattern of dental erosion was assessed in 51 participants with GERD and 50 participants without GERD using the Smith and Knight tooth wear index. Medical, dietary, and dental histories were collected by questionnaire. Factors potentially related to dental erosion, including GERD, were evaluated by logistic regression.

RESULTS

Dental erosion was observed in 31 (60.8%) participants with GERD and 14 (28%) participants without GERD. Bivariate analysis revealed that participants with GERD were more likely to experience dental erosion (crude odds ratio [cOR]: 2.74; 95% CI: 1.19, 6.32) than participants without GERD. Multivariate analysis also revealed that participants with GERD had a higher risk of dental erosion (adjusted odds ratio [aOR]: 3.97; 95% CI: 1.45, 10.89). Consumption of grains and legumes, the most frequently consumed foods in China, did not correlate with dental erosion. However, carbonated beverage consumption was significantly associated with GERD and dental erosion (aOR: 3.34; 95% CI: 1.01, 11.04; P=.04).

CONCLUSIONS

GERD was positively correlated with dental erosion. Carbonated beverage consumption can increase the risk of both GERD and dental erosion.

Erosive cola-based drinks affect the bonding to enamel surface: an in vitro study

Objective

This study aimed to assess the impact of in vitro erosion provoked by different cola-based drinks (Coke types), associated or not with toothbrushing, to bonding to enamel.

Material and Methods

Fifty-six bovine enamel specimens were prepared and randomly assigned into seven groups (N=8): C- Control (neither eroded nor abraded), ERO-RC: 3x/1-minute immersion in Regular Coke (RC), ERO-LC: 3x/1-minute immersion in Light Coke (LC), ERO-ZC: 3x/1-minute immersion in Zero Coke (ZC) and three other eroded groups, subsequently abraded for 1-minute toothbrushing (EROAB-RC, EROAB-LC and EROAB-ZC, respectively). After challenges, they were stored overnight in artificial saliva for a total of 24 hours and restored with Adper Single Bond 2/Filtek Z350. Buildup coronal surfaces were cut in 1 mm² -specimens and subjected to a microtensile test. Data were statistically analyzed by two-way ANOVA/Bonferroni tests (α=0.05). Failure modes were assessed by optical microscopy (X40). The interface of the restorations were observed using Confocal Laser Scanning Microscopy (CLSM).

Results

All tested cola-based drinks significantly reduced the bond strength, which was also observed in the analyses of interfaces. Toothbrushing did not have any impact on the bond strength. CLSM showed that except for Zero Coke, all eroded specimens resulted in irregular hybrid layer formation.

Conclusions

All cola-based drinks reduced the bond strength. Different patterns of hybrid layers were obtained revealing their impact, except for ZC.

Gastroesophageal reflux is not associated with dental erosion in children

BACKGROUND & AIMS

Dental erosion is a complication of gastroesophageal reflux (GER) in adults; in children, it is not clear if GER has a role in dental pathologic conditions. Dietary intake, oral hygiene, high bacterial load, and decreased salivary flow might contribute independently to GER development or dental erosion, but their potential involvement in dental erosion from GER is not understood. We investigated the prevalence of dental erosion among children with and without GER symptoms, and whether salivary flow rate or bacterial load contribute to location-specific dental erosion.

METHODS

We performed a cross-sectional study of 59 children (ages, 9-17 y) with symptoms of GER and 20 asymptomatic children (controls); all completed a questionnaire on dietary exposure. Permanent teeth were examined for erosion into dentin, erosion locations, and affected surfaces. The dentist was not aware of GER status, and the gastroenterologist was not aware of dental status. Stimulated salivary flow was measured and salivary bacterial load was calculated for total bacteria, Streptococcus mutans, and Lactobacilli.

RESULTS

Controlling for age, dietary intake, and oral hygiene, there was no association between GER symptoms and dental erosion by tooth location or affected surface. Salivary flow did not correlate with GER symptoms or erosion. Erosion location and surface were independent of total bacteria and levels of Streptococcus mutans and Lactobacilli.

CONCLUSIONS

Location-specific dental erosion is not associated with GER, salivary flow, or bacterial load. Prospective studies are required to determine the pathogenesis of GER-associated dental erosion and the relationship between dental caries to GER and dental erosion.

Full-mouth rehabilitation of a patient with gastroesophageal reflux disease: a clinical report

Gastroesophageal reflux disease (GERD) is a chronic condition caused by stomach acid regurgitating into the esophagus or oral cavity, often causing heartburn. Tooth erosion and wear are common oral manifestations of GERD. This clinical report describes the full-mouth rehabilitation of a patient with over 30 years of GERD, causing wear of maxillary and mandibular anterior teeth, along with complications associated with past restorations. Full-mouth rehabilitation of natural teeth in conjunction with dental implants was selected as the treatment option. Ideal occlusal design and optimal esthetics, along with reinforcement of oral hygiene, ensure a favorable prognosis.

In Vitro Evaluation of Surface Roughness and Microhardness of Restorative Materials Submitted to Erosive Challenges

The effects of dental erosion caused by acidic solutions on the surface of restorative dental materials could be minimized by the application of a surface sealant.