Attempts to feed Amblyomma variegatum ticks on artificial membranes

Preliminary Study on Artificial versus Animal-Based Feeding Systems for Amblyomma Ticks (Acari: Ixodidae)

Hard ticks pose a threat to animal and human health. Active life stages need to feed on a vertebrate host in order to complete their life cycle. To study processes such as tick-pathogen interactions or drug efficacy and pharmacokinetics, it is necessary to maintain tick colonies under defined laboratory conditions, typically using laboratory animals. The aim of this study was to test a membrane-based artificial feeding system (AFS) applicable for Amblyomma ticks using Amblyomma tonelliae as a biological model. Adult ticks from a laboratory colony were fed in a membrane-based AFS. For comparison, other A. tonelliae adults were fed on calf and rabbit. The proportions of attached (AFS: 76%; calf/rabbit: 100%) and engorged females (AFS: 47.4%; calf/rabbit: 100%) in the AFS were significantly lower compared to animal-based feeding (p = 0.0265). The engorgement weight of in vitro fed ticks (x¯ = 658 mg; SD ± 259.80) did not significantly differ from that of ticks fed on animals (p = 0.3272, respectively 0.0947). The proportion of females that oviposited was 100% for all three feeding methods. However, the incubation period of eggs (x¯ = 54 days; SD ± 7) was longer in the AFS compared to conventional animal-based feeding (p = 0.0014); x¯ = 45 days; SD ± 2 in the rabbit and (p = 0.0144). x¯ = 48 days; SD ± 2 in the calf). Egg cluster hatching (x¯ = 41%; SD ± 44.82) was lower in the AFS than in the other feeding methods (rabbit: x¯ = 74%; SD ± 20; p = 0.0529; calf: x¯ = 81%; SD ± 22; p = 0.0256). Although the attachment, development, and the hatching of AFS ticks were below those from animal-based feeding, the method may be useful in future experiments. Nevertheless, further experiments with a higher number of tick specimens (including immature life stages) and different attractant stimuli are required to confirm the preliminary results of this study and to evaluate the applicability of AFS for Amblyomma ticks as an alternative to animal-based feeding methods.

Applications of artificial membrane feeding for ixodid ticks

Ticks are obligatory hematophagous ectoparasites that feed on a large variety of vertebrates. In the laboratory, animals (mainly mice and rabbits) are used to maintain tick colonies. However, the use of animals to rear ticks can be expensive and requires dedicated animal facilities. In addition, research institutions are committed to the principle of 3Rs (Replacement, Reduction and Refinement), which encourages the use of alternatives to animals when possible. The development of artificial membrane systems has provided an alternative to animals, at least for some tick species. Over the years, different modifications in artificial feeding systems have led to new applications, including acaricide testing, tick-pathogen interaction, and novel approaches to study tick physiology. Although artificial membrane feeding still has some limitations, the method can provide numerous advantages, including the standardization of acaricide treatments under controlled conditions, an alternative to animals for tick rearing, and reduction of cost associated with animals and animal housing facilities. In this review, we summarized the evolution of tick feeding membranes and their applications over time, explaining the modifications incorporated to study tick physiology, tick-pathogen interactions, and acaricide testing.

Artificial blood feeders for mosquito and ticks-Where from, where to?

Mosquito and tick feeding activity represent a key threat for humans, livestock, pets and wildlife worldwide. Rearing these vectors in laboratory conditions is extremely important to investigate basic facets of their biology, vector competence, new control strategies, as well as mechanisms of pesticide resistance. However, the use of animals or humans to provide blood for hematophagous arthropod feeding poses a strict limit to these researches, due to the accidental transmission of diseases, ethical problems concerning animal welfare, as well as expensive and time-consuming animal rearing procedures. The use of devices to artificially feed arthropod vectors can importantly leverage progresses in parasitology and entomology. The aim of this review is to summarize current knowledge about artificial feeding of mosquitoes and ticks, focusing on key concepts and case studies about the design and fabrication of blood feeding devices. From a technical standpoint, the literature analyzed here showed little standardization of materials used for fabricating membrane interfaces, as well as in the strategy used to heat the "biomimetic host". In addition, a lack of uniform methods to design an architecture merging complex and realistic cues with an easy-to-assemble approach have been found. Some commercial products are available, but they are quite expensive, thus hard to reach for many laboratories, especially in developing countries. An important challenge for future research is represented by the introduction of automation and bioinspired engineered solutions in these devices, improving the effectiveness of blood-feeding systems by increasing their host-mimicking features. Automation can reduce labor costs and provide interesting solutions - in line with the 3R principle "reduce, replace and refine" - aimed to minimize the employ of experimental animals in research.

Itching for change: Embracing modern flea and tick product development

The development and regulatory approval of ectoparasiticides, including flea and tick control products, involves decades-old methods and the use of large numbers of animals to evaluate toxicity and efficacy. Animals also are used to rear (breed and feed) fleas and ticks for later use in testing. Non-animal methods for regulatory-required testing and rearing currently exist and, with further development, others could soon become available. Here we provide an overview of the state-of-the-science of non-animal methods for rearing and regulatory-required efficacy testing of flea and tick control products. Several remaining challenges as well as recommendations on the steps needed to replace animals in the evaluation of these products are discussed.

Glass capillary tube feeding: a method for infecting nymphal Ixodes scapularis (Acari: Ixodidae) with the lyme disease spirochete Borrelia burgdorferi

We evaluated an artificial capillary feeding method to infect nymphal Ixodes scapularis (Say) ticks with Borrelia burgdoeferi, the causative agent of Lyme disease. Thirty to 70% of the nymphs were infected after feeding for 2.5 h from glass capillary tubes filled with a solution of spirochetes. Capillary infection was stable and persisted in the nymphs for at least 10 d after feeding. Capillary feeding also maintained natural vector competence patterns because I. scapularis ticks acquired infection unlike Dermacentor variablis (Say), which did not become infected. Capillary infected I. scapularis nymphs were capable of transmitting the infection to naive mice although not as efficiently as naturally infected nymphs. The capillary infection method is convenient and is a better alternative to syringe inoculation as a means of infecting animals with B. burgdorferi.