Immediate versus delayed temporization at posterior single implant sites: A randomized controlled trial

Diabetes mellitus exacerbates inflammation in a murine model of ligature-induced peri-implantitis: A histological and microtomographic study

AIM

To investigate the influence of diabetes mellitus (DM) in a murine model of peri-implantitis (PI).

MATERIALS AND METHODS

Twenty-seven 4-week-old C57BL/6J male mice had their first and second maxillary left molars extracted. Eight weeks later, one machined implant was placed in each mouse. Four weeks after osseointegration, the mice were divided into three groups: (a) control (C), (b) PI and (c) DM + PI. DM was induced by streptozotocin (STZ) administration. After DM induction, PI was induced using ligatures for 2 weeks. The hemimaxillae were collected for micro-CT and histological analyses. The primary outcomes consisted of linear (mm) and volumetric (mm3) bone loss. Secondary outcomes were based on histological analysis and included inflammatory infiltrate, osteoclastic activity, matrix organization, composition and remodelling. Data are presented as means ± SEM. Statistical analyses were performed using one-way ANOVA, followed by Tukey's test.

RESULTS

Gingival tissue oedema was detected in the PI and DM + PI groups. Micro-CT showed significantly increased linear and volumetric bone loss in the DM + PI group compared to the C and PI groups. H&E staining showed greater inflammatory response and bone resorption in the PI and DM + PI groups than in the C group. The DM + PI group had significantly higher osteoclast numbers than the C and PI groups. Picrosirius red stained less for types I and III collagen in the PI and DM + PI groups than in the C group. There was a significant increase in monocyte/macrophage (CD-11b) counts and matrix metalloproteinases (MMP-2 and MMP-8) marker levels and a significant decrease in the matrix metalloproteinases inhibition marker (TIMP-2) levels in the DM + PI group compared to the C and PI groups.

CONCLUSIONS

DM exacerbates PI-induced soft-tissue inflammation, matrix degradation and bone loss.

Hypertension and Dental Implants: A Systematic Review and Meta-Analysis

PURPOSE

The aim of the present systematic review was to investigate the influence of hypertension on the dental implant failure rate.

METHODS

An electronic search was undertaken in four databases, plus a manual search of journals. The I2 statistic was used to check heterogeneity and the inverse-variance method was used for the meta-analysis. The estimate of relative effect for dichotomous outcome was expressed as an odds ratio (OR).

RESULTS

The review included 24 publications. There were 4874 implants (257 failures) placed in hypertensive patients and 16,192 implants (809 failures) placed in normotensive patients. A pairwise meta-analysis showed that implants in hypertensive patients did not have a higher risk of failure than implants placed in normotensive patients (OR 1.100, p = 0.671). The log OR of implant failure between hypertensive and normotensive patients did not significantly change with the follow-up time (p = 0.824).

CONCLUSIONS

This review suggests that implants in hypertensive patients do not present higher odds of failure in comparison to normotensive patients. However, further research on this topic, with the use of more rigorous criteria to diagnose patients as being hypertensive, as well as clearer information about the pharmacological management of the condition in the patients, is recommended.

Application of Immediate Implant Placement Techniques in Peri-implantitis Modeling

OBJECTIVES

To explore the use of immediate implant placement technique in peri-implantitis modeling, shorten the modeling period, and obtain similar effects.

MATERIALS AND METHODS

Eighty rats were divided into 4 groups: immediate placement (IP), delayed placement (DP), IP-ligation (IP-L) and DP-ligation (DP-L). In the DP and DP-L groups, implants were placed 4 weeks after tooth extraction. In the IP and IP-L groups, implants were placed immediately. Four weeks later, the implants were ligated to induce peri-implantitis in the DP-L and IP-L groups.

RESULTS

Nine implants were lost (3 in the IP-L and 2 each in the IP, DP, and DP-L group). The bone level decreased after ligation, and the buccal and lingual bone levels were lower in IP-L versus DP-L. The implant pullout strength was decreased after ligation. Micro-CT showed bone parameters were decreased after ligation, and the percent bone volume was higher in IP versus DP. Histology showed that the percent of CD4 + cells and IL-17 + cells was increased after ligation and higher in IP-L versus DP-L.

