Use of screw locking elements improves radiological and biomechanical results of femoral osteotomies

BACKGROUND

Dynamic compression plate (DCP) constructs provide inadequate fixation in cases of poor bone quality and early weight-bearing. Screw locking elements (SLE) are flat locking nuts placed at the end of the screw to prevent screw stripping from the bone, improving fixation stability. The purpose of this work was to compare biomechanical and radiological evaluations of femoral ovine osteotomies fixed using DCP constructs with and without SLE.

METHOD

A dyaphyseal femoral osteotomy was performed in sixteen adult sheep and fixed with a DCP and cortical screws. Half of the animals were operated on with a SLE on each side of the osteotomy and the rest without the addition of SLE. Four animals of each group were euthanized after 8 weeks, and the remaining after 16 weeks. Both femora of each animal were radiographed and mechanically tested in torsion.

RESULTS

Radiologically femoral malalignment or screw loosening was observed in six out of the eight animals operated on without SLE. In contrast, all animals subjected to the operation with SLE showed complete radiological consolidation of the osteotomy. Seven of these eight animals showed normal femoral alignment and no osteosynthesis failure. Stiffness of the bones fixed with SLE was among 145% and 177% the value of their contralateral non-operated femurs (all animals of this group showed greater stiffness on the operated bone than its contralateral non-operated femur). However, stiffness of the bones operated on without SLE was among 58% and 87% the value of the stiffness of their contralateral non-operated bone (all animals of this group showed greater stiffness on the non-operated bone than the osteotomized ones).

CONCLUSIONS

Use of SLE avoided loosening of the system and stimulated stronger osteotomy consolidation. Clinical application of this improved system may thus be a feasible and cost-effective alternative to other more rigid and expensive bone fixation techniques.

Experimental analysis of the minimally invasive plate osteosynthesis technique applied with non-locking screws and screw locking elements

Minimally invasive plate osteosynthesis (MIPO) is an effective surgical technique in the repair of humeral and tibial shaft fractures. There is some controversy as to the minimum number of screws required to ensure correct stability to promote healing, especially when dealing with low quality bones. This work compared different systems assembled on synthetic models simulating a comminuted fracture. Group 1 comprised a locking compression plate with four non-locking screws placed at the holes furthest from the fracture. Group 2 differed from group 1 only in the additional use of two screw locking elements (SLE). Group 3 had four rather than two SLE and, finally, Group 4 used 4 locking screws. The compression and torsion tests with static and cyclic loads showed that, in MIPO, two locking screws or two non-locking screws with SLE could be used per segment without any significant loss in stiffness after 1000 cycles, with system stability guaranteed in both cases. However, lower strength and significant loss of stiffness were observed when non-locking screws were used alone.