Improvement of pulmonary absorptions of poorly absorbable drugs using Gelucire 44/14 as an absorption enhancer

Enhanced alveo pulmonary deposition of nebulized ciclesonide for attenuating airways inflammations: a strategy to overcome metered dose inhaler drawbacks

Ciclesonide (CIC), an inhaled corticosteroid for bronchial asthma is currently available as metered dose inhaler (CIC–MDI) which possesses a major challenge in the management of the elderly, critically ill patients and children. In this work, nebulized CIC nano-structure lipid particles (CIC-NLPs) were prepared and evaluated for their deep pulmonary delivery and cytotoxicity to provide additional clinical benefits to patients in controlled manner and lower dose. The bio-efficacy following nebulization in ovalbumin (OVA) induced asthma Balb/c mice compared to commercial (CIC–MDI) was also assessed. The developed NLPs of 222.6 nm successfully entrapped CIC (entrapment efficiency 93.3%) and exhibited favorable aerosolization efficiency (mass median aerodynamic diameter (MMAD) 2.03 μm and fine particle fraction (FPF) of 84.51%) at lower impactor stages indicating deep lung deposition without imparting any cytotoxic effect up to a concentration of 100 μg/ml. The nebulization of 40 µg dose of the developed CIC-NLPs revealed significant therapeutic impact in the mitigation of the allergic airways inflammations when compared to 80 µg dose of the commercial CIC–MDI inhaler (Alvesco^®). Superior anti-inflammatory and antioxidative stress effects characterized by significant decrease (p< .0001) in inflammatory cytokines IL-4 and 13, serum IgE levels, malondialdehyde (MDA), nitric oxide (NO), TNF-α, and activated nuclear factor-κB (NF-κB) activity were obvious with concomitant increase in superoxide dismutase (SOD) activity. Histological examination with inhibition of inflammatory cell infiltration in the respiratory tract was correlated well with observed biochemical improvement.

Evaluation and Comparison of Solid Lipid Nanoparticles (SLNs) and Nanostructured Lipid Carriers (NLCs) as Vectors to Develop Hydrochlorothiazide Effective and Safe Pediatric Oral Liquid Formulations

The aim of this study was the optimization of solid lipid nanoparticles (SLN) and nanostructured lipid carriers (NLC) in terms of physicochemical and biopharmaceutical properties, to develop effective and stable aqueous liquid formulations of hydrochlorothiazide, suitable for paediatric therapy, overcoming its low-solubility and poor-stability problems. Based on solubility studies, Precirol® ATO5 and Transcutol® HP were used as solid and liquid lipids, respectively. The effect of different surfactants, also in different combinations and at different amounts, on particle size, homogeneity and surface-charge of nanoparticles was carefully investigated. The best formulations were selected for drug loading, and evaluated also for entrapment efficiency and release behaviour. For both SLN and NLC series, the use of Gelucire® 44/14 as surfactant rather than PluronicF68 or Tween® 80 yielded a marked particle size reduction (95-75 nm compared to around 600-400 nm), and an improvement in entrapment efficiency and drug release rate. NLC showed a better performance than SLN, reaching about 90% entrapped drug (vs. 80%) and more than 90% drug released after 300 min (vs. about 65%). All selected formulations showed good physical stability during 6-month storage at 4 °C, but a higher loss of encapsulated drug was found for SLNs (15%) than for NLCs (<5%). Moreover, all selected formulations revealed the absence of any cytotoxic effect, as assessed by a cell-viability test on Caco-2 cells and are able to pass the intestinal epithelium as suggested by Caco-2 uptake experiments.

Drug-Lipid-Surfactant Miscibility for the Development of Solid Lipid Nanoparticles

This research aimed to study the correlation between miscibility of flutamide (FLT), lipids and surfactant on the particle size of solid lipid nanoparticles (SLNs). Physical mixtures (PMs) of lipids-glyceryl monooleate (GMO), Precirol® (glyceryl palmitostearate, PRE), glyceryl monostearate (GMS), and Compritol® (glyceryl dibehenate, COM) were prepared with surfactant-Gelucire® (stearoyl polyoxyl-32 glycerides, GEL) 50/13 and 44/14. PMs were prepared in 5:2 w/w ratio (lipid:surfactant) and 2:1 w/w (Flutamide (FLT):lipids/GEL 50/13) by co-melting. Miscibility of PMs was investigated using modulated differential scanning calorimetry (MDSC). SLNs with and without drug were prepared using GEL 50/13 by the ultra-sonication method and particle size analysis was conducted. PMs of GMO, GMS, and PRE with both surfactants showed a decrease in the melting temperature, no change in melting and crystallization peak was observed with COM-GELs, indicating immiscibility. Similarly, MDSC data suggests good miscibility of FLT in GMO, GMS, and GEL 50/13 but not in PRE and COM. The particle size of drug-loaded SLNs prepared from GMO and GMS with GEL 50/13 was found to be 70.2 ± 5.4 and 92.6 ± 8.5 compared to > 200-nm particles obtained from PRE and COM. On lyophilization, an increase in particles size was observed with COM only. The particle size of SLNs with PRE and COM was prominently increased during stability studies indicating SLNs prepared with GMO and GMS are more stable due to miscibility and ability to reduce the crystallinity of FLT. The results established a good correlation between drug, lipids, and surfactants miscibility to the obtained particle size of SLNs before and after lyophilization. Graphical Abstract ᅟ.