Biomechanical Comparison of 2 Veterinary Locking Plates to Monocortical Screw/Polymethylmethacrylate Fixation in Canine Cadaveric Cervical Vertebral Column

Thoracolumbar Spinal Stabilization with Three Dimensional-Printed Drill Guides and Pre-Contoured Polyaxial Bone Plates

OBJECTIVE

 The aim of this study was to report new preoperative and intraoperative techniques performed for canine thoracic or lumbar spine kyphosis stabilization using three-dimensional-printed patient-specific drill guides, polyaxial titanium bone plates and drill stops, and to determine the accuracy of screw placement using these techniques.

STUDY DESIGN

 Retrospective study, five client-owned dogs.

RESULTS

 Three-dimensional-printed patient-specific drill guides and drill stops allowed safe drilling and screw placement in all of the cases, with (i) 84% of the screws graded as I (ideal placement) and 16% as IIa, IIIa or IIIb according to the modified Zdichavsky classification (partial penetration of medial pedicle wall, partial penetration of lateral pedicle wall and full penetration of lateral pedicle wall respectively), (ii) mean mediolateral deviation of ± 4.06 degrees (standard deviation: 8.21 degrees) compared to planned trajectories and (iii) variation in screw depth of ± 2.29mm (standard deviation: 3.07mm) compared to planned depth.

CONCLUSION

 We believe that the techniques presented here for thoracic spinal stabilization in dogs show promise; they allowed safe placement of screws along planned trajectories and depth; they also removed the need to use polymethylmethacrylate, while the use of titanium offers the possibility to repeat magnetic resonance imaging in these cases with chronic spinal conditions.

Comparison of Cervical Stabilization with Transpedicular Pins and Polymethylmethacrylate versus Transvertebral Body Polyaxial Screws with or without an Interbody Distractor in Dogs

OBJECTIVE

 The main aim of this study was to compare the biomechanical properties of caudal cervical vertebral stabilization using bicortical transpedicular pins with polymethylmethacrylate (PMMA) versus transvertebral body polyaxial screws and connecting rods with or without an interbody distractor.

STUDY DESIGN

 Ten canine cervical vertebral columns (C2-T3) were used. Four models (intact, transvertebral body polyaxial screw with interbody distractor [polyaxial + distractor], transvertebral body polyaxial screw without interbody distractor [polyaxial - distractor] and bicortical transpedicular pins/polymethylmethacrylate [pin-PMMA]) were applied to C6-7 sequentially on the same specimens. Angular range of motion (AROM) in the form of flexion and extension was measured at C4-5, C5-6 and C6-7 in all groups.

RESULTS

 Treated vertebral specimens had significantly less AROM than unaltered specimens. There was no significant difference in AROM between the experimental groups at C6 and C7. Angular range of motion ratio in flexion-extension was 80.8, 72.7 and 78.3% for polyaxial + distractor, polyaxial - distractor and pin-PMMA groups, respectively, which were less than the intact group. There was no significant increase in the range of motion of the adjacent vertebrae after stabilization.

CONCLUSION

 Stabilization obtained with transvertebral body polyaxial screws was comparable to that from the well-established bicortical pins/PMMA construct. Association of an intervertebral distractor did not change AROM of the polyaxial screw constructs.

Long-Term Follow-Up of Dogs and Cats after Stabilization of Thoracolumbar Instability Using 2-0 UniLock Implants

Traumatic vertebral fracture or luxation often results in spinal instability requiring surgical stabilization. This study describes the long-term outcome of spinal stabilization using a unilateral 5-hole 2-0 UniLock implant in eight dogs and two cats with trauma-induced thoracolumbar vertebral luxation/subluxation and presumed instability, as assessed by a combination of preoperative radiographs and MRI using a 3-compartment method. The UniLock plate was secured with four monocortical locking screws in adjacent vertebral bodies. Additional pins and facet screws were used in several patients. Postoperative radiographs and MRI studies showed restoration of the main spinal axis in all patients and satisfactory implantation of the screws in the vertebral bodies, with no intrusion in the vertebral canal or in the adjacent intervertebral disc spaces. Neurological status improved in nine patients six weeks postoperatively. Partial implant failure was detected in three patients with no long-term consequences. After 12 months, seven patients reached full recovery with no neurological deficit, two patients were euthanized (including one owing to an unrelated condition), and one remained paraparetic. The results of this study demonstrate that using a 2-0 UniLock implant to stabilize the thoracolumbar spine results in satisfactory long-term recovery in most dogs and cats with traumatic spinal luxation/subluxation and presumed instability. Complications may occur but do not require revision surgery and do not affect clinical outcomes.