CONCLUSIONS

We successfully introduced immediate implant placement into the modeling of peri-implantitis and observed similar bone resorption and more soft tissue inflammation in a shorter time.

Success rate of immediately loaded implants in the posterior zone

Dental implants are considered an ideal treatment for a missing single tooth. Immediate loading of implants can hasten the procedure, providing comfort to the patients. Recently, immediate loading of implants has gained much importance as it helps hasten the procedure and provides more comfort to patients. A previous systematic review published 5 years ago compared the success rates between immediate and conventional loading. There are several factors that influence the success rate of implants that were not discussed in detail in the previous review. Hence, the present systematic review is done to report differences in the outcomes from single implant restorations of missing teeth in the posterior region in patients who were subjected to immediate loading and conventional loading. A follow up for 1 year was done. Electronic databases of Medline, Scopus, and Web of Science were searched for publications in the English Language during May 2021. The search results yielded 306 articles, out of which 225 were excluded based on title and abstract screening. Screening of the remaining 81 full text articles yielded 14 original research articles that satisfied the predefined inclusion criteria. Meta analysis was not possible due to the heterogeneity of the data. The overall success rate of the immediate loading of a single implant is 94.31%. Implants in the maxillary region had a higher survival rate than those in the mandibular region. The age range between 18 and 80 years showed good prognosis and outcomes in older individuals. Good oral hygiene was emphasized for all patients to prevent any secondary conditions or delays in healing.

Relevant factors of posterior mandible lingual plate perforation during immediate implant placement: a virtual implant placement study using CBCT

BACKGROUND

To explore the influence of cross-sectional type and morphological parameters at the mandibular molar sites on lingual plate perforation (LPP) during the immediate implant placement (IIP).

METHODS

181 implants were virtually placed in the mandibular molar sites on the cone beam computed tomography (CBCT). Each cross-section of the implantation site was divided into the Undercut (U)/Parallel (P)/Convex (C) types. Morphologically relevant parameters were measured on the cross-sections, including width of the upper end (Wb), width of the lower end (Wc), vertical height (V), angle between the natural crown axis and the alveolar bone axis (∠β), LC depth (LCD), LC height, and angle between the horizontal line and the line connecting the most prominent point and the most concave point of lingual plate (∠α). Besides, the distance from the end of the virtual implant and the lingual bone plate of the cross-section (D_IL) was calculated. Relationships between all the morphologically relevant parameters and the D_IL were further analyzed.

RESULTS

A total of 77 (42.5%) cross-sections were classified as U-type, which was the most common one, accounting for 63% of the second molar regions. All LPP cases and most of the nearly LPP (87.9%) cases occurred at the U-type cross-sections, and the relationship between the D_IL and the morphological parameters can be expressed by a multivariate linear equation.

CONCLUSIONS

The occurrence rate of U-type cross-sections in the second molar region was very high, and the risk of LPP should be considered during IIP. Except for the U-type, significant large LCD, small Wc, and large ∠β were the important relevant factors. CBCT and multivariate linear equations could help to assess the LPP risk and provide a reference for implant placement design pre-surgery.

Clinical and Laboratory Outcomes of Angled Screw Channel Implant Prostheses: A Systematic Review

The purpose of this systematic review was to evaluate the clinical and laboratory outcomes of angled screw channel (ASC) restorations and to summarize the influencing factors. An electronic search of the English language literature was performed in four databases and enriched by manual searches. Retrieved studies were screened against the predefined exclusion and inclusion criteria. Eight clinical and seven laboratory studies were eligible for the analysis. The risk of bias for included observational studies was performed using the Newcastle–Ottawa quality assessment scale. Laboratory studies quality assessment method was adapted from previous published systematic reviews. Two clinical studies focused on technical outcomes and the rest reported the biological outcomes of the ASC restorations. Out of the seven laboratory studies, two studies investigated the fracture resistance of ASC restorations, four studies evaluated the reverse torque value of the nonaxially tightened screws, and one study evaluated both variables. The present review revealed that while the performance of ASC restorations is promising in short-term clinical studies, the evidence of their long-term reliability is still lacking. The laboratory studies indicated comparable fracture resistance results of the ASC restorations with the straight screw channel restorations. In addition, factors, such as initial torque value, configuration of the screw driver, screw design, abutment system, and the angulation of screw channel, were shown to influence the screw resistance to loosening.