Surgical intervention for vertebral osteomyelitis in a calf

OBJECTIVE

To report the surgical treatment and outcome of a non-ambulatory calf with cervical vertebral ostoeomyelitis.

STUDY DESIGN

Clinical report.

SAMPLE POPULATION

One 3.5-month-old female mixed-breed calf with tetraparesis of 3 months duration.

METHODS

After computed tomography-guided bone biopsy, a bacterial osteolytic lesion within the body of the fourth cervical vertebrae (C4) and resultant pathologic compression fracture clinically resulting in full tetraparesis was diagnosed in the calf. Culture results from the lesion within C4 confirmed a diagnosis of Trueperella pyogenes.

RESULTS

Poor response to medical management justified surgical debridment of the lesion in C4 and subsequent stabilization of the cervical vertebral column. A three-part procedure was performed including (1) debridement of the C4, (2) bilateral ventral vertebral stabilization from C3 to C5, and (3) placement of ampicillin-impregnated plaster of Paris beads within the body of C4. With postoperative physical rehabilitation, the calf regained full ambulatory function. At 1-month follow-up, the calf remained ambulatory with mild proprioceptive ataxia and no evidence of implant failure. At annual recheck, the calf had gained 208 kg and remained fully ambulatory with no residual neurologic deficits.

CONCLUSION

Surgical intervention and use of antibiotic-impregnated implants offered a viable alternative to long-term medical management of vertebral osteomyelitis in the calf reported here.

CLINICAL SIGNIFICANCE

This case identifies surgical intervention as a potential means for improving outcomes in a historically fatal condition of production animals.

Retrospective evaluation of perioperative and short term clinical outcomes in appendicular long bone skeleton fractures repaired via the string of pearls (SOP) locking plate system

BACKGROUND

Internal plate fixation and, more recently, locking plate fixation are commonly used in the repair of fractures in small animal surgery. This retrospective study reviewed the use of the String of Pearls locking plate system in the fixation/repair of appendicular long bone skeleton fractures in 31 small animal veterinary patients (33 fractures).

RESULTS

Major complications necessitating revision surgery occurred in 7/33 (21%), with implant failure as the inciting cause in all cases. Variables corresponding to an unsuccessful outcome were evaluated, and a correlation was found with plates placed in a bridging manner (placed without rigid anatomic reconstruction, p = 0.02) and length of follow-up (p = 0.01).

CONCLUSIONS

The SOP plating system can be used in the repair of appendicular longbone skeletal fractures, however, the authors propose that adjunct fixation, such as intramedullary pin, double plating, or external coaptation would likely improve results and should be considered imperative in cases in which anatomic reconstruction is either not desirable or achievable.

Optimal safe implantation corridors in feline cervical vertebrae (C2-T1): CT study in 16 domestic shorthair cats

OBJECTIVES

The objective of this study was to define safe corridors for the optimal placement of bicortical implants in the feline cervical spine (C2-T1) using CT.

METHODS

CT images of feline cervical spines (n = 16) were reviewed retrospectively. Multiplanar reconstructions were used to define the optimal safe corridors. Safe corridors were defined by their angle of insertion, width and length. The insertion point within the vertebral body was also described. Vertebral measurements were compared between vertebrae using multilevel linear regression, and left and right measurements within vertebrae were compared with the paired samples Wilcoxon signed-rank test. A P value <0.05 was considered significant for all analyses.

RESULTS

The safe corridor insertion points were located within the caudal third of the vertebral body in C2 (mean cranial vertebral ratio 0.73) and in the cranial third of the vertebral bodies from C3-T1 (mean cranial vertebral ratios 0.34-0.38). Mean safe corridor widths ranged from 1.04 mm in C2 to 2.30 mm in C7 and T1. The mean right and left optimal angles of implantation were, respectively, 21.79° and 21.49° for C2, 45.26° and 46.19° for C3, 51.48° and 51.04° for C4, 53.52° and 54.30° for C5, 56.36° and 56.65° for C6, 63.40° and 64.92° for C7, and 53.90° and 52.90° for T1. There were statistically significant differences between vertebrae in almost every measurement.

CONCLUSIONS AND RELEVANCE

Cervical vertebral safe corridors in cats are narrow and differ to those reported in dogs. Safe corridors are located in the caudal third of C2 and cranial third of the C3-T1 vertebral bodies. Current recommendations for implant sizes should be reviewed, as 1.5-2 mm implants would be oversized for bicortical implantation in most of the feline cervical vertebrae.