A systematic review and meta-analysis evaluating the survival, the failure, and the complication rates of veneered and monolithic all-ceramic implant-supported single crowns

Objective

To assess the survival, failure, and complication rates of veneered and monolithic all‐ceramic implant‐supported single crowns (SCs).

Methods

Literature search was conducted in Medline (PubMed), Embase, and Cochrane Central Register of Controlled Trials until September 2020 for randomized, prospective, and retrospective clinical trials with follow‐up time of at least 1 year, evaluating the outcome of veneered and/or monolithic all‐ceramic SCs supported by titanium dental implants. Survival and complication rates were analyzed using robust Poisson's regression models.

Results

Forty‐nine RCTs and prospective studies reporting on 57 material cohorts were included. Meta‐analysis of the included studies indicated an estimated 3‐year survival rate of veneered‐reinforced glass‐ceramic implant‐supported SCs of 97.6% (95% CI: 87.0%–99.6%). The estimated 3‐year survival rates were 97.0% (95% CI: 94.0%–98.5%) for monolithic‐reinforced glass‐ceramic implant SCs, 96.9% (95% CI: 93.4%–98.6%) for veneered densely sintered alumina SCs, 96.3% (95% CI: 93.9%–97.7%) for veneered zirconia SCs, 96.1% (95% CI: 93.4%–97.8%) for monolithic zirconia SCs and only 36.3% (95% CI: 0.04%–87.7%) for resin‐matrix‐ceramic (RMC) SCs. With the exception of RMC SCs (p < 0.0001), the differences in survival rates between the materials did not reach statistical significance. Veneered SCs showed significantly (p = 0.017) higher annual ceramic chipping rates (1.65%) compared with monolithic SCs (0.39%). The location of the SCs, anterior vs. posterior, did not influence survival and chipping rates.

Conclusions

With the exception of RMC SCs, veneered and monolithic implant‐supported ceramic SCs showed favorable short‐term survival and complication rates. Significantly higher rates for ceramic chipping, however, were reported for veneered compared with monolithic ceramic SCs.

Do the location and dimensions of the mental foramen differ among individuals of different facial types and skeletal classes? A CBCT study

STATEMENT OF PROBLEM

Knowledge about the location and dimensions of the mental foramen is important for surgical planning and implant placement in the posterior mandibular region.

PURPOSE

The purpose of this clinical study was to assess the location and dimensions of the mental foramen in individuals of different facial type, skeletal class, and sex by means of cone beam computed tomography (CBCT) images.

MATERIAL AND METHODS

CBCT images of 142 individuals (72 women and 70 men) were classified according to the facial type (dolichocephalic, mesocephalic, or brachycephalic) and skeletal class (I, II, or III). The vertical and horizontal locations of each mental foramen were evaluated on panoramic reconstructions, and the greatest height and width of the mental foramen were determined on multiplanar reconstructions. Also, the distances from the mental foramen to the alveolar crest and to the inferior cortex of the mandible were obtained. The data were compared by using the Kruskal-Wallis test and multiway analysis of variance (α=.05).

RESULTS

The facial type, skeletal class, and sex did not influence the vertical (P=1.00) or the horizontal (P>.15) location of the mental foramen. The most frequent location of the mental foramen was between the first and second premolars and below their apices. The dimensions of the mental foramen were not influenced by the studied factors in men (P>.07); conversely, the mental foramen dimensions were influenced for women (P<.03).

CONCLUSIONS

The most frequent location of the mental foramen was between the first and second premolars and below their apices. An influence of the facial type and skeletal class was observed on the dimensions of the mental foramen in women.